Please help 1) Let assume to have a 10nF ceramic capacitor with 20nH of series inductance...
Help
A series RLC circuit has components with the following values: L = 16.0 mH. C = 82.0 nF, R = 15.0 ohm, and Delta V_max = 100 V, with Delta v = Delta V_max sin omega t. Find the resonant frequency of the circuit. 4.3939e03 Resonance occurs when the impedance is at a minimum. kHz Find the amplitude of the current at the resonant frequency. 6.67 A Find the Q of the circuit. 2.68 How is the Q related...
(2 points) Two driven inductors A R = 1 kΩ resistor, a L1 = 20 mH inductor and a L2 28 mH inductor are connected in series. A funtion generator drives the circuit with a 5 Vpp variable frequency sine wave. (a) What is the equivalent impedance Zeq of this circuit? O A. R +jwLIL2/(L1+ L2) E. None of these (b) For what angular frequency does |Zoq v2 R? 20833.3 radians/sec (c) What is the peak-to-peak value of the voltage...
One or two sentence answers are fine. But please be clear with explanations. For each statement, decide whether it is always true, always false or true in certain circumstances. State which case applies to the statement, describing why you chose the answer you did and cite an experiment or principle of Physics which supports` your claim. [1] In a capacitor in an AC circuit, the electric field leads the current. [2] The impedance of a capacitor increases with frequency. [3]...
please help! will give a thumbs up
7) Given a timing circuit, you are asked to connect the following components in series. A 6-microfarad capacitor, and a 2002. They car connected with a 30 V voltage source that has angular frequency of 250 rad/s. a) What is the impedance of the entire circuit? b) What is voltage across both the resistor and capacitor? c) Calculate the phase angle d) What quadrant would you find this angle? 8) A resistor is...
please only answer Part C, all other parts is for any
information you may need.
- Part = Xc, solve for the frequency. That is the resonant frequency f? Using the expressions for XL and Xc given in the introduction and setting X Express your answer in terms of L, C and any relevant constant. O AXD O2 ? Submit Request Answer The amplitude of the AC current (10) in a series LRC circuit is dependent on the amplitude of...
Assume the load resistor RL= 100
Ohms. Assume vS(t) =
1cos(wt). Rs=3ohms, L1=7H, L2=9H, and C=8uF
First, convert the circuit to an impedance equivalent circuit in
the phasor domain finding impedances in terms of w. Draw the
circuit and mark the impedances.
Then analyze the circuit (you will need to find equivalent
impedances and apply voltage division rule) to find the phasor
VL in terms of
VS, and find an expression for
g =
|VL|/|VS|,
the gain ratio of the...
need help graphing this to make it a "voltage across the
resistor vs. frequency" please show work thank you
how is it in complete?
EXPERIMENT 7. RLC SERIES CIRCUIT NAN PART DATE 3/ylis LA ROCEDURE A: REACTANCES AND POTENTIALs Resistance of inductor R Resistance of L & N box Capacitance of Cenco box Power Supply Voltage from DMNM Voltage across the capacitor V 500 0.10 3.00 S2 volts volts Voltage across the inductor V evots Voltage across L & N...
Hi-fi audio amplifiers are usually built as discrete operational
amplifiers with a
relatively large gain (g ? 500) and with feedback that reduces the
closed-loop gain
to a smaller value k = 32. Since loudspeakers predominatly act like
a resistor
(nominal impedance: 8
) with an inductor in series, the feedback network can be
used to improve the frequency response in the audio range up to 20
kHz. We are
primarily concerned with gain and frequency response of the
amplifier....
We would like to build an AM radio receiver using a series RLC
circuit working as a bandpass filter. We have decided to use a 240
μH inductor with an internal resistance of 12Ω, and a variable
capacitor whose capacitance varies between 40 to 360 pF. A radio
“tunes” into a certain frequency by adjusting its receiver circuit
so that it resonates at that frequency, and it only catches that
specific frequency.
1. Determine the range of channel frequencies that...