Homework Answers
Add Answer to:
8 Assume PLL is used for the demodulation of FM signal. Under the condition of ideal...
5. Consider the following message signal: m(t) -2 .3 10 Assume that the carrier frequency is f ar...
5. Consider the following message signal: m(t) -2 .3 10 Assume that the carrier frequency is f are kf = 105, kp-25 respectively. 108 Hz, and frequency and phase deviation constants Find the maximum and minimum frequency deviation for FM, and sketch the FM wave for a duration of 103 seconds shown in the above figure (5 points). a. b. Find the maximum and minimum frequency deviation for PM, sketch the PM wave for a duration of 103 seconds shown...
22. Given the PLL circuit shown below, calculate the minimum Vs frequency that can be captured. (5) 15V R1 5KS2 10 7 FM output 1000 p LMSSSVCO output 1.0 F R R, 4.7nF-Voc 23 Assume the PLL in pr...
22. Given the PLL circuit shown below, calculate the minimum Vs frequency that can be captured. (5) 15V R1 5KS2 10 7 FM output 1000 p LMSSSVCO output 1.0 F R R, 4.7nF-Voc 23 Assume the PLL in problem 22 is locked on to the input signal, Vs. What is the minimum frequency Vs can be reduced to and still have the PLL remain locked to it? (6)
22. Given the PLL circuit shown below, calculate the minimum Vs frequency...
Prob. 5 (a) Consider the FM signal with modulation index B 2 is passed through an ideal band-pass...
Prob. 5 (a) Consider the FM signal with modulation index B 2 is passed through an ideal band-pass filter (BPF) with mid-band frequency f and bandwidth 5f. where f is the carrier frequency and fmis the frequency of the baseband modulating signal (i) Sketch the spectrum of the BPF output. (ii) Determine the fraction of the power of the FM signal that is present at the output of the filter (b) Consider the FM signal given by фFM (t)-100 cos...
a. In FM transmission circuits, explain the purpose and function of: i. Pre-emphasis and de-emphasis circuits....
a. In FM transmission circuits, explain the purpose and function of: i. Pre-emphasis and de-emphasis circuits. (CO1: PO1 - 3 Marks) ii. Limiter circuit. (CO1: P01 - 3 Marks) b. A sinusoidal carrier wave of frequency fe = 110 MHz is modulated by a modulating signal m(t). The characteristics of the modulating signal is illustrated in Figure Q2(b) and the Frequency Deviation Constant of the FM Modulator, kf = 107 Hz/volt. Determine the minimum bandwidth required for transmission of the...
Consider a FM system that is used to communicate the following message signal: S. m(t) 20...
Consider a FM system that is used to communicate the following message signal: S. m(t) 20 0.05 0.1 015 10 -0.05 with a frequency deviation constant ky 10, and a message bandwidth of W =15 kHz the one-sided noise power-spectral density in the transmission channel is No= 10-8 W/Hz, and an attenuation of 10 is introduced during transmission in the channel as well. a. What is the average-to-peak-power ratio of the message (or, equivalently the power content of the normalized...
Consider a FM system that is used to communicate the following message signal: S. m(t) 20...
Consider a FM system that is used to communicate the following message signal: S. m(t) 20 0.05 0.1 015 10 -0.05 with a frequency deviation constant ky 10, and a message bandwidth of W =15 kHz the one-sided noise power-spectral density in the transmission channel is No= 10-8 W/Hz, and an attenuation of 10 is introduced during transmission in the channel as well. a. What is the average-to-peak-power ratio of the message (or, equivalently the power content of the normalized...
(SULIT) C. A slope detector is probably the simplest FM demodulator, however it has several disadvantages...
(SULIT) C. A slope detector is probably the simplest FM demodulator, however it has several disadvantages which include poor linearity, difficulty in tuning, and lack of provisions of limiting. Suggest the best demodulation circuit technique that can resolve those problems. Show the relevant FM demodulator circuit and explain how this suggested demodulation circuit/technique is suitable in solving such issues. (CO2: PO2 - 7 marks) d. A periodic square wave m(t) of period T, frequency modulates a carrier of frequency fc...
1. Given a baseband signal m(t) sin(1000mt) cos(3000nt) + cos(3700nt a. Sketch the spectrum of m(...
1. Given a baseband signal m(t) sin(1000mt) cos(3000nt) + cos(3700nt a. Sketch the spectrum of m(t) (Hint. sin(a) cos(b) 0.5 sin(a +b) +0.5sin a-b)) b. Sketch the spectrum of DSB-CS signal m(t)cos(10000mt) C ldentify the upper sideband {USB) and lower sideband (LSB) spectra d. Give the black diagram of the receiver to receive DSB-CS signal in (b). 2. baseband signal m(r)--0.5 + Σ..小(t-n)-u(t-0.5-n)] where ult) is the Given unit step function, an amplitude modulated signal is as SAM 107+ m(0cos...
b) The figure below shows an FM demodulator. s'(t)Envelope detector Demodulated signal s(t) Differentiator Figure 4: Question 2(b) In the system above, the differentiator performs the time-differ...
b) The figure below shows an FM demodulator. s'(t)Envelope detector Demodulated signal s(t) Differentiator Figure 4: Question 2(b) In the system above, the differentiator performs the time-differentiation operation s'(t) = as(t). Also, the envelope detector is assumed to be ideal, capable of extracting the envelope of the incoming signal perfectly. Describe, by equations, how the above FM demodulator may exactly recover the message signal from the FM signal. (6%) (c) Is the FM demodulator in Question 2(b) a coherent detector,...
TO 2, the signal m(t) 20 sinc ( 400't) is an input to a ring modulator...
TO 2, the signal m(t) 20 sinc ( 400't) is an input to a ring modulator with carrier frequency 10 fm where fm is the maximum frequency of m(t)} (a) Draw the block diagram of the used ring modulator and write down equation of the output signal of the modulator (b) Sketch spectrum of the modulated transmitted AM signal (c) Sketch the corresponding VSB AM spectrum with 25% of visitgal band relative to the other band.
TO 2, the signal...
5. Consider the following message signal: m(t) -2 .3 10 Assume that the carrier frequency is f are kf = 105, kp-25 respectively. 108 Hz, and frequency and phase deviation constants Find the maximum and minimum frequency deviation for FM, and sketch the FM wave for a duration of 103 seconds shown in the above figure (5 points). a. b. Find the maximum and minimum frequency deviation for PM, sketch the PM wave for a duration of 103 seconds shown...
22. Given the PLL circuit shown below, calculate the minimum Vs frequency that can be captured. (5) 15V R1 5KS2 10 7 FM output 1000 p LMSSSVCO output 1.0 F R R, 4.7nF-Voc 23 Assume the PLL in problem 22 is locked on to the input signal, Vs. What is the minimum frequency Vs can be reduced to and still have the PLL remain locked to it? (6)
22. Given the PLL circuit shown below, calculate the minimum Vs frequency...
Prob. 5 (a) Consider the FM signal with modulation index B 2 is passed through an ideal band-pass filter (BPF) with mid-band frequency f and bandwidth 5f. where f is the carrier frequency and fmis the frequency of the baseband modulating signal (i) Sketch the spectrum of the BPF output. (ii) Determine the fraction of the power of the FM signal that is present at the output of the filter (b) Consider the FM signal given by фFM (t)-100 cos...
a. In FM transmission circuits, explain the purpose and function of: i. Pre-emphasis and de-emphasis circuits. (CO1: PO1 - 3 Marks) ii. Limiter circuit. (CO1: P01 - 3 Marks) b. A sinusoidal carrier wave of frequency fe = 110 MHz is modulated by a modulating signal m(t). The characteristics of the modulating signal is illustrated in Figure Q2(b) and the Frequency Deviation Constant of the FM Modulator, kf = 107 Hz/volt. Determine the minimum bandwidth required for transmission of the...
Consider a FM system that is used to communicate the following message signal: S. m(t) 20 0.05 0.1 015 10 -0.05 with a frequency deviation constant ky 10, and a message bandwidth of W =15 kHz the one-sided noise power-spectral density in the transmission channel is No= 10-8 W/Hz, and an attenuation of 10 is introduced during transmission in the channel as well. a. What is the average-to-peak-power ratio of the message (or, equivalently the power content of the normalized...
Consider a FM system that is used to communicate the following message signal: S. m(t) 20 0.05 0.1 015 10 -0.05 with a frequency deviation constant ky 10, and a message bandwidth of W =15 kHz the one-sided noise power-spectral density in the transmission channel is No= 10-8 W/Hz, and an attenuation of 10 is introduced during transmission in the channel as well. a. What is the average-to-peak-power ratio of the message (or, equivalently the power content of the normalized...
(SULIT) C. A slope detector is probably the simplest FM demodulator, however it has several disadvantages which include poor linearity, difficulty in tuning, and lack of provisions of limiting. Suggest the best demodulation circuit technique that can resolve those problems. Show the relevant FM demodulator circuit and explain how this suggested demodulation circuit/technique is suitable in solving such issues. (CO2: PO2 - 7 marks) d. A periodic square wave m(t) of period T, frequency modulates a carrier of frequency fc...
1. Given a baseband signal m(t) sin(1000mt) cos(3000nt) + cos(3700nt a. Sketch the spectrum of m(t) (Hint. sin(a) cos(b) 0.5 sin(a +b) +0.5sin a-b)) b. Sketch the spectrum of DSB-CS signal m(t)cos(10000mt) C ldentify the upper sideband {USB) and lower sideband (LSB) spectra d. Give the black diagram of the receiver to receive DSB-CS signal in (b). 2. baseband signal m(r)--0.5 + Σ..小(t-n)-u(t-0.5-n)] where ult) is the Given unit step function, an amplitude modulated signal is as SAM 107+ m(0cos...
b) The figure below shows an FM demodulator. s'(t)Envelope detector Demodulated signal s(t) Differentiator Figure 4: Question 2(b) In the system above, the differentiator performs the time-differentiation operation s'(t) = as(t). Also, the envelope detector is assumed to be ideal, capable of extracting the envelope of the incoming signal perfectly. Describe, by equations, how the above FM demodulator may exactly recover the message signal from the FM signal. (6%) (c) Is the FM demodulator in Question 2(b) a coherent detector,...
TO 2, the signal m(t) 20 sinc ( 400't) is an input to a ring modulator with carrier frequency 10 fm where fm is the maximum frequency of m(t)} (a) Draw the block diagram of the used ring modulator and write down equation of the output signal of the modulator (b) Sketch spectrum of the modulated transmitted AM signal (c) Sketch the corresponding VSB AM spectrum with 25% of visitgal band relative to the other band.
TO 2, the signal...
Most questions answered within 3 hours.
-
Write a program to solve the Josephus problem, with the following
modification:
Sample Input:
./a.out n...
asked 47 minutes ago -
At the start of a CD it is spinning at a rate of 525 rpm
(revolutions...
asked 1 hour ago -
4. Without doing any calculations, predict whether the observed
∆T would increase, decrease or remain the...
asked 2 hours ago -
Based on the range, which of the following sets of scores has
the greatest variability? 3,...
asked 3 hours ago -
Ripples in a pond travel at a velocity of 3 m/s with one peak
passing a...
asked 3 hours ago -
A man stands on the roof of a building of height 13.0 mm and
throws a...
asked 3 hours ago -
The extent to which assets are financed by borrowed funds and
other liabilities is indicated by:...
asked 4 hours ago -
Explain in detail
Germany is the fifth largest economy
explain what goods and services Germany specializes...
asked 4 hours ago -
The density of platinum is 21.45 g/mL. If a cube of platinum
with a mass of...
asked 5 hours ago -
Accounts Receivable
Sales
A/R Posting
Extended Sales Invoice
Packing Slip
Compare invoice to packing slip 2...
asked 5 hours ago -
Michaella, age 23, is a full-time law student and is claimed by
her parents as a...
asked 5 hours ago -
Why are polymers not typically casted into products?
asked 5 hours ago