Please show all work and CLEARLY
Homework Answers
Add Answer to:
Please show all work and CLEARLY
A lossless transmission line operates at 500 x 106rad/s with...
A distortionless transmission line with a characteristic impedance of ?0 = 75Ω has an attenuation constant...
A distortionless transmission line with a characteristic impedance of ?0 = 75Ω has an attenuation constant of ? = 10−3 Np/m. The line has a capacitance per unit length of C′ = 60 pF/m. (a) Find the per unit length resistance R′, inductance L′, and conductance G′ of the transmission line. (b) Find the phase velocity ?? for this line.
The input impedance of a 31 - cm - long lossless transmission line of unknown characteristic...
The input impedance of a 31 - cm - long lossless transmission line of unknown characteristic impedance was measured at 1 MHz. With the line terminated in a short circuit, the measurement yielded an input impedance equivalent to an inductor with inductance of 0.064uH, and when the line was open-circuited, the measurement yielded an input impedance equivalent to a capacitor with capacitance of 40uH. Find Zo of the line, the phase velocity, and the relative permittivity of the insulating material.
Please answer. Problem 5. We like to minimize the SWR of a lossless transmission line with...
Please answer.
Problem 5. We like to minimize the SWR of a lossless transmission line with respect to its characteristic impedance Zo. What would be the value Zo for which the SWR is minimum for a load Z4-100-1100
Problem 3. A lossless air-filled transmission line with Zo = 500 is terminated in a load...
Problem 3. A lossless air-filled transmission line with Zo = 500 is terminated in a load with Z. = (100 +j25) 22. Determine the reflection coefficient, VSWR, and the input impedance 0.122 away from the load.
Q1. (20pts) Consider a lossless transmission line with characteristic impedance Zo=50 Q is used to connect...
Q1. (20pts) Consider a lossless transmission line with characteristic impedance Zo=50 Q is used to connect a sinusoidal source with internal resistance Rs=50 2, and 10 Volts peak value to feed a load of ZL=300 Q. At an operating signal wavelength of do, the length of the transmission line is L=2.25o. Determine the followings: a) Standing wave ratio on the line b) Average power delivered to the load in dBm. c) The voltage and current phasor expressions on the transmission...
Phase of a three-phase, 60 Hz, 300 km long power transmission line with a nominal operating...
Phase of a three-phase, 60 Hz, 300 km long power transmission line with a nominal operating line voltage of 500 kV. its inductance per 291 mH/phase, and its capacitance is 3.45uF/phase. Voltage between 500 kV phases from the end of the energy transmission line Under it, a load of 1000 MVA is fed with a power factor of 0.8 back. Power transmission line lossless assumption. This according to the operating conditions, a.) The line's phase constant (61), characteristic impedance (ZC)...
7. Two measurements on a lossless transmission line of characteristic impedance 2-R-5003 length 1= λ / 2 are IIN ●1(ss/)s 2(amps) and VlaV(s.0). 100( volts) (a) Find the phasor voltage V(s) and the p...
7. Two measurements on a lossless transmission line of characteristic impedance 2-R-5003 length 1= λ / 2 are IIN ●1(ss/)s 2(amps) and VlaV(s.0). 100( volts) (a) Find the phasor voltage V(s) and the phasor current I(s) on the line "sfunctions of s/ λ、whm s is the distance from the load and λ is the wavelength. (b) Find the time average power P on the line Hint: Recall that e- LT
7. Two measurements on a lossless transmission line of characteristic...
10.198 A lossless transmission line is 50 cm in length and operates at a frequency of...
10.198 A lossless transmission line is 50 cm in length and operates at a frequency of 100 MHz. The line parameters are L-0.2 μ H/m and C = 80 pF/m. The line is terminated in a short circuit at z 0, and there is a load ZL = 50 + j 20 Ω across the line at location z--20 cm. What average power is delivered to ZL if the input voltage is 10020 V?
Please show all work. A 600 Ω transmission line is 150m long, operates at 400 kHz...
Please show all work.
A 600 Ω transmission line is 150m long, operates at 400 kHz with a-2.4x10 Np/m and B 0.0212 rad/m, and supplies a load impedance ZiL 300+$300 2. Find Zin Answers: 502el 22.8 502e-122.8 205ei22.8 205e-i22.8
a. A 15-m length of 300 Ω lines must be connected to a 3-m length of 150 Ω lines that is terminated in a SO O resistor. Assuming all lines are lossless, find the vswR on the 300 Ω line. In order...
a. A 15-m length of 300 Ω lines must be connected to a 3-m length of 150 Ω lines that is terminated in a SO O resistor. Assuming all lines are lossless, find the vswR on the 300 Ω line. In order to match the two sections, a quarter wavelength line of characteristic impedance Zo is added. Find the appropriate zo. Assume a working frequency of 50 MHz
a. A 15-m length of 300 Ω lines must be connected to...
Please answer.
Problem 5. We like to minimize the SWR of a lossless transmission line with respect to its characteristic impedance Zo. What would be the value Zo for which the SWR is minimum for a load Z4-100-1100
Problem 3. A lossless air-filled transmission line with Zo = 500 is terminated in a load with Z. = (100 +j25) 22. Determine the reflection coefficient, VSWR, and the input impedance 0.122 away from the load.
Q1. (20pts) Consider a lossless transmission line with characteristic impedance Zo=50 Q is used to connect a sinusoidal source with internal resistance Rs=50 2, and 10 Volts peak value to feed a load of ZL=300 Q. At an operating signal wavelength of do, the length of the transmission line is L=2.25o. Determine the followings: a) Standing wave ratio on the line b) Average power delivered to the load in dBm. c) The voltage and current phasor expressions on the transmission...
Phase of a three-phase, 60 Hz, 300 km long power transmission line with a nominal operating line voltage of 500 kV. its inductance per 291 mH/phase, and its capacitance is 3.45uF/phase. Voltage between 500 kV phases from the end of the energy transmission line Under it, a load of 1000 MVA is fed with a power factor of 0.8 back. Power transmission line lossless assumption. This according to the operating conditions, a.) The line's phase constant (61), characteristic impedance (ZC)...
7. Two measurements on a lossless transmission line of characteristic impedance 2-R-5003 length 1= λ / 2 are IIN ●1(ss/)s 2(amps) and VlaV(s.0). 100( volts) (a) Find the phasor voltage V(s) and the phasor current I(s) on the line "sfunctions of s/ λ、whm s is the distance from the load and λ is the wavelength. (b) Find the time average power P on the line Hint: Recall that e- LT
7. Two measurements on a lossless transmission line of characteristic...
10.198 A lossless transmission line is 50 cm in length and operates at a frequency of 100 MHz. The line parameters are L-0.2 μ H/m and C = 80 pF/m. The line is terminated in a short circuit at z 0, and there is a load ZL = 50 + j 20 Ω across the line at location z--20 cm. What average power is delivered to ZL if the input voltage is 10020 V?
Please show all work.
A 600 Ω transmission line is 150m long, operates at 400 kHz with a-2.4x10 Np/m and B 0.0212 rad/m, and supplies a load impedance ZiL 300+$300 2. Find Zin Answers: 502el 22.8 502e-122.8 205ei22.8 205e-i22.8
a. A 15-m length of 300 Ω lines must be connected to a 3-m length of 150 Ω lines that is terminated in a SO O resistor. Assuming all lines are lossless, find the vswR on the 300 Ω line. In order to match the two sections, a quarter wavelength line of characteristic impedance Zo is added. Find the appropriate zo. Assume a working frequency of 50 MHz
a. A 15-m length of 300 Ω lines must be connected to...
Most questions answered within 3 hours.
-
The x component of the velocity of an object vibrating
along the x-axis obeys the equation...
asked 58 minutes ago -
A junction box contains two trade size 2 raceways on the left
side, and two trade...
asked 1 hour ago -
Atmospheric Mass
Venus and Earth have about the same mass and radius, but the
atmospheric pressure...
asked 2 hours ago -
5. Discuss the use of fault tree analysis (FTA) for risk
assessment (maximum one paragraph).
asked 3 hours ago -
Given that a sample of aluminium oxide has a Young's modulus of
393 GPa and a...
asked 4 hours ago -
At a certain temperature, the equilibrium constant, Kc, for this
reaction is 53.3.
H2(g)+I2(g)−⇀↽−2HI(g)Kc=53.3
At this...
asked 6 hours ago -
Question1 ) The STL provides similiar classes called stack and
queue, both of which gave functions...
asked 7 hours ago -
For Questions 1-4, assume you have 5 bits available:
1. For (positive) integers: What is the...
asked 7 hours ago -
convert grams into vloume with the density of water being at
.997514 g/cm^3 at 23.1 Celsuis...
asked 9 hours ago -
Foreman company obtained a $20,000, 6% loan on May 1, 2018.
Principal and interest will be...
asked 9 hours ago -
5. Problem 11.05 (Discounted Payback)
eBook
Project L costs $60,000, its expected cash inflows are $14,000
per...
asked 9 hours ago -
1. Which of the following is true about politics and health
organizations?
A. Health organizations are...
asked 10 hours ago