A 2300 / 230V transformer, has R1 = 4 ohm, Rc = 20 K, Xm = 15 k, R2 = 46 mOhm, X1 = 12 ohm, X2 = 110 mOhm. Which Is your Rc1 in a simplified diagram?
A) 2 Mohm
B) 200 ohm
C) 20 Kohm
D) 20.4 K
three-phase transformer is rated at 12 kV/135 kV, 100 MVA. It has the following equivalent circuit parameters (referred to the primary winding where appropriate) : • primary resistance R1 = 0.03 ohms, secondary resistance R2’ = 0.04 ohms • primary leakage reactance X1 = 0.1 ohms, secondary leakage reactance X2’ = 0.1 ohms • magnetising reactance XM = 16 ohms, core-loss resistance RC = 200 ohms. In your calculations, you should use the simplified equivalent circuit. i) The transformer is...
Bus A Bus B R1 TI ine 1 20% 80% line 2 T2 R2 110 kV 11 kV The fault is located at point F, which is 20% of the total line 2 length from Bus B Fault MVA 1524.20471 Three-phase fault level in MVA at bus A SPFL (kA) 8 MVA1 MVA2 X1 (96 X2 (96) R1 (2) R2 (Q) z' (Q) Zo (2) Rf (Q) Single phase to ground fault level (kA) at bus A Transformer 1 MVA...
Need by 12 pm July 30, 2020 with answers shown and explanation. Thank you. R 1) Two resistors are connected to each other in parallel, one resistor has a known value of R, the resistance of the second one is unknown. If the equivalent of two resistors in parallel is equal to what is the resistance of the second one? A) R B) 2R E) 4R 2) Which one of the following sentences is correct about the velocity selector? A)...