GIVEN THE TOP AND RIGHT VIEWS DRAW THE MISSING VIEW SECTION NO DIMENSIONS REQUIRED. INCLUDE CENTER...
Given: The front and top views of an object.
Required: Draw the right side view and complete the bottom half
as instructed.
For part 2: Draw the right side view of surface
14,17,19,20,26.
ORTHOGRAPHIC READING GIVEN: The front and top views of an object. 10 REQUIRED: Draw the right side view and complete the bottom half as instructed. 13 14 15 16 17 18. 26 20 22 Draw the right side view of surface 14,17,19,20,26. 14 26
given the top and right side views, sketch the front view as a
full section
SECTIONA-A SECTION B-B SECTION C-C
PLEASE DRAW THIS IN AUTOCAD
TOP FRONT AND RIGHT SIDE VIEWS
INCLUDE HIDDEN AND CENTER LINES
8. Below 1.00 1.50 0.75 2.50 2 x 0.50- 1.50
Complete the following section view drawings with dimensions and
necessary views. Do not draw the pictorial views. They are shown to
assist you in visualization. Dimension views fully.
138- 118 Finish All Over: 1 um Material: Phosphor bronze Part Name: Valve Stem PROBLEM 12.34 Removed section (metric) 84 42- 19 - -09.6 09.6 038 07.88 2 4X R LEFT-SIDE VIEW 7.86 V 69.5 RIGHT-SIDE VIEW LØ28 15.06 - 59.2- 68.8 - -- 128- NOTE: Some hidden lines omitted for clarity....
Draw the front, top, and bottom views Add sufficient dimensions to fully define the geometry Model the part using Solidworks Name the part lego 4 Units mm 484,8 4.8 Do model ribs Do NOT model holes inside top of block Class #6 Hand sketch and solid model start on other side first Draw the front, top and bottom multi-view orthographic sketches Measure and add the dimensional values sufficient to model the part Model the part and name it duplo_4 Units...
sketch an isometric view given top front and right
views.
ㄚ Top, Front & the side views are given. Sketch an isometric view.
Top view
Front view. Right view
No required scale
Activity 4: Draw an isometric pictorial from the given top, front and right side view of an object. Use your engineer's pad to complete this activity. Use dimensions for proportions only .75 1.00 .75 1.00 .50 .62 25
2. Draw multiviews below (here they are top, front and right side views) as front, top and left-side view and add mising lines. Use red pencil for missing lines. And please watch the video named missing lines) that I uploaded on Ims for help. the missing line EXAMPLE 1 Soun 986622ELA DUOLE
A A-A A Drawing - redraw the given front and top views (don't draw the invisible edges and contours) and draw the section view as left side projection. Set all dimensions (dimension's numbers are measured from your drawing). Take a photo and upload it in Moodle by 15:30. Give name of your file “Name_Faculty number.jpg" (for example Elena_121314008.jpg). Later submission is not possible.
Please draw the top,front and right view for the following
isometric views.
Please don't forget to use engineering paper.