Consider the RL circuit in the figure with R = 1300 Ohm, L = 30 mH,...

Question

Question

Consider the RL circuit in the figure with R = 130

Answer 1

Answer #1

3002 Ac Wear어 Current с 63-94 (5x30x1๙ an 1300 300 - 63.76 current 63-76丶

Answer 2

Similar Homework Help Questions

a series circuit has RL= 150 o, L= 30 mH, and the coil resistance of the...

a series circuit has RL= 150 o, L= 30 mH, and the coil resistance of the inductor is R=60 ohm. if the circuit is connected to a 24 volts, 400hz supply, calculate the circuit current and its phase angle with respect tot he supply.
Consider a series RL circuit with R= 85.0 12 and an unknown inductor L, driven by...

Consider a series RL circuit with R= 85.0 12 and an unknown inductor L, driven by an AC emf with Erms= 32.0 Volts at frequency f= 6.90 kHz. If we measure the current in the circuit, we find Irms= 0.156 Amps. E 12 L What is the inductance L? (in H) OA: 1.41x10-3|OB: 2.05x10-3|OC: 2.97x10-3|OD: 4.30-10-3|| OE: 6.24x10-3 OF: 9.04x10-3 Submit Answer Tries 0/2 What is the magnitude of the phase angle between the applied voltage and the current? (in...
1. A series RLC circuit has R = 1009, L = 15 mH and C =...

1. A series RLC circuit has R = 1009, L = 15 mH and C = 10 uF. It is connected to an AC course with f= 60.0Hz and Vmax = 110 V. A. Calculate the phase angle between the current and the voltage. B. What is the maximum value of the current at this frequency? C. What source frequency in Hz) is needed for the series RLC circuit to be at resonance?

A controlled half-wave rectifier has an RL load with R 20 ohm and L 40 mH....

A controlled half-wave rectifier has an RL load with R 20 ohm and L 40 mH. The source is 120 V rms at 60 Hz The delay angle required to produce an average current of 2.0 A I output RMS I input RMS Apparent power and power factor Skitch Vout, Iout, and V diod
Consider the RLC circuit below, with R= 20 12, L = 10 mH, and C =...

Consider the RLC circuit below, with R= 20 12, L = 10 mH, and C = 5 mF. The voltage source has a voltage amplitude of 26.0 V and an angular frequency of w = 500 rad/s. a) What is the total impedance of the circuit? b) Find the amplitude of the current, and the phase angle, d. c) Draw a phasor diagram of the impedances. Be sure to clearly label Z, R, XL, Xc, and 0. R C E
(2 points) Two driven inductors A R = 1 kΩ resistor, a L1 = 20 mH...

(2 points) Two driven inductors A R = 1 kΩ resistor, a L1 = 20 mH inductor and a L2 28 mH inductor are connected in series. A funtion generator drives the circuit with a 5 Vpp variable frequency sine wave. (a) What is the equivalent impedance Zeq of this circuit? O A. R +jwLIL2/(L1+ L2) E. None of these (b) For what angular frequency does |Zoq v2 R? 20833.3 radians/sec (c) What is the peak-to-peak value of the voltage...

An ac generator supplies an rms voltage of 5.00 V to an RL circuit. At a...

An ac generator supplies an rms voltage of 5.00 V to an RL circuit. At a frequency of 20.0 kHz the rms current in the circuit is 45.0 mA; at a frequency of 26.0 kHz the rms current is 40.0 mA. What is the values of L in this circuit? What is the values of R in this circuit?
In the figure, set R = 238 ohm, C = 65.5 mu F, L = 250...

In the figure, set R = 238 ohm, C = 65.5 mu F, L = 250 mH, f = 60.0 Hz, and V_max = 8.10 V. What are impedance phase angle maximum current
An RLC series circuit with 150-ohm resistor, 25-mH inductor, and 2 microfarad-capacitor is powered by an...

An RLC series circuit with 150-ohm resistor, 25-mH inductor, and 2 microfarad-capacitor is powered by an AC voltage source with a peak voltage of 340V and a frequency of 660 Hz. (a) Find the peak current that flows in the circuit. (b) Determine the phase angle of the source voltage relative to the current. (c) Determine the peak voltage across the resistor and its phase angle relative to the voltage source. (d) Find the peak voltage across the inductor and...

An RLC series circuit with 150-ohm resistor, 25-mH inductor, and 2 microfarad-capacitor is powered by an...

An RLC series circuit with 150-ohm resistor, 25-mH inductor, and 2 microfarad-capacitor is powered by an AC voltage source with a peak voltage of 340V and a frequency of 660 Hz. (a) Find the peak current that flows in the circuit. (b) Determine the phase angle of the source voltage relative to the current. (c) Determine the peak voltage across the resistor and its phase angle relative to the voltage source. (d) Find the peak voltage across the inductor and...