We need at least 10 more requests to produce the answer.
0 / 10 have requested this problem solution
The more requests, the faster the answer.
4. A 120- lossless transmission line is terminated in an impedance of-j 60. If the amplitude...
Question 4 (a) The input impedance of a lossless air-core transmission line with characteristic impedance Ro. phase constant B and length I terminated in an impedance Z, is given by R,+Z, tan( i. Determine the length of an open circuit 50Ω line required to create a 0.1 nH inductor at a frequency of 10 GHz. (6 marks) ii. Determine the input impedance of the line in part () if the open circuit is changed to a short circuit. (3 marks)...
1) A lossless transmission line that is 3N2 long with an impedance of 75Ω terminated by a load of 25 Ω The generator has a voltage of V,r-2sin(et) V and an internal impedance Ζ'50Ω (a) For this circuit give Vg, T, and the voltage standing wave ratio. (b) Give Vin. Inand Vo (c) Give and I (d) Give the voltage and current at the midpoint of the line (ie. P(z) and I(2) at z-3/4). (e) From the answer of (d)...
9.45 In a laboratory experiment conducted on a 50-(2) lossless transmission line terminated in an unknown load impedance, it is found that the standing-wave ratio is 2.0. The successive voltage minima are 25 (cm) apart, and the first minimum occurs at 5 (cm) from the load. Find (a) the load impedance, and (b) the reflection coefficient of the load, (c) Where would the first voltage minimum be located if the load were replaced by a short-circuit?
SET 1 1. A lossless transmission line of length 1-0.3? is terminated with complex load impedance ZL- 30 + j20 ? and characteristic impedance Z0-75 ?. Using formulae, calculate (7 Marks) (4 Marks) (5 Marks) (14 Marks) i. The input impedance to the line Zin in ?; The input admittance to the line Yin in S; i The distance to first minimum from the load; Use Smith Chart to all above parameters iv.
Consider a 50 Ω lossless transmission line terminated in a load impedance ?? = (100 − ?50) Ω. Find ?(?) and Γ(?) at a distance ? = 0.1λ.
For a lossless transmission line extending from 1 = -1 to 1 = 0) with characteristic impedance Zo, and terminated with a load impedance, ZL, find the ratio of the backward to forward voltage wave amplitude, V /V+.
A lossless transmission line with 50 Ω characteristic impedance has a 50 V step function placed on it, generated from a source impedance of 10 Ω. Assume the velocity of the signal on the line is 106 m/s, the line is 100 m long, and is terminated in a load impedance of 100 Ω. (a) What is the source voltage? (4 marks) (b) How long does the step function take to reach the termination load impedance? (2 marks) (c) What...
A 50-Ohm lossless air-spaced transmission line is terminated in a load. The voltage standing wave pattern on the line is measured and the resulting curve is presented in the figure. V[V] -1 -0.8 -0.6 -0.4 -0.2 0 - [m] (a) Determine the signal frequency. (b) Find the percentage of the incident power that is delivered to the load.
A source of vdr) 10./2cos(2π10,)V with internal impedance Z,-10+ j10Ω is connected via a 300m long lossless two-wire transmission line to a load of Z-100+j2002. The line parameters are D-10mm , d Imm , μ,-I,e,-4. a) Calculate the velocity and direction of propagation of the incident and reflected waves. b) Find the characteristic impedance and the input impedance of the line. c) Calculate the amplitude of the incident wave for voltage and current. d) Write the complete expressions for v(z,t)...
A lossless transmission line of electrical length l = 0.35λ is terminated in a load impedance as shown in the following figure, where ZL = 60Ω, and Z0 = 100Ω. Find: a) Relfection coefficient Γ, b) Standing wave ratio S (or VSWR), c) Input impedance Zin.