Question

Design of a Solar Thermal Power Plant The scheme of the solar thermal power plant is depicted in Figure 1. It features a RankUseful equations: Omet - = m( How- for adiabatic pump and turbine: del = 0 for ideal pump: AN= v 4p for solar receiver: W=0 éSiedeinie: 0 Flussaken Dampt Nasedamot Talinis 1 Figure 2: Clausius-Rankine T-s and h-s cycle diagrams Questions 1) Indicate

0 0
Add a comment Improve this question Transcribed image text
Answer #1

* Wnel= 12 MW Temdm Ouliel > 320 K Oul pet precs = Xl 170bor To=325H Solor ouput Temp: 8504. 78.5% Sire: T 250K P170 bay T3-hg = 1132.5 KTIkg. Ctale: 3-4: PA= 17obor To > 325 K. Wpomp = -vdp - Vipeckc velune of X CPa-Pe) waler O. 001500 x C170- |12.

Add a comment
Know the answer?
Add Answer to:
Design of a Solar Thermal Power Plant The scheme of the solar thermal power plant is...
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for? Ask your own homework help question. Our experts will answer your question WITHIN MINUTES for Free.
Similar Homework Help Questions
  • Consider a steam power plant which operates on the simple ideal Rankine cycle (shown in the...

    Consider a steam power plant which operates on the simple ideal Rankine cycle (shown in the next page), where the boiler pressure is 3 MPa and the condenser saturation temperature is 50°C. The temperature at the exit of the boiler is 500°C. Water leaves the condenser as a saturated liquid. The mass flow rate through each component is 15 kg/s. Calculate: 1. The power output of the steam power plant 2. The thermal efficiency of the steam power plant Now,...

  • 1. A Steam Power Plant that operates on an ideal regenerative Rankine Cycle with an open...

    1. A Steam Power Plant that operates on an ideal regenerative Rankine Cycle with an open feedwater heater is considered. The turbine inlet conditions are 6 MPa, 450 C. The regeneration pressure is 0.4 MPa. The condenser pressure is 20 kPa. a) Draw the T-s diagram, and the sketch of the steam power plant. b) Calculate the low pressure pump work. c) Calculate the high pressure pump work. d) Calculate the fraction of the steam extracted from the turbine for...

  • A Solar Power Facility is a water-vapor power cycle, meaning that H2O is the system that...

    A Solar Power Facility is a water-vapor power cycle, meaning that H2O is the system that does the work... 1: 160 bar, 640 °C A Solar Power Facility is a water-vapor power cycle, meaning that H2O is the system that does the work. turbine boiler Consider a plant that heats the water in the boiler to 160 bar, 640°C. The condenser pressure is 0.1 bar. The inlet to the pump is a saturated liquid at the condenser pressure. 2: 0.1...

  • 1) FOUNDATIONAL PROBLEM (20-16-6-0) A Solar Power Facility is a water-vapor power cycle, meaning that H2O...

    1) FOUNDATIONAL PROBLEM (20-16-6-0) A Solar Power Facility is a water-vapor power cycle, meaning that H2O is the system that does the work. 1: 160 bar, 640 °C 1 Wr turbine boiler Consider a plant that heats the water in the boiler to 160 bar, 640°C. The condenser pressure is 0.1 bar. The inlet to the pump is a saturated liquid at the condenser pressure. 2: 0.1 bar condenser Qout Considering steady-state, ideal operation and with no stray heat transfer...

  • Steam generated in a power plant at a pressure of 8,600 kPa and temperature of 600°C...

    Steam generated in a power plant at a pressure of 8,600 kPa and temperature of 600°C is fed to a turbine. Exhaust from the turbine enters a condenser at 10 kPa, where it is condensed to saturated liquid, which is then pumped to the boiler. The turbine and the pump in the Rankine cycle operate at 80% and 75% efficiency, respectively. a. Determine the rates of heat transfer in the boiler b.Determine the rate of heat transfer in the condenser...

  • The condenser downstream of the turbine in a large Rankine cycle power plant is constructed of...

    The condenser downstream of the turbine in a large Rankine cycle power plant is constructed of 30,000 25-mm tubes. The steam condenses at 50 ºC with a heat transfer coefficient of 9,000 W/m2 ·K on the outside the tubes. The cooling water enters the tube side of the condenser at 20 ºC at a flow rate of 17,000 kg/s. For a 1000 MW (net) power output and a cycle thermal efficiency of 42%, determine: a. the cooling rate required (in...

  • A steam plant operates on a reheat Rankine cycle and has a net power output of...

    A steam plant operates on a reheat Rankine cycle and has a net power output of 80MW. Steam enters the high pressure turbine at 10 MPa and 500 °C and the low pressure turbine at 1 MPa and 500 °C. Steam leaves the condenser as a saturated liquid at a pressure of 10kPa. The efficiency of the turbine is 80% and the efficiency of the pump is 95%. Determine the thermal efficiency of the cycle. Rankine Cycle with Reheat

  • Question 1 The following diagram shows a solar thermal power system. The average daily overall plant (solar- to-elec...

    Question 1 The following diagram shows a solar thermal power system. The average daily overall plant (solar- to-electric) efficiency is 20 %. Solar trough collectors have an approximate efficiency of 60 % . Efficiency of the steam-turbine is about 50 % . The energy conversion efficiency of the generator is 98%. (a) Calculate other losses that are unaccounted for in the system. (b) List the other losses occurring in the system. Solar Field Soler Superheater Steam Turbine Hot Salt Tank...

  • A steam power plant operates on the Rankine cycle modified to include superheat. The steam leaves...

    A steam power plant operates on the Rankine cycle modified to include superheat. The steam leaves the superheater at a pressure of 40 bar and a temperature of 500oC. After expansion in the turbine, which has an isentropic efficiency of 82%, the steam exhausts into the condenser at a pressure of 0.2 bar. Neglecting feed pump work calculate :- 1. The Thermal Efficiency of the plant. 2. The specific steam consumption. 3. The required mass flow rate of steam if...

  • 1. A combined gas-steam power cycle uses a single gas turbine cycle for the air cycle...

    1. A combined gas-steam power cycle uses a single gas turbine cycle for the air cycle and a simple Rankine cycle for the water vapor cycle. Atmospheric air enters the compressor at a rate of 88.2 lbm / s, at 14.7 psia and 59 ° F, and the maximum gas cycle temperature is 1,742 ° F. The pressure ratio in the compressor is 7. The isentropic efficiency of both the compressor and the turbine is 80%. Gas exits the heat...

ADVERTISEMENT
Free Homework Help App
Download From Google Play
Scan Your Homework
to Get Instant Free Answers
Need Online Homework Help?
Ask a Question
Get Answers For Free
Most questions answered within 3 hours.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT