Question

sonus(Uptional) Would you recommend plating Fe, to protect it from corrosion, with each of the following metals/Au Cr; Ba; Pb? Why or why not? [Ignore the cost of the metat in making your decision.] page.) (To asstst in your choice of the correct response consult the standard reduction potentials on the cover
0 0
Add a comment Improve this question Transcribed image text
Answer #1

The reduction potential of the given metals are

Fe = -0.44 V

Au = +1.50 V

Cr = -0.74 V

Ba = -2.90 V

Pb = -0.13 V

Thus Ba and Cr has a lower reduction potential than Fe and can protect the Fe from galvanic corrosion. Pb cannot be used to protect Fe from corrosion because of the higher reduction potential than Fe. Au cannot offer galvanic protection to Fe. However, if completely covered over the Fe surface by plating, Au can protect Fe from corrosion, because it is less reactive than iron, and forms a barrier. The Au layer will act like a paint film and protect the iron from corroding even though it does reduce iron's propensity to be corroded

Hope this helps. Use comment box if you need further clarification

Add a comment
Know the answer?
Add Answer to:
sonus(Uptional) Would you recommend plating Fe, to protect it from corrosion, with each of the following...
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for? Ask your own homework help question. Our experts will answer your question WITHIN MINUTES for Free.
Similar Homework Help Questions
  • need help with the rest of the table EXPERIMENT 10 DETERMINATION OF THE ELECTROCHEMICAL SERIES PURPOSE...

    need help with the rest of the table EXPERIMENT 10 DETERMINATION OF THE ELECTROCHEMICAL SERIES PURPOSE To determine the standard cell potential values of several electrochemical coll INTRODUCTION The basis for an electrochemical cell is an oxidation reduction Corredor be divided into two half reactions reaction. This reaction can Oxidation half reaction Gloss of electrons) takes place at the anode, which is the positive electrode that the anions migrate to Chence the name anode) Reduction half reaction (gain of electrons)...

  • 7. Using the following reaction progress diagram, answer the questions below: wiring Energy A G Rxn....

    7. Using the following reaction progress diagram, answer the questions below: wiring Energy A G Rxn. a. How many steps are in the reaction? How do you know? (4 points) b. Which letter corresponds to the rate-determining-step? Explain your choice. (6 points) c. Is the reaction exothermic or endothermic? How do you know? (4 points) d. If the energy at point B is lowered, what will happen to the rate of the reaction will it increase, decrease, or stay the...

  • with the information and tables provided, can you help me answer questions 2,3,4,and 5? thank you!...

    with the information and tables provided, can you help me answer questions 2,3,4,and 5? thank you! DATA ANALYSIS - ONLINE SIMULATION DATA Record your collected data here. Black Red E (V) Cu Zn -1.10 Cu Sn -0.48 Cu Mg -2.71 Cu Ag 0.46 QUALITY OF DATA This section awards marks based on the quality of your Ell values. Quality of data Your standard cell potentials are in the expected order. EXPECTED DATA The expected data is given below. Use the...

  • this is all we were given in class Calculate the value of AG for the following...

    this is all we were given in class Calculate the value of AG for the following reaction if [H2O2]i = [Fe] =1.0 M [OH']; = 1.3 x10-M, and [Fe3+] = 0.50 M. In which direction will this reaction have to shift in order to reach equilibrium? Explain your answer. Fe2(aq) + H2O2(aq) 5 Fe3+ (aq) + OH(aq) Standard-State Reduction Potentials and Half Rache Best reducing agents K + eK Bat +2 Ba Ca" + 2e Ca Na + c N...

  • 16.52 Balance each of the following unbalanced equations for cell reactions in acidic conditions, then calculate...

    16.52 Balance each of the following unbalanced equations for cell reactions in acidic conditions, then calculate the standard cell emf, and decide whether the equation is written in the direction of spontaneous reaction. (a) Sn2+ (aq) + Ag(s) > Sn(s) + Ag+ (aq) (b) Al(s) + Sn4+ (aq) → Sn²+ (aq) + AP+ (aq) (C) CIO3+ (aq) + Ce3+ (aq) —Cl(aq) + Ce++ (aq) (d) Cu(s) + NO3 (aq) —> Cu2+ (aq) + NO(g) 16 .1 APPENDIX F standard Reduction...

  • helpp 3. For the hypothetical reaction A+B → C the following rate data (with and without...

    helpp 3. For the hypothetical reaction A+B → C the following rate data (with and without catalyst) were obtained: Rate, M/s Rate, M/s ALM B., Muncatalyzed) (catalyzed) 0.100 0.200 3.51 x 10 7.14 x 10 0.100 0.100 1.75 x 10 7.14 x 10 0.0500 0.200 1.76 x 10 3.57 x 10 0.0500 0.100 8.80 x 10 3.57 x 10 Based on these data: a. Determine the uncatalyzed and catalyzed rate laws for this reaction, and the corresponding rate constants. (16...

  • please solve A to d to get thumps up. Question 11 5 pts Consider a galvanic...

    please solve A to d to get thumps up. Question 11 5 pts Consider a galvanic cell consisting of the following two redox couples: Sn2+ (aq, 0.010 M) + 2e --> Sn (s) E.-0.14 V Cst (aq, 0.010 M) + e --> Cs(s) E--2.92 V a. Write the equation for the half-reaction at the cathode Question 12 5 pts b. Write the equation for the half-reaction at the anode HTML Editor Question 13 6 pts c. Write a shorthand cell...

  • Try Again Your answer is wrong. In addition to checking your math, check that you used...

    Try Again Your answer is wrong. In addition to checking your math, check that you used the right data and DID NOT round any intermediate calculations. 0.7996 -1.676 1.692 1.49B -2.912 1.066 -2.868 Using standard reduction potentials from the ALEKS Data tab, calculate the standard reaction free energy AG" for the following redox reaction. clo Data Round your answer to 5 significant digits. Ag+ (aq) + e + Ag (s) H, (8)+20H(aq) + C1, (8) + 2H,0 (1)+201 (aq) A13+...

  • Using the standard reduction potentials listed, calculate the equilibrium constant for each of the following reactions...

    Using the standard reduction potentials listed, calculate the equilibrium constant for each of the following reactions at 298 K. A) Fe(s)+Ni2+(aq)→Fe2+(aq)+Ni(s) Express your answer using two significant figures. B) Co(s)+2H+(aq)→Co2+(aq)+H2(g) Express your answer using two significant figures. C) 10Br−(aq)+2MnO−4(aq)+16H+(aq)→2Mn2+(aq)+8H2O(l)+5Br2(l) Express your answer using two significant figure. E°(V) -0.83 +0.88 +1.78 +0.79 Half-Reaction E°(V) Half-Reaction Ag+ (aq) + - Ag(s) +0.80 2 H20(1) + 2 e — H2(8) + 2 OH+ (aq) AgBr(s) + - Ag(s) + Br" (aq) +0.10 HO2...

  • Essay question: If you were offered a position with a company which would allow you to...

    Essay question: If you were offered a position with a company which would allow you to take the position as either a W2 employee or an independent contractor as a 'consultant' explain which one you would choose under these circumstances and why: The job pays $100,000 per year paid monthly. One month vacation for both 1099 & W2. Job stability is equal regardless of which option you choose. No other benefits beyond what is required by Federal Law. You are...

ADVERTISEMENT
Free Homework Help App
Download From Google Play
Scan Your Homework
to Get Instant Free Answers
Need Online Homework Help?
Ask a Question
Get Answers For Free
Most questions answered within 3 hours.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT