Draw the sections A-A and B-B (engineering drawing cross section) (like the second photo) Section В...
Draw , Section A-A , and again draw section ,B-B ,
etc..
Drawing ang Graphics Mechanical Engineering Drawing Lecture /-Sections and Sectiona actional views - homeworx ToP Frome D D В.В A.A 이번 Front - Counter ter d Sectional views Pr Bouazizi Mohamed Lamjed
Soild Mechanics
Question 2: A beam having the cross-section shown in the drawing is loaded as shown in figure (b). The values of the Section modulus for the beam are 1.74x106 and 0.74x106 mm3 What are the extreme fiber stresses at sections B and C 300 5 kN 2 kN/m B 4.0 4.0 3.0 50 (a) (b) O02
An instructor who taught two sections of engineering statistics last term, the first with 20 students and the second with 35, decided to assign a term project. After all projects had been turned in, the instructor randomly ordered them before grading. Consider the first 16 graded projects. (a) What is the probability that exactly 10 of these are from the second section? (Round your answer to four decimal places.) (b) What is the probability that exactly 6 of these are...
1C
1C
1 Find the second moment of area and section modulus with respect to the major axis for each of the following beam cross-sections (all dimensions are in mm): (a) (b) 250 > € 13 €20 600 €10 lle 200 A 200 → DV -
6 t Stream Cross-section Note: Drawing not to scale Depth soundings are taken to approximately determine the cross section of a stream, with the data as shown. By watching a leaf float down the stream, it is determined that the velocity of the stream is approximately 1.8 m/sec. A 44 Inch diameter pipe discharges 12.1 m3/sec of water into the stream just below where the stream cross-section measurements are made. The flows from the pipe and stream combine and go...
--------------------------------------------------------------------------------------
1.(15pts) a) Sketch cross-sections for the CMOS device (NFET plus PFET) and the depletion NFET. b) Draw example Ip vs Vos (or Vsa) curve for each MOSFET sketched above. (Not the ID vs VDs) 4.(10pts) Ilustrate the noise margin principles (definition) when one inverter is driving another inverter
1.(15pts) a) Sketch cross-sections for the CMOS device (NFET plus PFET) and the depletion NFET. b) Draw example Ip vs Vos (or Vsa) curve for each MOSFET sketched above. (Not the...
Draw cross-section for each (column A & beam B) Column A (
HE240 B ), Beam B ( IPE300 )
TE COLUMNA HE 240 SHA MEX CLOTHS BEAN A PE30 YOU HE 240 B WAR Tecla ortas
The cylindrical copper pressure tank (shown in cross section)
will be produced by deep drawing.
Tensile test data of the cold rolled sheet that will be used for
the blanks provided the following
true width and thickness strains relative to the rolling
direction
a) Assuming no change in volume or thickness from the initial
blank to final product,
calculate the initial blank diameter.
b) What is the limiting draw ratio (LDR) for this material?
c) Assuming 80% of the maximum...
For the pipe system below, we assume the cross-section at A is subject to the resultant forces P 339 N and Py 448 N. The pipe gauge pressure is given by p 6 b 212 mm and c 263 mm. The circular cross-section has outer diameter do 95 mm and inner diameter d 55 mm 623 kPa. Use the dimensions a 318 mm, Py Determine the state of stress at point K: evaluate the magnitude of the stresses and draw...