Homework Answers
Add Answer to:
Consider a half-wave rectifier circuit with a triangular-wave input of 5-V peak-to-peak amplitude and zero average,...
Shirt /10 pts 2 (10 pts) Half-wave rectifier circuit (Multiple Choice) For the rectifier circuit below,...
Shirt /10 pts 2 (10 pts) Half-wave rectifier circuit (Multiple Choice) For the rectifier circuit below, let the input be a sine wave with a value of 120 Vrms and assume a constant voltage drop model of 0.7 V p D Select a suitable value for R so that the peak diode current does not exceed 50 mA a 2400 0 32250 A. B. 3000 0 C. 3380 0 D the diode? b. What is the greatest reverse voltage that...
4. The half-wave rectifier in Fig. P3.94 is operating with an input voltage, V = 10...
4. The half-wave rectifier in Fig. P3.94 is operating with an input voltage, V = 10 sinat,at a frequency of 60 Hz and Von=1V. (25 points) C D Les = Figure P3.94 a. Draw the output voltage (Vo(t)) waveform. b. What is the minimum value of C required to maintain the ripple voltage to less than 0.25V if R=0.5 Q and the diode voltage drop is 1V? c. What is the PIV rating of the diode in this circuit? d....
Design a FULL WAVE BRIDGE RECTIFIER circuit that will: Take 120volts ac, 60 hz, sinusoidal waveform...
Design a FULL WAVE BRIDGE RECTIFIER circuit that will:
Take 120volts ac, 60 hz, sinusoidal waveform and convert
it to a “regulated “dc value
giving 12 volts +, - 1 volt across a 2000-ohm output
load resistor with no more than 2%
ripple voltage.
You may assume:
a. An ideal power transformer as discussed in class.
b. For hand computations, you must assume a diode given by
Figure 4.8 page 185.
c. A filter capacitor sized per the textbook equation...
A half-wave diode rectifier circuit is driven by a 60Hz sine wave with a peak value...
A half-wave diode rectifier circuit is driven by a 60Hz sine wave with a peak value of 19V. If the load resistance this circuit drives is 4.3kΩ and the ripple voltage at the output is 0.43 Vpeak-to-peak, then what is the peak current in the diode in milliamps? Answer: Check The diode circuit shown is a Select one: O a. Voltage doubler circuit O b. DC restorer circuit c. Limiter circuit O d. Peak detector circuit O e. None of...
w A ovo 3. (15 pts) The input Vg to the rectifier circuit on the right...
w A ovo 3. (15 pts) The input Vg to the rectifier circuit on the right is a sinusoidal signal of amplitude 4V, as shown below. Use the 0.7V voltage drop model for the diode. a) Determine the maximum and minimum values of the output voltage V across load resistor RL. b) Determine the conduction angle. c) Determine the percent conduction. 10022 {RL 2002 3. (15 pts) The input to the rectifier circuit on the right is sinusoidal signal of...
D *4.80 It is required to use a peak rectifier to design a de power supply...
D *4.80 It is required to use a peak rectifier to design a de power supply that provides an average de output voltage of 12 V on which a maximum of ±1-V ripple is allowed. The rectifier feeds a load of 200 2. The rectifier is fed from the line voltage (120 V rms, 60 Hz) through a transformer. The diodes available have 0.7-V drop when conducting. If the designer opts for the half-wave circuit: (a) Specify the rms voltage...
QUESTION 6 Following circuit is a half-wave rectifier. Assume Vs(t) = Vp sin (wt) where Vp...
QUESTION 6 Following circuit is a half-wave rectifier. Assume Vs(t) = Vp sin (wt) where Vp = 19 V, w=2nf and f=60 Hz. Also assume C = 415 F and R = 844 , and on-voltage Von = 1 V for the diode. Calculate the ripple voltage, Vr, at the output of the rectifier. Vout
Please note that D4 is the one that was destroyed not D1. Please I posted this but they answer it...
Please note that D4 is the one that was destroyed not D1.
Please I posted this but they answer it differently
QUESTION (2) Due to an abnormal operating condition, Diode D4 in this full-wave rectifier circuit was suddenly destroyed, and stopped Vconducting in both forward and reverse directions (i.e. open circuit) C- R Assume that all other diodes are ideal with zero forward voltage drop and that the time constant RC- 5 ms. stt) 10V For a 1 kHz triangular...
2. Consider the full-wave rectifier circuit in below. The output resistance is R - 125 12,...
2. Consider the full-wave rectifier circuit in below. The output resistance is R - 125 12, each diode cut-in voltage is V, -0.7 V, and the frequency of the input signal is 60 Hz. If a filter capacitor will be connected in parallel with R. The magnitude of the peak output voltage is to be 15 V and the ripple voltage is to be no more than 0.35 V. (a) Determine the rms value of vs and (b) the required...
For your choice of input voltage, load resistor and the value of the ripple voltage (as percent of Vdc) design a circuit for the half-wave rectifier. Assuming the value of Van for the diode, calc...
For your choice of input voltage, load resistor and the value of the ripple voltage (as percent of Vdc) design a circuit for the half-wave rectifier. Assuming the value of Van for the diode, calculate theoretically all parameters of the rectifier: Vp, Vdc, Idc, C, Isc, PIV and diode conducting interval. Simulate the designed circuit first without the capacitor filter and show on the graphs of the input, output and diode voltages and load and diode currents. Show on the...
Shirt /10 pts 2 (10 pts) Half-wave rectifier circuit (Multiple Choice) For the rectifier circuit below, let the input be a sine wave with a value of 120 Vrms and assume a constant voltage drop model of 0.7 V p D Select a suitable value for R so that the peak diode current does not exceed 50 mA a 2400 0 32250 A. B. 3000 0 C. 3380 0 D the diode? b. What is the greatest reverse voltage that...
4. The half-wave rectifier in Fig. P3.94 is operating with an input voltage, V = 10 sinat,at a frequency of 60 Hz and Von=1V. (25 points) C D Les = Figure P3.94 a. Draw the output voltage (Vo(t)) waveform. b. What is the minimum value of C required to maintain the ripple voltage to less than 0.25V if R=0.5 Q and the diode voltage drop is 1V? c. What is the PIV rating of the diode in this circuit? d....
Design a FULL WAVE BRIDGE RECTIFIER circuit that will:
Take 120volts ac, 60 hz, sinusoidal waveform and convert
it to a “regulated “dc value
giving 12 volts +, - 1 volt across a 2000-ohm output
load resistor with no more than 2%
ripple voltage.
You may assume:
a. An ideal power transformer as discussed in class.
b. For hand computations, you must assume a diode given by
Figure 4.8 page 185.
c. A filter capacitor sized per the textbook equation...
A half-wave diode rectifier circuit is driven by a 60Hz sine wave with a peak value of 19V. If the load resistance this circuit drives is 4.3kΩ and the ripple voltage at the output is 0.43 Vpeak-to-peak, then what is the peak current in the diode in milliamps? Answer: Check The diode circuit shown is a Select one: O a. Voltage doubler circuit O b. DC restorer circuit c. Limiter circuit O d. Peak detector circuit O e. None of...
w A ovo 3. (15 pts) The input Vg to the rectifier circuit on the right is a sinusoidal signal of amplitude 4V, as shown below. Use the 0.7V voltage drop model for the diode. a) Determine the maximum and minimum values of the output voltage V across load resistor RL. b) Determine the conduction angle. c) Determine the percent conduction. 10022 {RL 2002 3. (15 pts) The input to the rectifier circuit on the right is sinusoidal signal of...
D *4.80 It is required to use a peak rectifier to design a de power supply that provides an average de output voltage of 12 V on which a maximum of ±1-V ripple is allowed. The rectifier feeds a load of 200 2. The rectifier is fed from the line voltage (120 V rms, 60 Hz) through a transformer. The diodes available have 0.7-V drop when conducting. If the designer opts for the half-wave circuit: (a) Specify the rms voltage...
QUESTION 6 Following circuit is a half-wave rectifier. Assume Vs(t) = Vp sin (wt) where Vp = 19 V, w=2nf and f=60 Hz. Also assume C = 415 F and R = 844 , and on-voltage Von = 1 V for the diode. Calculate the ripple voltage, Vr, at the output of the rectifier. Vout
Please note that D4 is the one that was destroyed not D1.
Please I posted this but they answer it differently
QUESTION (2) Due to an abnormal operating condition, Diode D4 in this full-wave rectifier circuit was suddenly destroyed, and stopped Vconducting in both forward and reverse directions (i.e. open circuit) C- R Assume that all other diodes are ideal with zero forward voltage drop and that the time constant RC- 5 ms. stt) 10V For a 1 kHz triangular...
2. Consider the full-wave rectifier circuit in below. The output resistance is R - 125 12, each diode cut-in voltage is V, -0.7 V, and the frequency of the input signal is 60 Hz. If a filter capacitor will be connected in parallel with R. The magnitude of the peak output voltage is to be 15 V and the ripple voltage is to be no more than 0.35 V. (a) Determine the rms value of vs and (b) the required...
For your choice of input voltage, load resistor and the value of the ripple voltage (as percent of Vdc) design a circuit for the half-wave rectifier. Assuming the value of Van for the diode, calculate theoretically all parameters of the rectifier: Vp, Vdc, Idc, C, Isc, PIV and diode conducting interval. Simulate the designed circuit first without the capacitor filter and show on the graphs of the input, output and diode voltages and load and diode currents. Show on the...
Most questions answered within 3 hours.
-
20% of all customers subscribe to phone service.
70% of all customers subscribe to internet service....
asked 14 minutes ago -
Write a program to solve the Josephus problem, with the following
modification:
Sample Input:
./a.out n...
asked 2 hours ago -
At the start of a CD it is spinning at a rate of 525 rpm
(revolutions...
asked 3 hours ago -
4. Without doing any calculations, predict whether the observed
∆T would increase, decrease or remain the...
asked 4 hours ago -
Based on the range, which of the following sets of scores has
the greatest variability? 3,...
asked 5 hours ago -
Ripples in a pond travel at a velocity of 3 m/s with one peak
passing a...
asked 5 hours ago -
A man stands on the roof of a building of height 13.0 mm and
throws a...
asked 5 hours ago -
The extent to which assets are financed by borrowed funds and
other liabilities is indicated by:...
asked 6 hours ago -
Explain in detail
Germany is the fifth largest economy
explain what goods and services Germany specializes...
asked 7 hours ago -
The density of platinum is 21.45 g/mL. If a cube of platinum
with a mass of...
asked 7 hours ago -
Accounts Receivable
Sales
A/R Posting
Extended Sales Invoice
Packing Slip
Compare invoice to packing slip 2...
asked 7 hours ago -
Michaella, age 23, is a full-time law student and is claimed by
her parents as a...
asked 7 hours ago