A liquid at 10◦C rises to a height of 20 mm in a 0.4 mm glass...
A liquid at 10◦C rises to a height of 20 mm in a 0.4 mm glass tube. The angle of contact is 45◦ . Determine the surface tension of the liquid if its density is 1, 200 kg/m3
Homework Answers
fluid mechanic
1. A 1.2-mm diameter tube is inserted into an unknown liquid whose density is 960kg/m3, and it is observed that the liquid rises 5-mm in the tube, making a contact angle of 15º. Determine: (i) The surface tension of the liquid; and (ii) The capillary rise of the liquid, if the liquid is kerosene with surface tension 0.028 N/m and density is 820 kg/m3.
A device for sampling water in lakes and streams consists of a 2.25 cm diameter cylindrical tube ...
A device for sampling water in lakes and streams consists of a 2.25 cm diameter cylindrical tube that is 3 cm in length. The disks are placed in a wan technician to insert the sampling disk into the water. The tubes are then sealed in a container and taken back to the lab where the water is removed from the tube and analyzed. The tube is made of glass and contains 200 cylindrical pores 1 mm in diameter that run...
4. 5 points A device for sampling water in lakes and streams consists of a 2.25 cm diameter cylin...
4. 5 points A device for sampling water in lakes and streams consists of a 2.25 cm diameter cylindrical tube that is 3 cm in length. The disks are placed in a wand that allows the technician to insert the sampling disk into the water. The tubes are then sealed in a container and taken back to the lab where the water is removed from the tube and analyzed. The tube is made of glass and contains 200 cylindrical pores...
What is the capillary rise of ethanol in a glass tube with a 0.1 mm radius...
What is the capillary rise of ethanol in a glass tube with a 0.1 mm radius if the surface tension of ethanol is 0.032Jm2 and the density of ethanol is 0.71gcm3? Assume that the contact angle of ethanol in a glass tube is 0 degrees. Your answer should have two significant figures.
A glass tube of inside diameter 1.0 mm is dipped vertically into a container of mercury,...
A glass tube of inside diameter 1.0 mm is dipped vertically into a container of mercury, with its lower end 1 cm below the mercury surface. a) What must be the gauge pressure of the air in the tube to blow a hemispherical bubble at its lower end? (Answer: 1400 Pa) b) To what height will mercury rise in the tube if the air pressure in the tube is 3000 Pa below atmospheric? The contact angle is 140 degrees and...
An organic liquid is heated from 20°C to 40°C by hot water in a 1:1 pass...
An organic liquid is heated from 20°C to 40°C by hot water in a 1:1 pass shell-and- tube heat exchanger in counter-current flow. The inlet temperature of the water stream is 85oC and flows in the shell side. The organic liquid flows through a bundle of 200 tubes of outside diameter 21 mm with a wall thickness of 2 mm. The flows of the organic liquid and water are 40 kg s and 15 kg s1, respectively (a) Calculate the...
Two fluids have the same contact angle with glass. The density of fluid 1 is larger...
Two fluids have the same contact angle with glass. The density of fluid 1 is larger than the density of fluid 2 . (ρ1 = 1.3 ρ2) The surface tension of fluid 1 is larger than that of fluid 2. (γ1 = 1.81 γ2) Find the ratio h1/h2 of the heights to which a liquid will rise through capillary action in the same capillary tube.
A mercury thermometer consists of a 0.4-mm capillary tube connected to a glass bulb. The mercury...
A mercury thermometer consists of a 0.4-mm capillary tube connected to a glass bulb. The mercury rises 7.5 cm as the temperature of the thermometer increases from 35°C to 43°C. Find the volume of the thermometer bulb.
Milk is poured into a glass of height 150 mm and inside diameter 70 mm. If...
Milk is poured into a glass of height 150 mm and inside diameter 70 mm. If the initial velocity of the milk is 0.8 m/s at an angle of 45° with the horizontal, determine: (a) the range of values of the height h for which the milk will enter the glass, and (b) the velocity and acceleration of the milk when x 80 mm (make sure to indicate clearly magnitude and direction for each of these two quantities) 45° 100...
I need the best solution for these 2 questions on the section " Check your learning"...
I need the best solution for these 2 questions on the
section " Check your learning" (10.4 and 10.5) to prepare my exam in class.
Thank you so much for helping me
Y althlon tai sok Translate Gm arch this book O Back Figure 10.20 Depending upon the relative strengths of adhesive and cohesive forces, a liquid may rise (such as water) or fall (such as mercury) in a glass capillary tube. The extent of the rise (or falt is...
A device for sampling water in lakes and streams consists of a 2.25 cm diameter cylindrical tube that is 3 cm in length. The disks are placed in a wan technician to insert the sampling disk into the water. The tubes are then sealed in a container and taken back to the lab where the water is removed from the tube and analyzed. The tube is made of glass and contains 200 cylindrical pores 1 mm in diameter that run...
4. 5 points A device for sampling water in lakes and streams consists of a 2.25 cm diameter cylindrical tube that is 3 cm in length. The disks are placed in a wand that allows the technician to insert the sampling disk into the water. The tubes are then sealed in a container and taken back to the lab where the water is removed from the tube and analyzed. The tube is made of glass and contains 200 cylindrical pores...
An organic liquid is heated from 20°C to 40°C by hot water in a 1:1 pass shell-and- tube heat exchanger in counter-current flow. The inlet temperature of the water stream is 85oC and flows in the shell side. The organic liquid flows through a bundle of 200 tubes of outside diameter 21 mm with a wall thickness of 2 mm. The flows of the organic liquid and water are 40 kg s and 15 kg s1, respectively (a) Calculate the...
Milk is poured into a glass of height 150 mm and inside diameter 70 mm. If the initial velocity of the milk is 0.8 m/s at an angle of 45° with the horizontal, determine: (a) the range of values of the height h for which the milk will enter the glass, and (b) the velocity and acceleration of the milk when x 80 mm (make sure to indicate clearly magnitude and direction for each of these two quantities) 45° 100...
I need the best solution for these 2 questions on the
section " Check your learning" (10.4 and 10.5) to prepare my exam in class.
Thank you so much for helping me
Y althlon tai sok Translate Gm arch this book O Back Figure 10.20 Depending upon the relative strengths of adhesive and cohesive forces, a liquid may rise (such as water) or fall (such as mercury) in a glass capillary tube. The extent of the rise (or falt is...
Most questions answered within 3 hours.
-
1-Write an algorithm to get two numbers from the user (as
inputs) and calculate the sum...
asked 3 hours ago -
Define white-collar crime. What is the difference between
offender and offense-based definitions of white-collar crime? What...
asked 3 hours ago -
Consider a reaction which is 1st order with respect to A and 1st
order with respect...
asked 3 hours ago -
c++
The length of the hypotenuse of a right-angled triangle is the
square root of the...
asked 4 hours ago -
When a metal rod is heated, not only its resistance but also its
length and cross‐sectional...
asked 4 hours ago -
write a c++ program that computes the L^1 - Norm of a given
vector (L^1 norm...
asked 4 hours ago -
A manufacturer of banana chips would like to know whether its
bag filling machine works correctly...
asked 4 hours ago -
Complete the chapter case, "Turnover Analysis".
Chapter Case
Turnover Analysis
You recently completed your company’s new...
asked 4 hours ago -
What is the pH of solutions having the following H3O+
concentrations? Identify each as acidic, basic,...
asked 4 hours ago -
How does over-voltage of the diode usually occur?
asked 4 hours ago -
If you step on a dirty nail, your doctor will recommend you
update your Tetanus vaccination....
asked 4 hours ago -
Suppose that decreases in the price of milk lead to decrease s
in the retail prices...
asked 4 hours ago