Homework Answers
Add Answer to:
Q1) Inner surface of a side wall is used for heating of ambient-room air as shown...
1. Consider an opaque, horizontal square plate (Im by 1m) with an electrical heater on its backside. The front side is exposed to ambient quiescent air that is at 20° C, solar irradiation (from...
1. Consider an opaque, horizontal square plate (Im by 1m) with an electrical heater on its backside. The front side is exposed to ambient quiescent air that is at 20° C, solar irradiation (from sun at 5800° K) of 600 W/m2, and an effective sky temperature of -40° C. The plate surface temperature is kept at Ts 60 C (at steady state condition). Calculate natural convection heat transfer coefficient from the plate. (10 points) What is the electrical power (W/m2)...
A 50 mm thick steel plate (AISI347) has a uniform heat flux applied to its bottom...
A 50 mm thick steel plate (AISI347) has a uniform heat flux
applied to its bottom surface by a heater. The heater is in contact
with the steel plate, and the interface between the heater and
steel has a contact resistance of 2.0 x 10-4
m2*K/W. The top surface of the plate is exposed to
surrounding air (T = 20oC, h = 10 W/m2*K) and
exchanges radiation with surroundings at Tsur =
10oC. The emissivity of the plate is 0.85....
NE Steel tubes (k =35 W/m2.K) of 400-mm inner diameter and 30-mm wall thickness are used...
NE Steel tubes (k =35 W/m2.K) of 400-mm inner diameter and 30-mm wall thickness are used to route superheated steam from the boller to the turbine in a power plant. Safety and economic concerns make it practical to add a 200-mm layer of Insulation (k =0.1 W/mK) to each tube, which is wrapped in a thin sheet of aluminum with an emissivity e =0.15. The air (with a convective coefficient h =5 W/m2K) and wail temperatures of the plant are...
2. An aluminum cylinder has a radius (ra) of 3 cm and al n cylinder has...
2. An aluminum cylinder has a radius (ra) of 3 cm and al n cylinder has a radius (11) of 3 cm and a length (L) of 10 cm. The cylinder is covered with an additional insulation laver which has the critical insulation thickness The insulation surface is exposed to ambient air with the convection heat trans coefficient of h = 5 W/m2.°C. The surface temperature (T1) of aluminum cylinder is 100 The ambient air temperature (T..) is 25 °C....
Problem Wall with Strip Heater The air inside a chamber is measured to be 50C and used to convectively heat a wall (h 2...
Problem Wall with Strip Heater The air inside a chamber is measured to be 50C and used to convectively heat a wall (h 20 w/m2 K). The wall (thermal conductivity of 4 W/m K) is 200 mm thick and has a uniform heat generation of 1000 W/m2. To prevent any heat generated within the wall from being lost to the outside of the chamber a very thin electrical strip heater is placed on the outer wall to provide a uniform...
IF YOU CANNOT SOLVE THEM ALL THEN PLEASE DONT SOLVE ANY. A hollow aluminum sphere, with...
IF YOU CANNOT SOLVE THEM ALL THEN PLEASE DONT SOLVE ANY.
A hollow aluminum sphere, with an electrical heater in the center, is used in tests to determine the thermal conductivity of insulating materials. The inner and outer radii of the sphere are 0.15 and 0.18 m, respectively, and testing is done under steady-state conditions with the inner surface of the aluminum maintained at 250°C. In a particular test, a spherical shell of insulation is cast on the outer surface...
(b) The brick wall of a building has dimensions of 4 m by 10 m, and it is 15 cm thick with a coefficient of thermal con...
(b) The brick wall of a building has dimensions of 4 m by 10 m, and it is 15 cm thick with a coefficient of thermal conductivity of 0.8 W.m1ec1. How much heat flows through the wall in a 12-hour period when the average inside and outside temperatures are 20 °C and 5 °C respectively? Will a 2 kW heater operating in the room compensate for the heat loss? Justify your answer. A layer of insulating material of thickness 5...
A dormitory at a large university, built 50 years ago, has exterior walls constructed of L,...
A dormitory at a large university, built 50 years ago, has exterior walls constructed of L, = 25-mm-thick sheathing with a thermal conductivity of k, = 0.1 W/m K. To reduce heat losses in the winter, the university decides to encapsulate the entire dormitory by applying an L = 25-mm-thick layer of extruded insulation characterized by kı = 0.029 W/m K to the exterior of the original sheathing. The extruded insulation is, in turn, covered with an L = 5-mm-thick...
The room shown in Figure 1 has a heater with heat flow rate input of q0. The thermal capacitances of the heater and the...
The room shown in Figure 1 has a heater with heat flow rate
input of q0. The thermal capacitances of the heater and the room
air are C1 and C2, respectively. The thermal resistances of the
heater–air interface and the room wall–ambient air interface are R1
and R2, respectively. The temperatures of the heater and the room
air are T1 and T2, respectively. The temperature outside the room
is T0, which is assumed to be constant.
a. Draw the circuit...
please help me ASAP 2. [10] COI A steel tube (ks - 43.26 W/mK) of 5.08...
please help me ASAP
2. [10] COI A steel tube (ks - 43.26 W/mK) of 5.08 cm inner diameter and 7.62 em outer diameter is covered with 2.5 cm layer of insulation (k, -0.208 W/mK) the inside surface of the tube receivers heat from a hot gas at the temperature of 316°C with heat transfer co-efficient of 28 W/mK. While the outer surface exposed to the ambient air at 30°C with heat transfer co- efficient of 17 W/mK. Calculate heat...
1. Consider an opaque, horizontal square plate (Im by 1m) with an electrical heater on its backside. The front side is exposed to ambient quiescent air that is at 20° C, solar irradiation (from sun at 5800° K) of 600 W/m2, and an effective sky temperature of -40° C. The plate surface temperature is kept at Ts 60 C (at steady state condition). Calculate natural convection heat transfer coefficient from the plate. (10 points) What is the electrical power (W/m2)...
A 50 mm thick steel plate (AISI347) has a uniform heat flux
applied to its bottom surface by a heater. The heater is in contact
with the steel plate, and the interface between the heater and
steel has a contact resistance of 2.0 x 10-4
m2*K/W. The top surface of the plate is exposed to
surrounding air (T = 20oC, h = 10 W/m2*K) and
exchanges radiation with surroundings at Tsur =
10oC. The emissivity of the plate is 0.85....
NE Steel tubes (k =35 W/m2.K) of 400-mm inner diameter and 30-mm wall thickness are used to route superheated steam from the boller to the turbine in a power plant. Safety and economic concerns make it practical to add a 200-mm layer of Insulation (k =0.1 W/mK) to each tube, which is wrapped in a thin sheet of aluminum with an emissivity e =0.15. The air (with a convective coefficient h =5 W/m2K) and wail temperatures of the plant are...
2. An aluminum cylinder has a radius (ra) of 3 cm and al n cylinder has a radius (11) of 3 cm and a length (L) of 10 cm. The cylinder is covered with an additional insulation laver which has the critical insulation thickness The insulation surface is exposed to ambient air with the convection heat trans coefficient of h = 5 W/m2.°C. The surface temperature (T1) of aluminum cylinder is 100 The ambient air temperature (T..) is 25 °C....
Problem Wall with Strip Heater The air inside a chamber is measured to be 50C and used to convectively heat a wall (h 20 w/m2 K). The wall (thermal conductivity of 4 W/m K) is 200 mm thick and has a uniform heat generation of 1000 W/m2. To prevent any heat generated within the wall from being lost to the outside of the chamber a very thin electrical strip heater is placed on the outer wall to provide a uniform...
IF YOU CANNOT SOLVE THEM ALL THEN PLEASE DONT SOLVE ANY.
A hollow aluminum sphere, with an electrical heater in the center, is used in tests to determine the thermal conductivity of insulating materials. The inner and outer radii of the sphere are 0.15 and 0.18 m, respectively, and testing is done under steady-state conditions with the inner surface of the aluminum maintained at 250°C. In a particular test, a spherical shell of insulation is cast on the outer surface...
(b) The brick wall of a building has dimensions of 4 m by 10 m, and it is 15 cm thick with a coefficient of thermal conductivity of 0.8 W.m1ec1. How much heat flows through the wall in a 12-hour period when the average inside and outside temperatures are 20 °C and 5 °C respectively? Will a 2 kW heater operating in the room compensate for the heat loss? Justify your answer. A layer of insulating material of thickness 5...
A dormitory at a large university, built 50 years ago, has exterior walls constructed of L, = 25-mm-thick sheathing with a thermal conductivity of k, = 0.1 W/m K. To reduce heat losses in the winter, the university decides to encapsulate the entire dormitory by applying an L = 25-mm-thick layer of extruded insulation characterized by kı = 0.029 W/m K to the exterior of the original sheathing. The extruded insulation is, in turn, covered with an L = 5-mm-thick...
The room shown in Figure 1 has a heater with heat flow rate
input of q0. The thermal capacitances of the heater and the room
air are C1 and C2, respectively. The thermal resistances of the
heater–air interface and the room wall–ambient air interface are R1
and R2, respectively. The temperatures of the heater and the room
air are T1 and T2, respectively. The temperature outside the room
is T0, which is assumed to be constant.
a. Draw the circuit...
please help me ASAP
2. [10] COI A steel tube (ks - 43.26 W/mK) of 5.08 cm inner diameter and 7.62 em outer diameter is covered with 2.5 cm layer of insulation (k, -0.208 W/mK) the inside surface of the tube receivers heat from a hot gas at the temperature of 316°C with heat transfer co-efficient of 28 W/mK. While the outer surface exposed to the ambient air at 30°C with heat transfer co- efficient of 17 W/mK. Calculate heat...
Most questions answered within 3 hours.
-
Complete and balance the following reactions. In case of no
reaction occurring write NR.
Mix #1:...
asked 4 minutes ago -
If an economy consumes 75% of any increase in income, then an
increase in autonomous investment...
asked 7 minutes ago -
A shotputter throws the shot with an initial speed of 15.8 m/s
at a 38.0 ∘...
asked 23 minutes ago -
Debra and Merina sell electronic equipment and supplies through
their partnership. They wish to expand their...
asked 24 minutes ago -
How does a linear regression allow you to better estimate
trends, costs, and other factors in...
asked 32 minutes ago -
1. (15%) Describe the difference between a pull (Kanban), push
and CONWIP production systems.
asked 28 minutes ago -
QUESTION 5
The total area under the Z distribution curve is equal to:
a.
10
b....
asked 37 minutes ago -
Using Python
The variables x and y refer to numbers. Write a code segment
that prompts...
asked 51 minutes ago -
If
the coefficient of static friction between a box and the floor is
0.35 with what...
asked 53 minutes ago -
A die is designed to punch holes with a radius of 1.08 10-2 m in
a...
asked 58 minutes ago -
government can increase import through
a. export subsidies
b. tax breaks
c. increase import tax
d....
asked 58 minutes ago -
Draw the following in the proper skeletal structure or line
angle formula.
5,6,6-tribromo-3,8-dicyclopropyl-7-isopentyldodecane
asked 1 hour ago