A cylindrical tank or radius 2 meters and height 7 meters is filled with water to...
(10 points) A cylindrical tank of radius 2 meters and height 14 meters is filled with water to a depth of 10 meters. How much work is required to pump all the water over the upper rim? The weight density of water is 9810 N/m'.
A cylindrical water tank 6 meters high with a radius of 2 meters is buried so that the top of the tank is 1 meter below ground level (see figure). How much work is done in pumping a full tank of water up to ground level? (The water weighs 9800 newtons per cubic meter.) newton-meters y Ground level 7- y Ду х -2 2
A water tank is shaped like a right, circular cylinder with height 6 ft and radius 3 ft. If the tank is filled to 1 ft below the top, find the work required to pump all of the water to the level of the top and let flow over the edge. The density of water is 62.5 lbs per cubic foot.
A cylindrical water tank has a radius of 2.8 feet and a height of 5.6 feet. The water tank is filled to the top. If water can be pumped out at a rate o f36 cubic feet per minute, about how long will it take to empty the water tank? A.3 hours B. 2 hours C.4 minutes D. 1 minute
Water in a vertical cylindrical tank of height 29 it and radius 4 ft is to be pumped out. The density of water is 62.4 lb/R. (6) The tank is full of water and all of the water is to be pumped over the top of the tank. Find the approximate work for the slice as shown. Use Delta or A from the CalcPad. Leave in your answer. 32118.5281 ( 29 - y) Ay Find the endpoints for the integral...
5 points WORK LIFT PROBLEM An inverted conical tank at a chemical plant has a base radius of 4 m and height of 3 m and is completely filled with liquid nitrogen, which has a density of 808.4 kg/m3. The Earth's gravitational constant is -9.8 m/s2. How much work is needed to pump all of the liquid nitrogen up through an outflow pipe that empties 3 meters above the top of the tank? (Note that the conical tank is opening...
Pumping a conical tank A right- circular conical tank, point
down, with top radius 5 ft and height 10 ft is filled with a liquid
whose weight-density is 60 lb/ft^ 3 . How much work does it take to
pump the liquid to a point 2 ft above the tank? If the pump is
driven by a motor rated at 275 ft-lb/sec (1/2 hp), , how long will
it take to empty the tank? Must work the integral out by...
A tank in the shape of an inverted right circular cone has height 5 meters and radius 3 meters. It is filled with 2 meters of hot chocolate. Find the work required to empty the tank by pumping the hot chocolate over the top of the tank. The density of hot chocolate is δ=1040 kg/m^3. Your answer must include the correct units.
A cylindrical tank is being filled with water. The tank is initially empty but then water begins to flow into it at a rate of 62.00 kg/min. There is a small hole of radius r = 0.7000 cm at the bottom of the tank where water can escape. Because the flow rate of water leaving the hole is initially at a slower rate than water entering the tank, the water level rises. The average velocity of water leaving through the...
Consider the following tank. The shape of this tank is a trough whose ends are isosceles triangles. The height of the trough is 6 meters. The width is also 6 meters. and the length of the trough is 8 meters. (See figure to the right.) Suppose this tank contains honey (for whatever reason). The density of honey is p = 1420 kg/m^3. If the tank is initially filled with honey, how much work will it take to pump all of...