find max flow and min cut from Source O to Sink T
From the above diagram the minimum cut will be as follows-
Min cut = {(B,T),(C,T),(E,T)} all forward .
Capacity of the cut = 7+3+4 = 14
As Per the theorem, in any basic network, the value the of maximum flow is equal to the Capacity of the minimum cut.
So the maximum flow is 14.
. Find a max flow in this network from s to t, and show the final flow value along each edge. Also indicate the vertex partition that forms a min cut, and show the edges that cross the min cut. Show max flow Show min cut s (570/47 bonu Desgn an algorithm whose input is a ist of n poes, run in Ofn)t
et NV,E] be a capacitated directed network with unique fixed source and unique fixed sink, no edges into the source, and no edges out of the sink. To eadh vertex u,e V, assign a number μj equal to 0 or-1. To each edge (Unuj)e E, assign a number yy defined by yy -max (0, H, - Hj). (See the discussion immediately preceding Example 10.) a. Prove that-t +pj + yi,2 0 for all i and j. b. Prove that yy...
Find the minimum flow from source A to sink F 3 3 2
You are given a flow network G with n >4 vertices. Besides the source sand the sink t, you are also given two other special vertices u and v belonging to G. Describe an algorithm which finds a cut of the smallest possible capacity among all cuts in which vertex u is at the same side of the cut as the sources and vertex v is at the same side as sink t. Hint: it is enough to ad two...
5 Network Flow, 90p. Consider the below flow network, with s the source and t the sink. 5 4 1. (10p) Draw a flow with value 8. (You may write it on top of the edges in the graph above, or draw a new graph.) You are not required to show how you construct the flow (though it may help you to apply say the Edmonds-Karp algorithm). 2. (5p) List a cut with capacity 8. (You may draw it in...
4. Use Ford-Fulkerson algorithm to find the maximum flow from source node 0 to the sink node 5 in the following network.
graph below represents a network and the capacities are the sumber written on edges. The source is node a, and the target is node h. a. 10 (e) Show a fow of size 7 units going from the source a to the target h. (Write on the graph, next to the capacity, how many units of flow go through each edge.) (b) Consider the cut (L, R), wbere L (o) and R-(d.e.cf.s.Al, Indicate the edges crosig show that this cut...
4) Consider the network flow graph below, where each arc is labeled with the maximum capacity of that link in the flow network. A 25C 15 - 10,- -* YD 15 35 20 40 10 X 2 (a) Use the Ford-Fulkerson Algorithm to determine the maximum total flow from source to sink in this network. Start with the path s B DA Ct and list (in order) the remaining paths added and the total flow after each path is added....
A Carnot heat engine has a source at 1000 °C and sink at 200 °C. If the source supplies 7200 kJ/min of heat, how much heat is rejected to the sink? O A 56.76 kW O B.24 kW O C. 18.85 kW OD. 44.58 kW