robe is mounted within a cone which is supported by a rectangular rod. The air flow...
A streetlight is approximated by a 50cm diameter sphere mounted on a (a) 0.10m diameter cylinder 2.5m long. Estimate, using the data below and stating any assumptions you make, the bending moment at the root of the cylinder due to aerodynamic forces with:- 2 winds of 6.3m/s and an air temperature of 15'C; (i) slightly stronger winds of 7m/s and an air temperature of 22'C (ii) Comment on your answers and what advice would you give with regards the (b)...
A bridge is supported by two types of rectangular cross-section piles located in a river as shown in Figure 1. The width of the piles is w - 0.5 m and their lengths are either l 2 m or 12 2.5 m. The river of depth of about 20 m runs at 2 m/s. Water density is p 1000 kg/m and its absolute viscosity 1.00 x 10-3 N.s/m2 You are asked to perform dimensional analysis to find the drag force...
A bridge is supported by two types of rectangular cross-section piles located in a river as shown in Figure 1. The width of the piles is w -0.5 m and their lengths are either lı- 2 m or l2-2.5 m. The river of depth of about 20 m runs at 2 m/s. Water density is p 1000 kg/m3 and its absolute viscosityH 1.00 x 10-3 N.s/m2. You are asked to perform dimensional analysis to find the drag force on the...
A bridge is supported by two types of rectangular cross-section piles located in a river as shown in Figure 1. The width of the piles is w 0.5 m and their lengths are eitherl 2 m or 12 2.5 m. The river of depth of about 20 m runs at 2 m/s. Water density is ρ-1000 kg/m' and its absolute viscosityH-1 .00 x 103 N.s/m2 You are asked to perform dimensional analysis to find the drag force on the piles,...
A bridge is supported by two types of rectangular cross-section piles located in a river as shown in Figure 1. The width of the piles is w = 0.5 m and their lengths are either 11-2 m or l2 2.5 m. The river of depth of about 20 m runs at 2 m/s. Water density is p 1000 kg/m3 and its absolute viscosityu- 1.00 x 10-3 N.s/m2. You are asked to perform dimensional analysis to find the drag force on...