po e NISO Consider the following pole that has a tubular cross-section having the following section...

Question

Question

Answer 1

Answer #1

Ane compressine stress A = of toaxial = my & Be = Pyx Do + Por I 863.98106 = 2955% (006 ) + 665 31293764 = 2061157 V10 Pa *

Answer 2

Similar Homework Help Questions

10 points Consider the following pole that has a tubular cross-section having the following section properties...

10 points Consider the following pole that has a tubular cross-section having the following section properties • Outer Diameter = 500 mm • Inner diameter 50.0 mm • Area-863.9 mm · J-658,752.7 mm • 1329,376.4 mm • L-1,353 mm For a load P1.70N and P1053 determine the butto precision. Do not write the unit
For the pipe system below, we assume the cross-section at A is subject to the resultant forces P ...

For the pipe system below, we assume the cross-section at A is subject to the resultant forces P 339 N and Py 448 N. The pipe gauge pressure is given by p 6 b 212 mm and c 263 mm. The circular cross-section has outer diameter do 95 mm and inner diameter d 55 mm 623 kPa. Use the dimensions a 318 mm, Py Determine the state of stress at point K: evaluate the magnitude of the stresses and draw...
1. (15 pts) Athin walled tube of circular cross-section has an inner diameter of 60 mm,...

1. (15 pts) Athin walled tube of circular cross-section has an inner diameter of 60 mm, thickness of 2 mm, and a length of 3 m. a. Determine the maximum torque the tube can withstand if the angle of twist is limited to 6 degrees. b. If the tube is instead capped on both ends and pressurized to p - 20 MPa, calculate the circumferential and longitudinal stresses in the tube. Use G = 15 GPa

The gears attached to the fixed-end steel shaft are subjected to the torques shown in the figure. If the shear modulus of elasticity is 150 GPa a determine the following: nd the shaft has a d...

The gears attached to the fixed-end steel shaft are subjected to the torques shown in the figure. If the shear modulus of elasticity is 150 GPa a determine the following: nd the shaft has a diameter of 14 mm, a. Sketch the torque diagram along the steel shaft. b. Determine the maximum shear stress at Tmax and specify location. c. Sketch the shear stress distribution along the radial line at location specified in (b). d. Determine the displacement of the...