We need at least 10 more requests to produce the answer.
0 / 10 have requested this problem solution
The more requests, the faster the answer.
3. A controlled single-phase fiull-wave controlled rectifier is connected in a de motor drive in Figure 4. The de motor armature inductance can be assumed large enough such that any motor curent ripple is negligible. (a) Assuming negligible supply reactance, show that the average rectifier output voltage V, in tems of the supply ms voltage E and the firing angle a, is given by 2/2E (6 marks) cos a _ (b) Given that the supply voltage is 230V, 50HZ and...
Analyze a DC series phase-controlled motor drive with single-phase, full wave, controlled AC/DC rectifier in continuous conduction mode (CCM) of operation. Draw the motor voltage and current waveforms and write the equations (instantaneous and averaged). Please note that the waveforms and equations have been presented in class for a DC separately-excited motor drive.
What is a rectifier? Explain half wave and full wave rectifier with circuit diagrams.
4.) Worth 30 Points A controlled single-phase full-wave bridge rectifier has a R load (R = 20 92) and a 120 Vrms, 60 Hz AC Source. The delay angle is 45 degrees. Hint: Use the following equation for this problem. 1. " a sina MR V2 21 44 A. Determine the average current in the load. B. Determine the RMS current in the load. C. Determine the RMS source current. D. Determine the power factor. E. Validate your answers using...
3. Consider the full-wave bridge rectifier circuit shown below. The full-wave bridge is made using silicon diodes. 120V 15V 120 V(ms) n 60 Hz 752 Vout a. Find the maximum value of VoUT, and the voltage rating for the capacitor assuming a 50% margin of safety. b. Choose the capacitance of the filter capacitor for a peak-to-peak ripple of 1V, and determine the corresponding peak diode current. What is the frequency of the ripple voltage? c. Now suppose the filter...
PLEASE ANSWER ALL PARTS OF THE QUESTION A single-phase full-wave rectifier in the following figure has a ripple-free average load current of Ia (Highly-Inductive-Load). Assume a transformer turns ratio of unity. (1) Draw the waveform for current ipi, io2 and ip through D1, D2, and at the primary side of transformer, respectively; (2) Express the input primary current ip() in Fourier series (3) Determine the input PF of the rectifier and HF (or THD) of the input primary current ip(t)....
Consider the single-phase full-wave rectifier circuit shown below with a sinusoidal input vs 120 Vrms at 60 Hz and a load R= 250 TiD DAZ 40 AD AD ww D (a) (b) Consider adding a filter capacitor to the full-wave rectifier in Problem 3 to reduce the output ripple (a) Calculate the minimum value of capacitance required to reduce the output voltage ripple to 1 % of the average value (b) Calculate the average output current (c) Calculate the average...
The speed of a separately excited de motor is controlled by a one-phase full-wave converter. The field circuit is also controlled by a full-wave converter and the field current is set to its maximum value. The AC supply voltage to the armature and field converters is one-phase, 400V, 50Hz. The armature resistance Ra 0.232, the field circuit resistance Rf- 1812, and the motor voltage constant is Kv 1.3V/A - rad/s. The armature current corresponding to the load demand Ia 42A...
Controlled three-phase rectifiers Figure 4-20a shows a controlled six-pulse three-phase rectifier. The delay angle a is referenced from where the SCR would begin to conduct if it were a diode. Sketch the output voltage of the controlled rectifier for a delay angle of 60°