10) (5pts) What is the Voltage Gain in dB of 5000. dB What is the Power...
1. If the voltage gain is 2000, the decibel voltage gain is a. 40 dB c. 66 dB b. 46 dB d. 86 dB 2. The input power to a device is 10.000 W. The output power is 500 W. The power gain (GdB) in decibels is a. -13 dB b. -26 dB c. 56 dB d. 18 dB 3. Which of the following is an advantage of using dB representations of gain values? (a) Positive and negative dB values...
1) What is the gain at 100Hz for an amplifier that has a mid-band gain of 5000, a lower cutoff frequency of 10kHz, and a upper cutoff frequency of 200kHz 2)Calculate the decibel power gain for an Ap= 50? 3)If the decibel voltage gain of an amplifier is 60dB, what is the voltage gain (Av)? 4)If the decibel power gain of an amplifier is 20dB, what is the power gain (AP)? 5)For a two stage amplifier with AV1(DB) equal to...
Express the voltage gain 15.8, current gain 4.43 x 104, and power gain 10 x 10 in dB. AvdB = Аав в ApdB - The amplifier in the given figure has R, -8.1k0, R = 140 kO and operates from 112. V power supplies OVO References eBook & Resources Section Break Difficulty: Medium Learning Objective: Find op amp circuit 2. value 10.00 points What is the voltage gain Ay Volvof the circuit? (Round off the solution to one decimal place.)...
1. A high power amplifier is rated as having a gain of 36 dB. It receives an input power of 10 mW. What is the output power? 2. An electrical circuit has voltage attenuation of -3dB. Calculate Vout /Vin
1.14 An amplifier with a voltage gain of +40 dB, an input resistance of 10 kS2, and an output resistance of i kn is used to drive a l-kΩ load. What is the value of Apo? Find the value of the power gain in decibels. 1.14 An amplifier with a voltage gain of +40 dB, an input resistance of 10 kS2, and an output resistance of i kn is used to drive a l-kΩ load. What is the value of...
An amplifier is specified by manufacturers to have a power gain of 45 dB when used with a 50 Ohm load. The input impedance is 1000 Ohm. If the input voltage is 0.1 V_RMs- what voltage appears across the load?
4. Refer to the following amplifier assuming β-150 for Q1 an d Q2, and β-50 for Q3. (a) Find the total voltage gain in dB (20 points) (b) Find the total power gain dB (20 points) (c) Find the power efficiency (20 points) +15V Ry Ri Rc 0.22 μF ei 2, 1.0μF 47 Ω 500 mVppn 15 k2 Res 100μF 16Ω 2 W 1.0 kHz Ca RE: 160 4. Refer to the following amplifier assuming β-150 for Q1 an d...
QUESTION 24 Voltage gain of 60 dB is a voltage gain of (non-logrithmic) is: A. None of the other choices are correct B. 100 C. 1/1000 D. 1000 E. 1/100 QUESTION 25 The system H(s) = ((s+100)(s+100000)/(s+1000)(5+10000)) is: A. Highpass filter B. Lowpass filter C. None of the other choices are correct D. Bandpass filter E. Bandstop filter QUESTION 26 If F(s) = (1/52), f(t) would be: A. 5(t) B. None of the choices are correct . Ct D. 1...
Problem Consider a voltage amplifier having a frequency response of the low-pass STC 1ype with a de gain of 60 dB and a 3-dB frequency of 1000 Hz Find the gain in dB at f- 10 Hz, 10kHz, 100 kHz, and 1 MHz Problem For the circuit shown below first, evalusteand the coresponding comer froquency. Second evalmt and the corresponding comer froquency. At the end caloulate overall transfer function T(w)= and reurite it in the standard fom ( and draw...
For a hi-fi amplifier, a power gain of 30 is a decibel gain of ___ dB and a power gain of 50 is a decibel gain of ___dB.