2. Size an office meter for service on a 3 inch schedule 40 pipe carrying a...
2. Size an office meter for service on a 3 inch schedule 40 pipe carrying a hydrocarbon liquid( specific gravity equals to 0.65) with a maximum flow rate of 175 GPM and a minimum flow rate of 75 gpm. Assume that the line pressure is 150 psig.
Homework Answers
Add Answer to:
2. Size an office meter for service on a 3 inch schedule 40 pipe
carrying a...
A vertical venturi-meter is connected to a vertical pipe which carries water as shown in the...
A vertical venturi-meter is connected to a vertical pipe which carries water as shown in the figure. the diameters at the entrance and throat are 150 mm and 75 mm, respectively. The the mercury (specific gravity +13.6). U-tube mercury manometer connected to the entrance and throat of the meter . the height difference between the throat and entrance is 150mm.If the actual rate is 40 liters/s and the coefficient of discharge is 0.96, calculate (a) the pressure difference between entrance and...
1. A constriction meter in a 2-inch diameter pipeline consists of a short section of 1.2-inch...
1. A constriction meter in a 2-inch diameter pipeline consists of a short section of 1.2-inch diameter pipe (as shown below). The contraction and expansion are abrupt with 0 = 180 degrees. When the flow rate is 0.19 cfs the pressure at point 1 is 14 psi. (a) For this flow rate, calculate the level of the energy grade line (EGL) and hydraulic grade line (HGL) before the contraction (point 1), in the contraction (point 2) and after the expansion...
Problem 2 [20 Points: 1- An orifice meter with a3 inch opening s placed on a...
Problem 2 [20 Points: 1- An orifice meter with a3 inch opening s placed on a water line a32 (p62.4 lb/ftthat has an 6 inch outer diamete. According to the factory manual the coefficient of discharge is 0.85 After attaching a manometer to help measu w rate through the pipe. The manometer measures a differential pressure of 4 inches of mercury (pm 848.4 Ibs/ft) What is the volumetric flow rate? Orifice Plate Upstream 2AP 2- What is the velocity of...
L 2. Steady statemass balance: Water is flowing at steady state in a 0.1 meter-diameter pipe...
L 2. Steady statemass balance: Water is flowing at steady state in a 0.1 meter-diameter pipe with a maximum velocity (turbulent profile) of 0.3 meters/sec. The pipe then goes through an expansion, to where it is then flowing in a 0.5 meter-diameter pipe, and the flow regime has changed from turbulent to laminar. In the second section of pipe, calculate the velocity as (a) block flow profile (Vavg), and (b) maximum velocity in laminar flow profile? HINT: you will need...
Question 3 (40 marks) (a) Air enters a horizontal nozzle with a velocity of 1 m/s,...
Question 3 (40 marks) (a) Air enters a horizontal nozzle with a velocity of 1 m/s, a pressure of 2 bar and a temperature of 350 K. At exit from nozzle, the air temperature is 450 K. The combined rate of specific heat transfers, and specific work transfers, w to the air as it passes through the nozzle is 150 kJ/kg. Assume that the air flow is steady and air can be treated as perfect gas with = 1005 J/(kg.K)....
1. Assume ideal flow from reservoir A to reservoir B. The pipe from reservoir A to...
1. Assume ideal flow from reservoir A to reservoir B. The pipe from reservoir A to the turbine is a constant diameter. Sketch the HGL and EGL as accurate as possible. Indicate on the sketch where the minimum and maximum pressures are. pomp TJ TOEBE Match the correct Key term with the correct Definition Key Terms Bernoulli Equation Cavitation Continuity Equation Elevation Head Energy Grade Line Definitions Nothing changes with time, velocity is constant Most used and abused equation in...
In regards to question 3, will cavitation occur based on the NPSH available vs NPSH required?...
In regards to question 3, will cavitation occur based on the
NPSH available vs NPSH required?
Water is pumped from a reservoir to a large receiver vessel which is maintained at p3 = 6 bar through the operation of the pump and a high pressure nitrogen supply that bleeds into the tank through a regulator. The water enters through an opening at the top of the vessel. A drain is provided at the low point in the system. Elevations are...
(100 points) Water at 25°C is pumped at a rate of 0.075m's from a reservoir 20m above a pump to a free 1....
(100 points) Water at 25°C is pumped at a rate of 0.075m's from a reservoir 20m above a pump to a free 1. discharge (this means discharged to atmosphere) 35m above the pump. The pressure on the intake side of the pump is 150kPa and the pressure on the discharge side of the pump is 450kPa. The pipe between the reservoir and the pump is 3 meters of Sin diameter cast iron. From the pump to the discharge the pipe...
1/9 1 Piping system (14 points) Water is pumped from a reservoir to a large receiver...
1/9 1 Piping system (14 points) Water is pumped from a reservoir to a large receiver vessel which is maintained at p4 6 bar (absolute) through the operation of the pump and a high pressure nitrogen supply that bleeds into the tank through a regulator. The water enters through an opening at the top of the vessel. A drain is provided at the low point in the system. Elevations are as shown. All valves are gate valves (k = 0.15)...
1/9 1 Piping system (14 points) Water is pumped from a reservoir to a large receiver...
1/9 1 Piping system (14 points) Water is pumped from a reservoir to a large receiver vessel which is maintained at p4 6 bar (absolute) through the operation of the pump and a high pressure nitrogen supply that bleeds into the tank through a regulator. The water enters through an opening at the top of the vessel. A drain is provided at the low point in the system. Elevations are as shown. All valves are gate valves (k = 0.15)...
1. A constriction meter in a 2-inch diameter pipeline consists of a short section of 1.2-inch diameter pipe (as shown below). The contraction and expansion are abrupt with 0 = 180 degrees. When the flow rate is 0.19 cfs the pressure at point 1 is 14 psi. (a) For this flow rate, calculate the level of the energy grade line (EGL) and hydraulic grade line (HGL) before the contraction (point 1), in the contraction (point 2) and after the expansion...
Problem 2 [20 Points: 1- An orifice meter with a3 inch opening s placed on a water line a32 (p62.4 lb/ftthat has an 6 inch outer diamete. According to the factory manual the coefficient of discharge is 0.85 After attaching a manometer to help measu w rate through the pipe. The manometer measures a differential pressure of 4 inches of mercury (pm 848.4 Ibs/ft) What is the volumetric flow rate? Orifice Plate Upstream 2AP 2- What is the velocity of...
L 2. Steady statemass balance: Water is flowing at steady state in a 0.1 meter-diameter pipe with a maximum velocity (turbulent profile) of 0.3 meters/sec. The pipe then goes through an expansion, to where it is then flowing in a 0.5 meter-diameter pipe, and the flow regime has changed from turbulent to laminar. In the second section of pipe, calculate the velocity as (a) block flow profile (Vavg), and (b) maximum velocity in laminar flow profile? HINT: you will need...
Question 3 (40 marks) (a) Air enters a horizontal nozzle with a velocity of 1 m/s, a pressure of 2 bar and a temperature of 350 K. At exit from nozzle, the air temperature is 450 K. The combined rate of specific heat transfers, and specific work transfers, w to the air as it passes through the nozzle is 150 kJ/kg. Assume that the air flow is steady and air can be treated as perfect gas with = 1005 J/(kg.K)....
1. Assume ideal flow from reservoir A to reservoir B. The pipe from reservoir A to the turbine is a constant diameter. Sketch the HGL and EGL as accurate as possible. Indicate on the sketch where the minimum and maximum pressures are. pomp TJ TOEBE Match the correct Key term with the correct Definition Key Terms Bernoulli Equation Cavitation Continuity Equation Elevation Head Energy Grade Line Definitions Nothing changes with time, velocity is constant Most used and abused equation in...
In regards to question 3, will cavitation occur based on the
NPSH available vs NPSH required?
Water is pumped from a reservoir to a large receiver vessel which is maintained at p3 = 6 bar through the operation of the pump and a high pressure nitrogen supply that bleeds into the tank through a regulator. The water enters through an opening at the top of the vessel. A drain is provided at the low point in the system. Elevations are...
(100 points) Water at 25°C is pumped at a rate of 0.075m's from a reservoir 20m above a pump to a free 1. discharge (this means discharged to atmosphere) 35m above the pump. The pressure on the intake side of the pump is 150kPa and the pressure on the discharge side of the pump is 450kPa. The pipe between the reservoir and the pump is 3 meters of Sin diameter cast iron. From the pump to the discharge the pipe...
1/9 1 Piping system (14 points) Water is pumped from a reservoir to a large receiver vessel which is maintained at p4 6 bar (absolute) through the operation of the pump and a high pressure nitrogen supply that bleeds into the tank through a regulator. The water enters through an opening at the top of the vessel. A drain is provided at the low point in the system. Elevations are as shown. All valves are gate valves (k = 0.15)...
1/9 1 Piping system (14 points) Water is pumped from a reservoir to a large receiver vessel which is maintained at p4 6 bar (absolute) through the operation of the pump and a high pressure nitrogen supply that bleeds into the tank through a regulator. The water enters through an opening at the top of the vessel. A drain is provided at the low point in the system. Elevations are as shown. All valves are gate valves (k = 0.15)...
Most questions answered within 3 hours.
-
Assume that the situation can be expressed as a linear cost
function. Find the cost function....
asked 1 hour ago -
(Sort ArrayList) Write the following method that sorts an
ArrayList: public static > void sort(ArrayList list)...
asked 1 hour ago -
2) A 9 volt battery is connected to a parallel plate capacitor
with an initial capacitance...
asked 1 hour ago -
Prince Equipment has to decide whether to obtain $1,000,000 of
financing by: (1) selling common stock...
asked 2 hours ago -
The terms electrical and electronic have similar but
different meanings which of the following statement is...
asked 2 hours ago -
You wish to test the claim that the mean GPA of night students
is than 2.5...
asked 3 hours ago -
A soft drink machine outputs a mean of 25 ounces per cup. The
machine's output is...
asked 4 hours ago -
Ross Co., Westerfield, Inc., and Jordan Company announced a new
agreement to market their respective products...
asked 3 hours ago -
What is the distance run by a runner 50m/hr and
60m/hr?
asked 4 hours ago -
Write a descendant selector rule that affects the <em>
element that is contained within the
<p>...
asked 4 hours ago -
The management of an electrical manufacturing plant determined
that the mean life of their 10 watt...
asked 4 hours ago -
On January 1, Year 1, Prairie Enterprises purchased a parcel of
land for $13,100 cash. At...
asked 5 hours ago