Question

(4.2) A water droplet of volume V is sandwiched between two glass plates separated by a distance h (see Fig. 4.16). Calculate the capillary force acting on the plates. Assume that the radius of the wet re- gion r is much larger than h and that the contact angle of the water on the glass is ?. Fig. 4.16

0 0
Add a comment Improve this question Transcribed image text
Know the answer?
Add Answer to:
(4.2) A water droplet of volume V is sandwiched between two glass plates separated by a...
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for? Ask your own homework help question. Our experts will answer your question WITHIN MINUTES for Free.
Similar Homework Help Questions
  • Two circular metal plates with radii of 10.0 cm are separated by a distance of 0.200...

    Two circular metal plates with radii of 10.0 cm are separated by a distance of 0.200 mm. They are connected to the terminals of a car battery (treat as 12.0 V). (d) You now return the plates to their original separation and allow a long time to go by so that the capacitor is fully charged. You then disconnect the battery from them. Again, using insulated plates, you pull the plates apart until they are separated by 0.400 mm. Now...

  • Consider steady laminar viscous fluid between two parallel plates with distance h separated from each other....

    Consider steady laminar viscous fluid between two parallel plates with distance h separated from each other. A pressure gradient dp/dx drives the flow. By considering forces acting on a small volume between the parallel plates, obtain the velocity profile, the volumetric flow rate, and the average velocity in terms of centerline velocity Umax Umax

  • 4. Consider fully developed Couette flow-flow between two infinite parallel plates separated by distance h, with...

    4. Consider fully developed Couette flow-flow between two infinite parallel plates separated by distance h, with the top plate moving and the bottom plate stationary. The flow is steady, incompressible, and two-dimensional in the xy- plane. Use the method of repeating variables to generate a dimensionless relationship for the x component of fluid velocity u as a function of fluid viscosity , top plate speed V, distance h, fluid density p, and distance y Show all your work. Hint: u...

  • please do two pargraph about this pre lab and lab include Title,purpose ,chemical eqution if their...

    please do two pargraph about this pre lab and lab include Title,purpose ,chemical eqution if their any ،Procedure ,Hazards(hazard Identification,physical and chemical properties),Experimental Phase, Data &Observations,Data&Observations cont (melting point and meling point). and Calcuations Spinach Laboratory Procedure PROCEDURES Isolation of pigment from leaves: 1. Wash the spinach leaves. Weigh 1.0 g-2.0 g of dry spinach leaves. Remove any stems and veins from the leaves before you weigh. 2. Combine 1.0 g of anhydrous magnesium sulfate with 0.5 g of sand...

  • Please answer all the blanks (volume if H2 and everything in analysis). TIA! Data 5 1...

    Please answer all the blanks (volume if H2 and everything in analysis). TIA! Data 5 1 oong 0.00 10.5ml 2 o.olag 0.00 11.0 Trial 3 o.org 0.00 12.00 o Daag o.albg 0.00 10.0 ml 11.5ml Mass of Mg (g) Initial volume of Syringe (mL) Final volume of Syringe (mL) Volume of H (mL) Barometric pressure (torr) Ambient temperature (°C) Vapor pressure of H2O (torr) 779.314har 23. Oi 21.0 forr TA.314tar 23.0c 179.3 14ton 23.0¢ 779.314 ton 23.0c 779.31472 23.0c 21.0...

  • Consider a cylindrical capacitor like that shown in Fig. 24.6. Let d = rb − ra...

    Consider a cylindrical capacitor like that shown in Fig. 24.6. Let d = rb − ra be the spacing between the inner and outer conductors. (a) Let the radii of the two conductors be only slightly different, so that d << ra. Show that the result derived in Example 24.4 (Section 24.1) for the capacitance of a cylindrical capacitor then reduces to Eq. (24.2), the equation for the capacitance of a parallel-plate capacitor, with A being the surface area of...

  • What are the instruments that have been utilized for the review article discussions? ` 1. Introduction...

    What are the instruments that have been utilized for the review article discussions? ` 1. Introduction In recent years, nanoclays have been the object of particular interest for many scientists and researchers in chemistry, physics, engineering and biology due to their excellent properties as well as their sustain- ability [1-3]. For instance, they represent the starting point to the de velopment of smart materials for drug delivery (4-9), food packaging [10-12), environmental remediation and wastewater treatment [13], cultural heritage [14–17and...

ADVERTISEMENT
Free Homework Help App
Download From Google Play
Scan Your Homework
to Get Instant Free Answers
Need Online Homework Help?
Ask a Question
Get Answers For Free
Most questions answered within 3 hours.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT