5. A cylinder of cast iron 0.50 in in diameter by 2 in long is tested...

Question

Question

5. A cylinder of cast iron 0.50 in in diameter by 2 in long is tested in compression. Failure occurs at an axial load of 50,0

Answer 1

Answer #1

i AP 40 A8 Ag :- Area at shear plane A8 Intial Area. As = Ao Cosso = Ao sinto — АР Shear stress - on the plane of p costo = p

Answer 2

Similar Homework Help Questions

1. A 2-cm diameter gra y cast iron-class 20 solid round beam of 1-m long is...

1. A 2-cm diameter gra y cast iron-class 20 solid round beam of 1-m long is cantilevered at one end and is subjected to a 100 N load at the other end. The beam is resting on a roller support in the middle. Determine the reactions at the wall. (15 points)
2. A steel bar 100 mm long and having a square cross section 20 mm on...

2. A steel bar 100 mm long and having a square cross section 20 mm on an edge is pulled in tension with a load of 89,000 N and experiences an elongation of 0.10 mm. Assuming that the deformation is entirely elastic, calculate the elastic modulus of steel. Give your answer in GPa. 3. A zinc single crystal is being pulled in tension with the normal to its basal plane (0001) at 60° to the tensile axis and the slip...
A 5-cm-diameter shaft rotates at 4500 rpm in a 15-cm long, 8-cm-outer-diameter cast iron bearing (k...

A 5-cm-diameter shaft rotates at 4500 rpm in a 15-cm long, 8-cm-outer-diameter cast iron bearing (k =70 W/m.K) with a uniform clearance of 0.6 mm filled wwith tubricating oil (u 0.03 N.s/m2 and k 0.14 W/m.K). The bearing is cooled externally by a liquid, and its outer surface is maintained at 40°C. Disregarding heat conduction through the shaft and assuming one- dimensional heat transfer, determine (a) the rate of heat transfer to the coolant, (b) the sutacs temperature of the...

7) Which of the following is true? O The linear coefficient of thermal expansion is unique...

7) Which of the following is true? O The linear coefficient of thermal expansion is unique for each material (material property) O The displacement due to temperature is linearly related to the original length O Stress concentration factors relate the maximum stress to the average stress O Sharp corners should be avoided because they create stress concentrations. O All the above are true 8) Which of the following statements are true? O A simply supported beam which supports a load...