Question

Explain how the output power of a turbine-generator operating in a constant frequency system is controlled...

Explain how the output power of a turbine-generator operating in a constant


frequency system is controlled by adjusting the setting of the governor. Show the effect on the generator power-frequency curve.

0 0
Add a comment Improve this question Transcribed image text
Answer #1

solution:

please give me like..its really needed to write more questions.thanks..

avg) if you thought that the single phase arve was complex, look at the three phase power curve Pom fig. at shows the outputtwice during its cycle. It also spends about one third of Ifs time below 50% of peak voltage. Although single phane can be me

please dont forget to give like..thanks,

Add a comment
Know the answer?
Add Answer to:
Explain how the output power of a turbine-generator operating in a constant frequency system is controlled...
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for? Ask your own homework help question. Our experts will answer your question WITHIN MINUTES for Free.
Similar Homework Help Questions
  • I need help to solve this questions about Generator Governor Droop and Transmission Line. A complete...

    I need help to solve this questions about Generator Governor Droop and Transmission Line. A complete solutions with answers would be great. Thank you Generation Question 1 to 5 relate to the following grid connected generator. A governor-controlled, steam-driven 450 MW synchronous generator with 5% droop is synchronized to the 60 Hz grid and its load set-point adjusted to deliver 300 MW to the grid. Q1. (a) 000 What is the actual droop of the generating unit? 0.0225 Hz/MW (b)...

  • Air is the working fluid in a gas-turbine power system which rotates an electric generator. The...

    Air is the working fluid in a gas-turbine power system which rotates an electric generator. The system includes a compressor, a two-stage turbine and a regenerator. Air enters a compressor with a compression ratio of 16 at 14 lbf/in2 and 70°F. For each stage of the turbine, compression ratio is 8 and temperature of air entering is 2000°F. The reported isentropic efficiency for each turbine and the compressor is 85%. Regeneration system is 70% efficient. Considering specific heat capacities varying...

  • Steam-driven power generators rotate at a constant speed via a governor that maintains constant s...

    Steam-driven power generators rotate at a constant speed via a governor that maintains constant steam pressure in the turbine. In addition, automatic generation control (AGC) or load frequency control (LFC) is added to ensure reliability and consistency despite load variations or other disturbances that can affect the distribution line frequency output. A specific turbine- governor system can be described only using the block diagram below, in which G (s)- Gg (s)G(s)Gm(s), where is the governor's transfer function 0.2s+1 G.(s)s the...

  • The rated output power for a turbine model at 15 m/s is 3 MW. The rotor...

    The rated output power for a turbine model at 15 m/s is 3 MW. The rotor diameter is 90m.The rotor rotates at a constant frequency of 0.198 Hz. Please calculate the tip to speed ratio and power conversion coefficient of this mode. (5 Marks)

  • Wind turbine can be used to support the grid frequency. Let us assume, that generator rotates...

    Wind turbine can be used to support the grid frequency. Let us assume, that generator rotates at 1.360 MW power with a rotating speed 12 rpm. How long turbine can provide 2 MW power be decelerating the wind rotor speed, if the allowed speed deviation is 20 %. Assume constant aerodynamic power P = 1,360 MW during the deceleration. Total inertia of wind turbine is 4820000 kgm2. The given aerodynamic power was 1.360 MW. The requested power to the grid...

  • Steam enters the turbine of a power plant operating on the Rankine cycle at 3300 kPa...

    Steam enters the turbine of a power plant operating on the Rankine cycle at 3300 kPa and exhausts at 50 kPa. To show the effect of superheating on the performance of the cycle, calculate the thermal efficiency of the cycle and the quality of the exhaust steam from the turbine for turbine-inlet steam temperature of 550°C. The Rankine cycle is shown in the following figure: The thermal efficiency of the cycle is O The quality of the exhaust steam is...

  • Q2 A generating station for a power system consists of two synchronous generators which are operating...

    Q2 A generating station for a power system consists of two synchronous generators which are operating in parallel. The two generators are supplying a total power of 135 MW The slope of Generator 1 is 25 MW/Hz and has a non-load frequency of 52 Hz. The slope of Generator 2 is 15 MW/Hz and has a non-load frequency of 53 Hz 1. 2. Determine the system frequency. To what frequency must the non-load frequency of generator 1 be adjusted in...

  • How many kW of electricity can a turbine generator operating at a head of 100 m, with a flow of 20 m3/s deliver? Assume that the water turbine has 90% efficiency?

    How many kW of electricity can a turbine generator operating at a head of 100 m, with a flow of 20 m3/s deliver? Assume that the water turbine has 90% efficiency?

  • A 13.8 kV, 10 MVA, 0.8 pf lagging, 60 Hz two-pole star-connected steam-turbine generator has a...

    A 13.8 kV, 10 MVA, 0.8 pf lagging, 60 Hz two-pole star-connected steam-turbine generator has a synchronous reactance of 12 Ω per phase and an armature resistance of 1.5 Ω per phase. This generator is operating in parallel with a large power system (infinite bus). At the absolute maximum power possible, how much reactive power will this generator be supplying or consuming? Sketch the corresponding phasor diagram. (Assume IF is still unchanged.)

  • a. A 91.0-μF capacitor is connected to a generator operating at a low frequency. The rms...

    a. A 91.0-μF capacitor is connected to a generator operating at a low frequency. The rms voltage of the generator is 2.40 V and is constant. A fuse in series with the capacitor has negligible resistance and will burn out when the rms current reaches 11.0 A. As the generator frequency is increased, at what frequency will the fuse burn out? b. Assume that the speed of light in a vacuum has the hypothetical value of 18.0 m/s. A car...

ADVERTISEMENT
Free Homework Help App
Download From Google Play
Scan Your Homework
to Get Instant Free Answers
Need Online Homework Help?
Ask a Question
Get Answers For Free
Most questions answered within 3 hours.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT