1)A 3300 F capacitor is connected in series with a 50 k resistor to a 64 V voltage source. At t=0, the charge on the capacitor is zero.
2)At what time is the charge on the capacitor 52800 C?
3)At what time is the voltage across the capacitor 32 V?
4)In the same scenario, after the capacitor is fully charged, it is disconnected from the voltage source and discharged through the resistor.
5)How long does it take till the voltage is 32 V?
Screen Shot 2021-04-07 at 5.39.14 PM.png
We need at least 10 more requests to produce the answer.
0 / 10 have requested this problem solution
The more requests, the faster the answer.
A 3300 microF capacitor is connected in series with a 50 kilo ohms resistor to a 64 V voltage source. At t=0, the charge on the capacitor is zero.
An uncharged capacitor and a resistor are connected in series to a source of emf. If emf=9.00 V, capacitance=21.5 ?F, and resistance=127Ω, find (a) the time constant of the circuit. After 1.30 ms, find (b) the charge on the capacitor, (c) the voltage drop across the capacitor, (d) the voltage drop across the resistor, and (e) the current.
10. A resistor and capacitor are connected in series to a voltage source. At time t = 0 the capacitor begins charging, and the charge on the capacitor is Qc. The graph below depicts Qc vs t. The slope of the graph represents: Qс CV a) The total charge on the capacitor b) The potential energy stored in the capacitor c) The equivalent resistance of the circuit d) The instantaneous voltage across the capacitor e) The instantaneous current through the...
An AC source operating at 60-Hz with a maximum voltage of 170 V is connected in series with a resistor (R = 1.2 k Q) and capacitor (C = 2.5 μF). a) What is the maximum value of the current in the circuit? b) What is the maximum values of the potential difference across the resistor and capacitor? c) When the current is zero, what are the magnitudes of the potential difference across the resistor, capacitor and AC source? How much charge is...
A resistor of 5 kilo-ohms is connected to a 10 micro-farad capacitor. The initial charge in the capacitor is 20 micro-coulombs. What is the voltage across the capacitor after one time constant? 0.74v 126v 5A1V 252V
A resistor, an inductor, and a capacitor are connected in series to an AC source. The AC source is operating at the resonance frequency. Which of the following statements are true? Check all that apply. The current is in phase with the driving voltage. The total voltage across the inductor and the capacitor at any instant is equal to zero. The peak voltage across the capacitor is greater than the peak voltage across the inductor. The peak voltage across the...
A capacitor is connected in series to a resistor with a resistance of 1.2ko and a battery with an emf of 12 V. a) What multiple of the time constant gives the time taken by the initially uncharged capacitor to reach 58% of its maximum charge? b) At that charge, what is the current through the resistor? At that charge, what is the potential across the capacitor? d) At that charge, what is the potential across the resistor?
5. A resistor and capacitor are connected in series with an applied AC voltage source. There is no inductor. Separate voltmeter readings across the resistor and capacitor give values of 50 V and 75 V (rms) respectively. What is the (rms) voltage of the source? (5 points)
A resistor, 50.0-mH inductor, and 100.0-uF capacitor are connected in series with a 50-Hz voltage source. The maximum voltage through the circuit is 240 V. Calculate the power across the LCR circuit, if phase angle between the current and voltage is 60degrees.
1. A resistor R and capacitor care connected in series with an AC voltage source with frequency f and maximum voltage Vo. a. Find the complex impedance (in the form Z = R + jX). If the impedance is written in polar form (Z = Zejº), find expressions for Z and Ⓡ. Write your answers in terms of the variables R, C, and o(= 21f). b. If the voltage source is described by the phasor V = V, ejwt, and...
A circuit has an ac voltage source and a resistor and capacitor connected in series. There is no inductor. The ac voltage source has voltage amplitude 0.900 kV and angular frequency w = 20.0 rad/s. The voltage amplitude across the capacitor is 0.500 kV. The resistor has resistance R= 0.300 kΩ. Part A What is the voltage amplitude across the resistor? Part B What is the capacitance C of the capacitor? Part C Does the source voltage lag or lead the current? Part D What is the average...