ZuoTi.Pro
Question

What color bands would be printed on resistors with the resistances below? (i)    530 kΩ band 1    ...

What color bands would be printed on resistors with the resistances below?

(i)    530 kΩ

band 1    
band 2    
band 3    


(ii)    8.4 kΩ

band 1    
band 2    
band 3    
science   physics   
0 0
Add a comment Improve this question Transcribed image text
Next > < Previous
Sort answers by oldest

Homework Answers

Answer #1

color codes are as follows:

Black - 0

Brown - 1

red - 2

orange - 3

yellow - 4

green -5

blue -6

violet -7

grey -8

white-9

part 1:

530 kilo ohms=53*10^4 ohms

band 1- green (for 5)
band 2- orange (for 3)
band 3-yellow (for exponent 4)


part 2:

8.4 kilo ohms=8.4*10^3=84*10^2

band 1- grey (for 8)
band 2- yellow (for 4)
band 3-red (for exponent 2)

0 0
Add a comment
Know the answer?
Add Answer to:
What color bands would be printed on resistors with the resistances below? (i)    530 kΩ band 1    ...
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Log In

Sign Up

Not the answer you're looking for? Ask your own homework help question. Our experts will answer your question WITHIN MINUTES for Free.
Similar Homework Help Questions

  • 1. Using the colored bands on the two resistors at your table, you determine that the...

    1. Using the colored bands on the two resistors at your table, you determine that the two resistances of the resistors are 300 ohms with 20% tolerance and 200 ohms with a 5% tolerance. What would you expect the equivalent resistance of the two resistors to be (including the uncertainty) if they are connected in series? (Answer ± Answer) ohms

  • The drawing below shows the color bars on a typical resistor. The bands are counted from...

    The drawing below shows the color bars on a typical resistor. The bands are counted from one to four starting from left to right. The arrow points to one of the bands. What does this band show? od doo the second number the third number the multiplier the tolerance When wiring a duplex outlet, the hot wire is usually connected to the colored terminal screw of the outlet 1. brass

  • Starting in 2013, every guest staying at a Disney hotel is given a free magic band...

    Starting in 2013, every guest staying at a Disney hotel is given a free magic band (a bracelet that has a computer chip that turns a bracelet into a hotel room key, parktickets, and dining plan meal card). Prof. K has a collection of 21 magic band bracelets from various trips over the years as listed below: MAGIC BAND COLOR NUMBER OF MAGIC BANDS Red 7 Pink 1 Yellow 3 Blue 4 Orange 2 Purple 3 Pink 1 Gray 1...

  • Notes for lab dc02-Resistors and the Color Code will skip are Part 2 e, g: Part 4; Exercises 2, 4,5,6 an...

    Notes for lab dc02-Resistors and the Color Code will skip are Part 2 e, g: Part 4; Exercises 2, 4,5,6 and 3. It is important to answer the exercises correctly in each labl you should include the appropriate prefix for the unit in the Numerical Value We will not be Volt using the Volt-Ohm meter (VOM) for this lab, so skip the parts that ask for VOM measurements. The parts we You do need to complete Exercises1 Note that in...

  • Three resistors with color codes 1. Brown, Brown, Brown, 2. Red, Red, Red 3. Orange, Black,...

    Three resistors with color codes 1. Brown, Brown, Brown, 2. Red, Red, Red 3. Orange, Black, Orange are connected in parallel. A battery of voltage 4.5 V is connected to the resistors. a) Draw the circuit diagram. b) List the values of the resistors according to color code. c) Calculate the equivalent resistance 1st Digit d) Find the current through each resistor e) Add the currents through each resistor to find the total current and use the voltage to find...

  • I need help and a bit confused on the following questions. Thanks in advance! 1. Three...

    I need help and a bit confused on the following questions. Thanks in advance! 1. Three resistors with resistances of 5.0 ?, 9.0 ?, and 12.0 ?, respectively, are connected in a series circuit with a 6.0 V battery. Find the potential difference across the 5.0 ? resistor. 2. Following the steps and answering the questions below, find the equivalent resistance of the combination of resistors shown in the figure: We will break this complex circuit into simpler combinations of...

  • Design and implement a C program that acts as a resistor color code encoder using 4 color bands. for example, a 1.2k resistance with 2% tolerance is expressed as [1] black [2] red [3] brown [4] red in...

    Design and implement a C program that acts as a resistor color code encoder using 4 color bands. for example, a 1.2k resistance with 2% tolerance is expressed as [1] black [2] red [3] brown [4] red in a 4 color band resistor. input: Resistance, R, in ohms or kilo-ohms output: The color code sequence the user should not be asked to do the conversion. Do not ask the user to enter the first number, the second number, multiplication factor...

  • 1. What is the equivalent resistance of two parallel resistors, one of 40 Ω and the...

    1. What is the equivalent resistance of two parallel resistors, one of 40 Ω and the other 60 Ω? What is the equivalent capacitance oftwo parallel capacitors, one of 10μF and the other 15 μΕ? 2. a) You pick up a resistor and notice its color bands are BLUE, YELLOW, and What is the value of this resistor? RED. 3. b) and another has BROWN, BLACK, BROWN. What is its resistance?

  • 1) What does the appearance of a new band in a western blot mean? 2) When...

    1) What does the appearance of a new band in a western blot mean? 2) When a band on a western blot increases in density over time, what does it mean? 3) When a band on a western blot decreases in density over time, what does it mean? 4) As it relates to EGF signaling, what process in the cell would possibly lead a band to increase in density over time? 5) As it relates to EGF signaling, what process...

  • 3. The figure below shows a schematic of the dispersion for the conduction and valence bands...

    3. The figure below shows a schematic of the dispersion for the conduction and valence bands for particular semiconductor. The conduction band has dispersion equation a 10-35 E (3 x 10 19) [2 x 10 and the valence band has dispersion equation E (4 x 10-37A2 where in both cases E is in units of joules and k in units of m1 E 6x 10-19 J 2 6 x 10 m -6 -4 -2 2 k (a) Is this a...

ADVERTISEMENT
Free Homework Help App
Download From Google Play
Scan Your Homework
to Get Instant Free Answers
Need Online Homework Help?
Ask a Question
Get Answers For Free
Most questions answered within 3 hours.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT