Homework Answers
thankyou
Add Answer to:
I need asnwer for both questions
3- A capacitor of 10 uF is charged to 20...
I can find iL(0+) and vC(0+), but I cannot find tm and Vcm. The final answer...
I can find iL(0+) and
vC(0+), but I cannot find tm and
Vcm. The final answer is given for Vcm=-4.718 V and tm=1.7018
ms
In the circuit shown below, the switch was open for a very long time and closes at t = 0. Calculate: 1. The initial value of inductor current, IL(0*), 2. The initial value of capacitor voltage, vc(0*), 3. The minimum value of the capacitor voltage, Vcm, 4. The time, tm, when the minimum in p.3 occurs....
A 0.2 F capacitor has been charged to 10 V. At t = 0, it is...
A 0.2 F capacitor has been charged to 10 V. At t = 0, it is connected to a resistor R and it begins to discharge. At t = 10 seconds, the charge on the capacitor is 1 Coulomb. What is the charge on the capacitor at t = 30 seconds?
A 14.1 ?F capacitor in an RC circuit is initially charged up to a potential difference...
A 14.1 ?F capacitor in an RC circuit is initially charged up to a potential difference of 105 V. Then it is discharged through a resistor with a resistance of 49.1 k2. What is the voltage across the capacitor 423 ms after the discharge begins?
To study the behavior of circuit containing a resistor and a charged capacitor when the capacitor...
To study the behavior of circuit containing a resistor and a charged capacitor when the capacitor begins to discharge. A capacitor with capacitance C is initially charged with charge q. At time t = 0, a switch is thrown to close the circuit connecting the capacitor in series with a resistor of resistance R (Figure 1) Part AWhat happens to the charge on the capacitor immediately after the switch is thrown? The electrons on the negative plate of the capacitor are...
a police car is traveling east at 39.5 A 8.0 uF capacitor is charged by a...
a police car is traveling east at 39.5
A 8.0 uF capacitor is charged by a 13.0 V battery through a resistance R. The capacitor reaches a potential difference of 4.00 V at a time 3.00 s after charging begins. Find R. Need Help? -42 paints Se PSE T9 28 P 042 In the circuit of the figure below, the switch S has been open for a long time. It is then suddenly closed. (Use the following as necessary: for...
In the RC circuit shown, the capacitor is initially charged to 10 volts, and the switch...
In the RC circuit shown, the capacitor is initially charged to 10 volts, and the switch closes at time t=0. The voltage across the capacitor can be described by the equation Vc(t) given below for time t>=0 (greater than, or equal to, O). Determine V_1 and V_2 for this equation. R=100KR C=o.lMF I capacitor initially I charged to 10 volts V(t) = V₂ + (VZ-V4) e ERC for tzo
Automatic Zoom 2. A charged capacitor, an inductor, and a light bulb is put into series...
Automatic Zoom 2. A charged capacitor, an inductor, and a light bulb is put into series as shown in the figure below. Describe how the light bulb act when the switch is closed. You can assume that this is the under-damped case and that the resistance of the light bulb stays constant even when it starts to heat up. Justify your answer with a qualitative plot of the current through the resistor if the switch closes at t = 0.
A capacitor with C 1.30x10-5 F is connected as shown in the figure (Figure 1) with...
A capacitor with C 1.30x10-5 F is connected as shown in the figure (Figure 1) with a resistor with R 980 2 and an emf source with E = 18.0 V and negligible internal resistance. Initially the capacitor is uncharged and the switch S is in position 1. The switch is then moved to position 2, so that the capacitor begins to charge. After the switch has been in position 2 for 10.0 ms, the switch is moved back to...
A capacitor with C = 1.40×10−5 F is connected as shown in the figure (Figure 1)...
A capacitor with C = 1.40×10−5 F is connected as shown in the figure (Figure 1) with a resistor with R = 950 Ω and an emf source with E = 18.0 V and negligible internal resistance. Initially the capacitor is uncharged and the switch S is in position 1. The switch is then moved to position 2, so that the capacitor begins to charge. After the switch has been in position 2 for 10.0 ms, the switch is moved...
In the RC circuit shown, the capacitor is initially charged to 10 volts, and the switch...
In the RC circuit shown, the capacitor is initially charged to 10 volts, and the switch closes at time t=0. What is the maximum value of the current flowing through this circuit for time t >= 0 (greater than, or equal to, 0)? tso R=100ks + 12+ C=0.1MF T capacitor initially charged to lovolts Select one: a. 40 A (Amps) b. 40 mA (milli-Amps) c.40 uA (micro-Amps) d. 4 mA (mill-Amps) e. RC/4 (Amps)
I can find iL(0+) and
vC(0+), but I cannot find tm and
Vcm. The final answer is given for Vcm=-4.718 V and tm=1.7018
ms
In the circuit shown below, the switch was open for a very long time and closes at t = 0. Calculate: 1. The initial value of inductor current, IL(0*), 2. The initial value of capacitor voltage, vc(0*), 3. The minimum value of the capacitor voltage, Vcm, 4. The time, tm, when the minimum in p.3 occurs....
A 14.1 ?F capacitor in an RC circuit is initially charged up to a potential difference of 105 V. Then it is discharged through a resistor with a resistance of 49.1 k2. What is the voltage across the capacitor 423 ms after the discharge begins?
a police car is traveling east at 39.5
A 8.0 uF capacitor is charged by a 13.0 V battery through a resistance R. The capacitor reaches a potential difference of 4.00 V at a time 3.00 s after charging begins. Find R. Need Help? -42 paints Se PSE T9 28 P 042 In the circuit of the figure below, the switch S has been open for a long time. It is then suddenly closed. (Use the following as necessary: for...
In the RC circuit shown, the capacitor is initially charged to 10 volts, and the switch closes at time t=0. The voltage across the capacitor can be described by the equation Vc(t) given below for time t>=0 (greater than, or equal to, O). Determine V_1 and V_2 for this equation. R=100KR C=o.lMF I capacitor initially I charged to 10 volts V(t) = V₂ + (VZ-V4) e ERC for tzo
Automatic Zoom 2. A charged capacitor, an inductor, and a light bulb is put into series as shown in the figure below. Describe how the light bulb act when the switch is closed. You can assume that this is the under-damped case and that the resistance of the light bulb stays constant even when it starts to heat up. Justify your answer with a qualitative plot of the current through the resistor if the switch closes at t = 0.
A capacitor with C 1.30x10-5 F is connected as shown in the figure (Figure 1) with a resistor with R 980 2 and an emf source with E = 18.0 V and negligible internal resistance. Initially the capacitor is uncharged and the switch S is in position 1. The switch is then moved to position 2, so that the capacitor begins to charge. After the switch has been in position 2 for 10.0 ms, the switch is moved back to...
In the RC circuit shown, the capacitor is initially charged to 10 volts, and the switch closes at time t=0. What is the maximum value of the current flowing through this circuit for time t >= 0 (greater than, or equal to, 0)? tso R=100ks + 12+ C=0.1MF T capacitor initially charged to lovolts Select one: a. 40 A (Amps) b. 40 mA (milli-Amps) c.40 uA (micro-Amps) d. 4 mA (mill-Amps) e. RC/4 (Amps)
Most questions answered within 3 hours.
-
You purchase your daily coffee at the Chemist’s Coffeehouse and
have a choice of two cups:...
asked 1 hour ago -
Which of the following pairs of chemicals could be used to make
a buffer solution?
A.)...
asked 1 hour ago -
Problem 16-51 Sales
Activity Variance (LO 16-3)Odessa, Inc., reports the following
information concerning operations for the...
asked 1 hour ago -
Pictured on the right are thee point charges Q1 = 18.4 μC, Q2 =
-30.6 μC,...
asked 1 hour ago -
A graduate student is conducting research in psychology and
needs to obtain the IQ scores of...
asked 2 hours ago -
R2.84: There are 2 defective products in a production lot of 10.
An inspector randomly selected...
asked 3 hours ago -
Consider the following equilibrium system: COCl2(g) CO(g) +
Cl2(g) A 10.00 L evacuated flask is filled...
asked 4 hours ago -
1) What are the two distinct steps that one needs to perform
when developing a data...
asked 4 hours ago -
2) Write a C++ program that uses a class called “Degree” to
obtain the trigonometric
values...
asked 5 hours ago -
1. In eukaryotic cells the genomes of
&
asked 5 hours ago -
The standard enthalpy of propanol (C3H7OH) is -303.0 kJ/mol.
Compute both of the
gross and net...
asked 5 hours ago -
Why PWM using H-bridge for control motor speed is more power
effiecient than the linear amplifier...
asked 5 hours ago