Homework Answers
Add Answer to:
Question 4 (1 point) As you increase the frequency of your source, the voltage attenuates at...
this is a question from a review for a test. please help! An RC circuit with...
this is a question from a review for a test. please
help!
An RC circuit with R = 10 Kilo-ohms and C = 40 nano-Farads is constructed to serve as an example of a first order system and as a filter. The capacitor is uncharged when the circuit is assembled. Two sources of input voltage to the circuit are possible, a DC power supply or a function generator. 1a) (6 points) • What input source would be used to determine...
1. Read the laboratory supplement entitled “Frequency Response". 2. Read the remainder of this handout. 3....
1. Read the laboratory supplement entitled “Frequency Response". 2. Read the remainder of this handout. 3. In Multisim, build the circuit shown in Figure 1 with C=0.22 uF and R = 2.2 k12. This circuit looks like a simple voltage divider except that one of the resistors is replaced by a capacitor. Il Figure 1: RC network. F Set up Vin to be a 1 Vpp sinusoid with 0 VDC Offset using a function generator. 2. Connect the oscilloscope in...
done on pspice thank you Part IV: Diode Rectifiers Procedure: 1. Build the circuit model for...
done on pspice thank you
Part IV: Diode Rectifiers Procedure: 1. Build the circuit model for full-wave diode rectifier in PSpice as shown in Fig. 4. The value of the load resistor is 10 k22. The input AC voltage source (VSIN in PSpice) is configured at 100 Hz and 20 V (peak-to- peak) in sinusoidal waveform. O 10K V.(t) V(A) A Figure 4. Circuit configuration for full-wave diode rectifier 2. Run the simulation and save the input and output voltage...
Objectives: To learn transient behavior of series RC circuits To observe of time constant and its...
Objectives: To learn transient behavior of series RC circuits To observe of time constant and its effect on charging process of capacitor using pulse waveforms Equipment: Oscilloscope Function generator Resistors (1 k) Capacitors (1 uF) Breadboard Pre-Lab Questions A pulse is a voltage or current that changes from one level to the other and back again. If a waveform's high time equals its low time, it is called a square wave. The length of each cycle (one positive peak and...
1. The following half-wave rectifier circuit has a 120-Vrms source at 60-Hz, R-500-2, and C-100-uF. Determine:...
1. The following half-wave rectifier circuit has a 120-Vrms source at 60-Hz, R-500-2, and C-100-uF. Determine: a) An expression for the output voltage. b) The peak-to-peak voltage variation on the output. c) An expression for capacitor current. d) The peak diode current. e) Confirm your answers through OrCAD solution. Display all graphs and tabulate the results ID IR le Vs Vm Sin(wt) R. T100 Vo soon
1. In this class and in other physics lab classes you will often use oscilloscopes to...
1. In this class and in other physics lab classes you will often use oscilloscopes to look at signal that change in time. Below is a sinusoidal AC signal on an oscilloscope screen. The vertical axis is set to 10 mV/division and the horizontal axis is set to 50 ms/division For the signal shown, what is the: a. Average voltage? b. Peak voltage? c. Peak-to-peak voltage? d. RMS voltage? e. Period? f. Frequency? g. If you were to write an...
Question 11 1 pts The peak voltage of an AC source is 200. V. What is...
Question 11 1 pts The peak voltage of an AC source is 200. V. What is the rms voltage? O 200 V O 282 V O 141 V O 100V 1 pts Question 12 In the typical household AC voltage of 120 V, calculate the peak voltage: O 240 V O 120 V O 170 V O 85 V 1 pts Question 13 In an AC series circuit the inductive reactance is 50 and the frequency is 100 Hz. What...
Ov 4) In the above circuit, the alternating voltage source has frequency , am- plitude Vo, and R-Ve. At steady state, calculate how much the phase of the charge on the capacitor lags the voltag...
Ov 4) In the above circuit, the alternating voltage source has frequency , am- plitude Vo, and R-Ve. At steady state, calculate how much the phase of the charge on the capacitor lags the voltage when w is equal to 1/2, 2/2, 3/2, and 4/2 the resonant frequency o Vte
Ov 4) In the above circuit, the alternating voltage source has frequency , am- plitude Vo, and R-Ve. At steady state, calculate how much the phase of the charge on...
Lab Procedure: Part 1: Source Free RC Circuit V(t) ilts C3 (R3 21ko 1uF IC=10V a)...
Lab Procedure: Part 1: Source Free RC Circuit V(t) ilts C3 (R3 21ko 1uF IC=10V a) For the circuit shown above, provide the equation and calculate the following: 1. The source free equation for V(t) for V(O)= 10 volts 2. The equation for it) 3. V(t) and i(t) for t = t (one time constant) b) Now, enter the circuit using Multisim Schematic Capture. c) Simulate using Transient mode with a graphical output and verify graphical results with your calculations....
1. A resistor R and capacitor care connected in series with an AC voltage source with...
1. A resistor R and capacitor care connected in series with an AC voltage source with frequency f and maximum voltage Vo. a. Find the complex impedance (in the form Z = R + jX). If the impedance is written in polar form (Z = Zejº), find expressions for Z and Ⓡ. Write your answers in terms of the variables R, C, and o(= 21f). b. If the voltage source is described by the phasor V = V, ejwt, and...
this is a question from a review for a test. please
help!
An RC circuit with R = 10 Kilo-ohms and C = 40 nano-Farads is constructed to serve as an example of a first order system and as a filter. The capacitor is uncharged when the circuit is assembled. Two sources of input voltage to the circuit are possible, a DC power supply or a function generator. 1a) (6 points) • What input source would be used to determine...
1. Read the laboratory supplement entitled “Frequency Response". 2. Read the remainder of this handout. 3. In Multisim, build the circuit shown in Figure 1 with C=0.22 uF and R = 2.2 k12. This circuit looks like a simple voltage divider except that one of the resistors is replaced by a capacitor. Il Figure 1: RC network. F Set up Vin to be a 1 Vpp sinusoid with 0 VDC Offset using a function generator. 2. Connect the oscilloscope in...
done on pspice thank you
Part IV: Diode Rectifiers Procedure: 1. Build the circuit model for full-wave diode rectifier in PSpice as shown in Fig. 4. The value of the load resistor is 10 k22. The input AC voltage source (VSIN in PSpice) is configured at 100 Hz and 20 V (peak-to- peak) in sinusoidal waveform. O 10K V.(t) V(A) A Figure 4. Circuit configuration for full-wave diode rectifier 2. Run the simulation and save the input and output voltage...
Objectives: To learn transient behavior of series RC circuits To observe of time constant and its effect on charging process of capacitor using pulse waveforms Equipment: Oscilloscope Function generator Resistors (1 k) Capacitors (1 uF) Breadboard Pre-Lab Questions A pulse is a voltage or current that changes from one level to the other and back again. If a waveform's high time equals its low time, it is called a square wave. The length of each cycle (one positive peak and...
1. The following half-wave rectifier circuit has a 120-Vrms source at 60-Hz, R-500-2, and C-100-uF. Determine: a) An expression for the output voltage. b) The peak-to-peak voltage variation on the output. c) An expression for capacitor current. d) The peak diode current. e) Confirm your answers through OrCAD solution. Display all graphs and tabulate the results ID IR le Vs Vm Sin(wt) R. T100 Vo soon
1. In this class and in other physics lab classes you will often use oscilloscopes to look at signal that change in time. Below is a sinusoidal AC signal on an oscilloscope screen. The vertical axis is set to 10 mV/division and the horizontal axis is set to 50 ms/division For the signal shown, what is the: a. Average voltage? b. Peak voltage? c. Peak-to-peak voltage? d. RMS voltage? e. Period? f. Frequency? g. If you were to write an...
Question 11 1 pts The peak voltage of an AC source is 200. V. What is the rms voltage? O 200 V O 282 V O 141 V O 100V 1 pts Question 12 In the typical household AC voltage of 120 V, calculate the peak voltage: O 240 V O 120 V O 170 V O 85 V 1 pts Question 13 In an AC series circuit the inductive reactance is 50 and the frequency is 100 Hz. What...
Ov 4) In the above circuit, the alternating voltage source has frequency , am- plitude Vo, and R-Ve. At steady state, calculate how much the phase of the charge on the capacitor lags the voltage when w is equal to 1/2, 2/2, 3/2, and 4/2 the resonant frequency o Vte
Ov 4) In the above circuit, the alternating voltage source has frequency , am- plitude Vo, and R-Ve. At steady state, calculate how much the phase of the charge on...
Lab Procedure: Part 1: Source Free RC Circuit V(t) ilts C3 (R3 21ko 1uF IC=10V a) For the circuit shown above, provide the equation and calculate the following: 1. The source free equation for V(t) for V(O)= 10 volts 2. The equation for it) 3. V(t) and i(t) for t = t (one time constant) b) Now, enter the circuit using Multisim Schematic Capture. c) Simulate using Transient mode with a graphical output and verify graphical results with your calculations....
1. A resistor R and capacitor care connected in series with an AC voltage source with frequency f and maximum voltage Vo. a. Find the complex impedance (in the form Z = R + jX). If the impedance is written in polar form (Z = Zejº), find expressions for Z and Ⓡ. Write your answers in terms of the variables R, C, and o(= 21f). b. If the voltage source is described by the phasor V = V, ejwt, and...
Most questions answered within 3 hours.
-
You follow the lab procedure and at the end of Part 4C, you used
an average...
asked 14 minutes ago -
Write 250-450 words, about the following: • Analyze how a
servant leader in your organization or...
asked 17 minutes ago -
3. American and Japanese workers can each produce 4 cars a
year. An American worker can...
asked 20 minutes ago -
On October 1, 20X1, a company purchased a piece of land by
agreeing to pay the...
asked 33 minutes ago -
Jamie is doing a survey at her school about whether the students
feel the cafeteria food...
asked 38 minutes ago -
What are the roles of 3' and 5' untranslated regions in
mRNAs?
asked 39 minutes ago -
A domestic television receives antenna delivers a sky noise
power of -105 dBm to a matched...
asked 38 minutes ago -
What do you think are the chemical reactions involved in the
breathalyzer tests administered to potentially...
asked 53 minutes ago -
A random sample of 120 observations produces a mean of
38.2 from a population with a...
asked 1 hour ago -
The average area of land burned by forest fires every year in
Canada is 2.5 million...
asked 1 hour ago -
36. The basic difference between government bureaus and market
firms is that bureaus:
a. can...
asked 1 hour ago -
java
- A recursive method findR() to search for a number in list
(ArrayList)
- A...
asked 1 hour ago