Homework Answers
Add Answer to:
YS 1410 PROBLEM SET 3 PAGE 2 A cart rolling on a track slows down from...
Two carts are rolling to the right along the same level track. Cart 1, with a...
Two carts are rolling to the right along the same level track. Cart 1, with a mass m1 = 3.4 kg, is in the rear, rolling at a speed of 6.2 m/s and catching up to cart 2, which is rolling at a speed of 3.2 m/s. Choose signs carefully; only speeds are given. a) Cart 1 overtakes and collides with cart 2, sticking to it (both have Velcro pads). Afterward, they both continue rolling right, now at a speed...
A 5.0-kg carl (cart 1) rolling cast on a level, frictionless track at 18.0 m/s, collides...
A 5.0-kg carl (cart 1) rolling cast on a level, frictionless track at 18.0 m/s, collides with a stationary 4.0-kg cart (cart 2). After the collision, cart 1 is still rolling cast, but now at a speed of 2.0 m/s. (a) Assuming the total momentum of the two-cart system is conserved, calculate the final velocity of the second cart. (b) Before the collision, the system's total kinetic energy was 810 J. Calculate the total kinetic energy of the two-cart system...
Suppose that while a mining cart is rolling along a straight, frictionless, horizontal track with some...
Suppose that while a mining cart is rolling along a straight, frictionless, horizontal track with some initial speed, it starts to rain. If the rain falls vertically into the cart and begins to accumulate within it, flooding the cart, determine the following 19. is the momentum of the system conserved in the horizontal direction? a. Yes b. No 20. Is the momentum of the system conserved in the vertical direction? a. Yes b. No 22.If a 1200 kg train car...
A bicycle slows down uniformly from an initial velocity vi = 8.70 m/s to rest over a distance of 125 m.
1. A bicycle slows down uniformly from an initial velocity vi = 8.70 m/s to rest over a distance of 125 m. Each wheel has an overall diameter of 690 cm. You can assume that the wheels roll without slipping. (a) Calculate the angular speed of the wheels at the initial instant (t = 0). (b) Calculate the total number of revolutions each wheel rotates before coming to rest. (c) Calculate the angular acceleration of the wheel (d) Calculate the time it takes to...
To find the acceleration of a glider moving down a sloping air track, you measure its...
To find the acceleration of a glider moving down a sloping air track, you measure its velocity at two points (?1 and ?2); and the time t it takes between them: v1 = .21 ± 0.05 m/s v2 = .85 ± 0.05 m/s 2 = 0 t = 8.0 ± 0.1 s a. Assuming all uncertainties are independent and random, and acceleration is calculated using a = (v2-v1)/t, what should you report for a and its uncertainty? b. You calculate...
Ultrasonic motion sensor Pre - laboratory Assignment In experiments 1 and 2, you will use a...
Ultrasonic motion sensor Pre - laboratory Assignment In experiments 1 and 2, you will use a cart, track, and motion detector like those Spring bumper illustrated in Figure 1 to validate the work-energy theorem end examine the conversation of mechanical energy principle. Sonar reflector Cart Track Data acquisition TC Leveling jacks Figure 1. Experimental setup used in Lab #6 Consider the following exercises/questions relevant to experiments 1 and 2. Question 1. Show that the kinematics equation 12 - v2 =...
Page of 3 8) A car travels a distance straight down the road according to the...
Page of 3 8) A car travels a distance straight down the road according to the equation x (r)=ara_b? . where a-2 m/s2 and b-0.1 m/s3 a) Calculate the average velocity of the car for the time interval t-0 s to t-10 s. b) Calculate the instantaneous velocity of the car at t-0 s, t-1 s, and t-5s. c) Other than at t-0, when is the car at rest? 9) The graph shows a car's position as a function of...
Impulse and Momentum Name: Date: TA's Name: Learning Objectives: 1. Understanding force ys time curves for...
Impulse and Momentum Name: Date: TA's Name: Learning Objectives: 1. Understanding force ys time curves for a collision. 2. Calculating impulse using force vs. time curves. 3. Understanding the relationship between impulse and momentum. 4. Applying conservation of momentum for inelastic collisions. Apparatus: Aluminum track, track legs, two smart carts, two cart stops, and small black rectangular cart masses. Part A: Collision of a moving cart with a fixed cart cart 1 Cart stop stationary cart cart stop Consider the...
Question 3: In order to determine the force of friction and the coefficient of kinetic friction,...
Question 3: In order to determine the force of friction and the coefficient of kinetic friction, you will use Vernier Video Analysis to find the acceleration of the cart. You will use the following video to determine these values. Download the following video and open up Vernier Video Analysis, and then import the video into the program. You need to begin your analysis after the hand is no longer pushing the cart and finish when the cart has come to...
Kinematica Lab PHY 231 - University Physics 1 Measurement of acceleration on an inclined plane 1....
Kinematica Lab PHY 231 - University Physics 1 Measurement of acceleration on an inclined plane 1. Incline the track by a few degrees by placing a book or platform jack under one end. 2. Place t hat Place two photogales in gate mode along the track and record the distance between the gates 3 Release the and to Release the cart from the top of the track and record the time it takes the cart to pass through each gate...
A 5.0-kg carl (cart 1) rolling cast on a level, frictionless track at 18.0 m/s, collides with a stationary 4.0-kg cart (cart 2). After the collision, cart 1 is still rolling cast, but now at a speed of 2.0 m/s. (a) Assuming the total momentum of the two-cart system is conserved, calculate the final velocity of the second cart. (b) Before the collision, the system's total kinetic energy was 810 J. Calculate the total kinetic energy of the two-cart system...
1. A bicycle slows down uniformly from an initial velocity vi = 8.70 m/s to rest over a distance of 125 m. Each wheel has an overall diameter of 690 cm. You can assume that the wheels roll without slipping. (a) Calculate the angular speed of the wheels at the initial instant (t = 0). (b) Calculate the total number of revolutions each wheel rotates before coming to rest. (c) Calculate the angular acceleration of the wheel (d) Calculate the time it takes to...
Ultrasonic motion sensor Pre - laboratory Assignment In experiments 1 and 2, you will use a cart, track, and motion detector like those Spring bumper illustrated in Figure 1 to validate the work-energy theorem end examine the conversation of mechanical energy principle. Sonar reflector Cart Track Data acquisition TC Leveling jacks Figure 1. Experimental setup used in Lab #6 Consider the following exercises/questions relevant to experiments 1 and 2. Question 1. Show that the kinematics equation 12 - v2 =...
Page of 3 8) A car travels a distance straight down the road according to the equation x (r)=ara_b? . where a-2 m/s2 and b-0.1 m/s3 a) Calculate the average velocity of the car for the time interval t-0 s to t-10 s. b) Calculate the instantaneous velocity of the car at t-0 s, t-1 s, and t-5s. c) Other than at t-0, when is the car at rest? 9) The graph shows a car's position as a function of...
Impulse and Momentum Name: Date: TA's Name: Learning Objectives: 1. Understanding force ys time curves for a collision. 2. Calculating impulse using force vs. time curves. 3. Understanding the relationship between impulse and momentum. 4. Applying conservation of momentum for inelastic collisions. Apparatus: Aluminum track, track legs, two smart carts, two cart stops, and small black rectangular cart masses. Part A: Collision of a moving cart with a fixed cart cart 1 Cart stop stationary cart cart stop Consider the...
Question 3: In order to determine the force of friction and the coefficient of kinetic friction, you will use Vernier Video Analysis to find the acceleration of the cart. You will use the following video to determine these values. Download the following video and open up Vernier Video Analysis, and then import the video into the program. You need to begin your analysis after the hand is no longer pushing the cart and finish when the cart has come to...
Kinematica Lab PHY 231 - University Physics 1 Measurement of acceleration on an inclined plane 1. Incline the track by a few degrees by placing a book or platform jack under one end. 2. Place t hat Place two photogales in gate mode along the track and record the distance between the gates 3 Release the and to Release the cart from the top of the track and record the time it takes the cart to pass through each gate...
Most questions answered within 3 hours.
-
Industry standards suggest that 16% of new vehicles require
warranty service within the first year. Jones...
asked 7 minutes ago -
1) Comment of this statement: “A compiler transforms high-level
language statements directly into object codes”.
asked 10 minutes ago -
Calculate the molality, mole-fraction and percent mass of 28.9M
HF at 25 degrees Celcius of the...
asked 19 minutes ago -
A developmental psychologist believes that children raised in
bilingual families will have higher verbal fluency at...
asked 25 minutes ago -
A fast food meal has 5660 kJ of energy. A person uses energy at
a rate...
asked 38 minutes ago -
The pKb for a generic amine(R-NH2)) in
aqueous solution is 6.30. What is its pKa?
asked 39 minutes ago -
The following reactions have the indicated equilibrium constants
at a particular temperature: N2(g) + O2(g) ⇌...
asked 41 minutes ago -
Please Help ASAP.
1Consider the below code which iterates over a linked
list of n nodes...
asked 57 minutes ago -
Determine the air to fuel ratio of:
Canadian natural gas, with 93.9% methane, 4.2% ethane, 0.3%...
asked 58 minutes ago -
A manufacturer of power tools claims that the average amount of
time required to assemble their...
asked 1 hour ago -
"electron-withdrawing substituents on carbon encourage back
donation", then on the next page he says that "greater...
asked 1 hour ago -
On December 31, 2016, the shareholders’ equity section of the
balance sheet of R & L...
asked 1 hour ago