Title - Valve Spring Inspection
Conclusion - Both the valves of intake and exhaust are of same importance. Springs must be checked for squareness using a square scale and flat surface. Also the spring force must be checked as due to fatigue loading springs may loose yielding properties. Do upvote and comment for more clarification on subject matter if required.
7. Technician A says that valve springs should be kept with the valve at the time...
Technician A says that a system should be recharged with refrigerant until the condenser temperature is equal to the ambient temperature plus 100°F. Technician B says that a system should be recharged with the type and amount of refrigerant found on the vehicle's under-hood sticker. Who is correct? A. Technician A B. Technician B C. Both Technicians A and B D. Neither Technician A nor B
Technician A says that a micron gauge is a better indicator of vacuum than a gauge calibrated in inches of Hg. Technician B says that the service valve cores are normally removed before evacuating the system. Who is correct? A. Neither Technician A nor B B. Technician B C. Both Technicians A and B D. Technician A
Technician A says a refrigerant identifier is only needed when the technician is unsure of the refrigerant used in an AC system. Technician B says that some refrigerant identifiers can measure the amount of moisture in the refrigerant system to aid in diagnosis. Who is correct? A. Neither Technicians A nor B B. Both Technicians A and B C. Technician A D. Technician B
Technician A says that the airflow default setting in vehicles is defrost, because seeing out the windshield is most important. Technician B says that failure for air to flow through any but the defrost vents is likely caused by a vacuum problem. Who is correct? A. Neither Technician A nor B B. Technician B C. Technician A D. Both Technicians A and B
Technician A says that if the cooling system has been exposed to the air for more than 24 hours, the drier should be replaced Technician B says that repairs should be made before retrigerant is evacuated from a system. Who is correct? A. Neither Technician A B B. Both Technicians A and B C. Technician B D. Technician A
Two Technicians are discussing automatic transmission/transaxle oil pumps. Technician A says that vane-type pumps are positive displacement pumps. Technician B says that converter drives the pump. Which technician is correct? A. Neither Technician A nor Technician B b. Technician B only C. Technician A only D. Both Technician A and Technician B
58. (TCO 7) Technician A says a PLC enclosure should contain a power disconnect switch for physie isolation from the main power. Technician B says a programmed master control reset can also be u to achieve the same results. Who is correct? (Points : 4) O Only Technician A O Only Technician B Both Technician A and Technician B O Neither Technician A nor Technician B 59. (TCO 7) Which of the following statements is true for PLC analog input...
While testing variable resistors: Technician A says that while checking a rheostat with a voltmeter, the voltage should change smoothly with a change in the control. Technician B says that a potentionmeter can be checkedwith a scope. Who is correct? a. Tec A b. Tec B c. Both A and B. d. Neither A nor B
Technician A says that the leading shoe lining receives the greatest wear on a leading-trailing shoe brake. Technician B says that leading-trailing brakes are nonservo brakes. Who is correct? A only B only Both A and B Neither A nor B
Technician A says that a micrometer can be used to measure the outside diameter of something. Technician B says that a vernier caliper can be used to measure the inside diameter of a bore. Who is correct? a . Tec A b. Tec B. c.Both A and B. d. Neither A nor B.