Question

nput summing amplifier circuit has R,-10 ?? at its input l and R2-20 ?? at its input 2. The feedback resistor R,-40 ?? and assume that the Op-Amp saturates at ±12 V (a) Draw the circuit and derive the expression for the output voltage V, in terms of the input voltages V1 and V2 for linear operation. (b) Using the expression derived in part (a) and/or saturation characteristics, whichever is applicable, calculate the output for the following pair of input voltages (V, V2) and in each case state whether in linear or saturation:
0 0
Add a comment Improve this question Transcribed image text
Answer #1

R) RA- uok (42v)inear Vo -(2)-2 (3) 6

Add a comment
Know the answer?
Add Answer to:
nput summing amplifier circuit has R,-10 ?? at its input l and R2-20 ?? at its...
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for? Ask your own homework help question. Our experts will answer your question WITHIN MINUTES for Free.
Similar Homework Help Questions
  • Find the output voltage Vo as an expression in terms of the input sources Vi, v2,...

    Find the output voltage Vo as an expression in terms of the input sources Vi, v2, v3, and the resistance R in the following op-amp circuit. 3. Ri Vy R: 4. In the following two stage op-amp circuit, find the output voltage Vo as an expression in terms of the input voltages v1, v2 and resistor values R1, R2, R3, and R4. R2 R ウー+

  • 4.0 First Circuit. The summing junction circuit Figure 2-4 below is the circuit for summing two...

    4.0 First Circuit. The summing junction circuit Figure 2-4 below is the circuit for summing two voltages, V, and V. The required components are an op-amp and resistors. Although the voltage are summed, the final summation is negative (I hope your experiment will prove this). This is what is called inverting op amp configuration. Nonetheless, the circuit sums Iwo voltages and is called summing circuit. 159 Tokom M Olhas -15 -IV ISV TOXO RA w 10km Vout 15V -ISV Figure...

  • 2. Consider this non-inverting op-amp amplifier This non-inverting amplifier circuit uses an operational amplifier as a...

    2. Consider this non-inverting op-amp amplifier This non-inverting amplifier circuit uses an operational amplifier as a building block. Do around. The op-amp's gain is a "little a"), but the overall amplifier's gain is A Cbig A. Derive the value of the output voltage, ve, as a function of the input voltage not confuse the non-inverting amplifier with the operational amplifier that it is built a. and the op-amp's gain a. What is the overall amplifier's gain Avo/v? (20pts) b. We...

  • Part C - Saturation of a summing op amp circuit For the circuit shown(Figure 2), determine...

    Part C - Saturation of a summing op amp circuit For the circuit shown(Figure 2), determine the range (i.e., maximum and minimum values) of V1V1 such that the op amp operates in the linear region. Assume that R1 = 5.0 kΩ , R2 = 8.2 kΩ , R3 = 8.2 kΩ , RF = 180 kΩ , V2 = 10 mV, V3 = 60 mV , and VCC = 15 V . Express your answer to three significant figures separated...

  • Learning Goal: To analyze op amps that sum different input voltages. Before proceeding, review summing op...

    Learning Goal: To analyze op amps that sum different input voltages. Before proceeding, review summing op amp circuits and the ideal op amp assumptions. Figure 1 of 1 Review Part A - Calculating the output voltage of a summing op amp circuit For the circuit shown(Figure 1). determine V, when R1 = 3.4 kN, R2 = 5.0 kN. R3 = 7.0 kN Rp = 100 kn. Vi = 20 mV, V = 50 mV V3 = 280 mV and Voc...

  • 7.) In the in the cascaded summing / inverting / noninverting operational amplifier circuit shown in...

    7.) In the in the cascaded summing / inverting / noninverting operational amplifier circuit shown in Figure 7, find the output AC signal voltages V1 V2 V3 and Vo. The values of input AC signal voltages Vsi, Vs2 and V sa are -0.25 V, 0.40 V and 0.80 V, respectively. (160 pts) V1 = V2 = Vos V3 = vatior Bom Differential ations 2010 - 40kr End of her Four $ 231 Tigue ? or Arp Cirenit , take have...

  • Laboratory 1: operation amplifier characteristics A. Objectives: 1. To study the basic characteri...

    thanks Laboratory 1: operation amplifier characteristics A. Objectives: 1. To study the basic characteristics of an operational amplifier 2. To study the bias circuit of an operational amplifier B. Apparatus: 1. DC Power supply 2. Experimental board and corresponding components 3. Electronic calculator (prepared by students) 4. Digital camera (prepared by students for photo taking of the experimental results) 5. Laptop computer with the software PicoScope 6 and Microsoft Word installed. 6. PicoScope PC Oscilloscope and its accessories. 7. Multimeter...

  • 3. (10 pts) Draw a summing op amp circuit with two inputs, v, and v. The...

    3. (10 pts) Draw a summing op amp circuit with two inputs, v, and v. The first input should have a gain of-5, and the second should have a gain of -2. You can use as many resistors as you want, but they must be 1kW resistors. (5) If we assume the positive and negative supplies to the op amp are +10 V and -5 V respectively, what values of input voltages (v and v) will keep the circuit in...

  • QUESTION 6 In an inverting summing amplifier circuit, two inputs are given (check here to show):...

    QUESTION 6 In an inverting summing amplifier circuit, two inputs are given (check here to show): V1 peak - 2.0 V (square) and V2peak = 1.0 V (triangle) at 500 Hz Draw one cycle of V1, V2 and Vout on the V-t graph paper (here) when R1 - R2. After complete your drawings, write your name on the graph, take a photo or save it to a jpg file and submit below Attach File Browse My Computer Browse Content Collection...

  • A. (10 pts) Implement the voltage amplifier shown below using an ideal op amp circuit. You have o...

    a. (10 pts) Implement the voltage amplifier shown below using an ideal op amp circuit. You have one op amp available for this circuit, and a range of resistors with values from 1 kΩ to 100 ka. Draw the schematic of your op amp circuit, labeling resistor values. Make sure the gain, input resistance, and output resistance of your circuit matches the model in the schematic. R=012 *100v, RL 100 b. (5 pts) Your amplifier circuit should have a frequency...

ADVERTISEMENT
Free Homework Help App
Download From Google Play
Scan Your Homework
to Get Instant Free Answers
Need Online Homework Help?
Ask a Question
Get Answers For Free
Most questions answered within 3 hours.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT