A ship, carrying fresh water to a desert island in the Caribbean, has a horizontal cross-sectional area of 2210 m^2 at the waterline. When unloaded, the ship rises 8.30 m higher in the sea. What volume of water was delivered?
Volume of water = cross section area x height
cross section area = 2210 m^2
height = 8.30 m
Volume = 2210 x 8.30 = 18343 m^3
A ship, carrying fresh water to a desert island in the Caribbean, has a horizontal cross-sectional...
8. The fresh water intake in a reservoir has a cross-sectional area of 0.800 m2 and receives water flowing at a speed of 0.500 m/s. At the outlet, a vertical distance of 200 m below the intake, the cross-sectional area is 0.020 m. Calculate the pressure difference between the inlet and outlet. (Answer: 1.76 x 10 Pa)
An oscillating water column has an air duct of cross-sectional area 1 m2 and a water duct of cross-sectional area 10 m². If the average speed of the water is 1 m/s calculate the average speed of the air. Concrete A Turbine Structure Air column Wave trough Shoreline Sea
4. (10 pts) Fresh water flows through the pipe configuration sectional area of 5.06 cm, is connected to Pipe B, with a cross ws through the pipe configuration below. Pipe A, with a cross- cm, is connected to Pipe B, with a cross-sectional area of 1.26 cm', all on Le same horizontal level. Fill out the missing information on the table below. The pressure gauge on Pipe A reads 2.07x103 Pa with a flow ate of 1.64x10-4 m
Water is flowing in a straight horizontal pipe of variable cross section. Where the cross-sectional area of the pipe is 3.70·10-2 m2, the pressure is 8.10·105 Pa and the velocity is 0.660 m/s. In a constricted region where the area is 16.90·10-4 m2, what is the velocity? Tries 0/15 What is the pressure (in Pa)? (Assume an ideal fluid)
A ship has a length of 150m and wetted area of 3000m2.A model of this ship 5m in length when towed in fresh water at 2m/s produces a resistance of 39.24N.The ship surface has skin resistance of 49.05 N/m2 at a velocity of 3 m/s and the velocity index is 1.85.the corresponding values for the model surface towed in fresh water are respectively 16.38N/m2,3m/s and 1.90. calculate: (1).The corresponding speed of ship (2).The shaft power required to propel the ship...
A liquid of density 830 kg/m3 flows through a horizontal pipe that has a cross-sectional area of 2.50 x 10-2 m2 in region A and a cross-sectional area of 9.20 x 10-2 m2 in region B. The pressure difference between the two regions is 6.80 x 103 Pa. What are (a) the volume flow rate and (b) the mass flow rate?
A liquid of density 930 kg/m3 flows through a horizontal pipe that has a cross-sectional area of 2.90 x 10-2 m2 in region A and a cross-sectional area of 9.90 x 10-2 m2 in region B. The pressure difference between the two regions is 7.40 x 103 Pa. What are (a) the volume flow rate and (b) the mass flow rate?
A container of water has a cross-sectional area of A = 0.1 m^2. A piston sits on top of the water (see the following figure). There is a spout located 0.15 m from the bottom of the tank, open to the atmosphere, and a stream of water exits the spout. The cross sectional area of the spout is A_s = 7.0 times 10^-4 m^2. (a) What is the velocity of the water as it leaves the spout? (b) If the...
A water intake at a pump storage reservoir (the figure) has a cross-sectional area of 0.642 m. The water flows in at a speed of 0.480 m/s. At the generator building, at distance D = 119 m below the intake point, the cross-sectional area is smaller than at the intake and the water flows out at 9.67 m/s. What is the difference in pressure between inlet and outlet? Revivir Generator building Outlet Number units
Groundwater Let us assume that the water table on the island is 2 m above sea level. Then, t 2 m, so 2 m/0.03-h 66.67 m. Thus we can predict that if we drill a hole on the island we would not come to salty groundwater for approximately 67+ 2 meters, or about 69 m from the top of the water table. This would be 67 m below sea level. a] Suppose you found a place on the island where...