Q1 a) Define ultimate tensile strength. b) Define yield poin c) Define yield strength and tell...
If my material has an ultimate tensile strength of 52 KSU, yield strength of 35 ksi, elastic modulus of 6.5 msi, and a poisssons ratio of 0.33. What is the maximum force that can be reached till failure?
A shaft is to be manufactured from a steel having an ultimate tensile strength of 420 MPa, and a yield stress of 305 MPa. The shaft has a solid circular cross section of diameter 50 mm and is subjected to a sinusoidally varying torque ranging from 60 Nm to 130 Nm. It has also been established that the shaft has a fully-corrected endurance limit of 129 MPa and that a torsional fatigue stress concentration factor, kf = 2.1, exists at...
(20%) Question 6. The elastic modulus, yield strength and ultimate strength of a certain material afe 110 GPa 2400 MPa and 265 MPal respectively. If a cylindrical bar of this material 380 mm long is subjected to a uniaxial tension test and its length is increased by an amount áf O.50 mm under a tensile load ót 6660 N.At the same time its diameter decreased by0,28 mm Calculate; a) The initial diameter of the bar, (8%) d b) Under an...
5. A metal has a modulus of elasticity of 70 GPa, yield strength of 210 MPa, Poisson's ratio 0.33 and an area of cross section of 9 mm? A. Calculate the area of cross section when a tensile stress of 140 MPa is applied on this metal (6 points) B. In a new experiment, a stress of 280 MPa is applied on this metal. Then the stress is completely removed. Again a stress of 350 MPa is applied. Then this...
Some general Material Properties: Materia Elastic Modulus Poisson's ratio Yield Strength Density and std deviat. 330 MPa la- 16.5 Mpa - 190 MPa: la-30.0 Mpa 414 MPa; 1a-40.0 Mpa 2024-T4 E- 70 GPa H0.30 2800 kg/m T6 E- 69 GPa H-0.30 -2700 kgm 1040 carbon Steel E-200 GPA H-0.33 7850 kg 4130 c steel hrome-molyE-200 GPA 655 Mpa -60.0 MPa 800 MPa l-40.0 Mpa 1260 MPa m-0.30 -7850 kg/m E- 100 GPA m-0.33 -4500 kg/m tanium Graphite Fiber E- 224...
Problem #1 A cylindrical rod of copper (E 110 GPa) having a yield strength of 240 MPa is to be subjected to a load of 6660 N. If the length of the rod is 380 mm, what must the diameter be to allow an elongation of 0.50 mm? A cylindrical specimen of some alloy 8 mm in diameter is stressed elastically in tension. A force of 15,700 N produces a reduction in the specimen diameter of 5 10-3 mm. Compute...
1-Determine the % elongation, yield stress and ultimate tensile strength of the material tested above 2-Calculate the elastic modulus of the material tested above 3-If a 200mm cylindrical rod of the material tested above, with radius 20mm, was subjected to a tensile load of 200kN, what would the length be? 4-An underground wastewater steel pipe with 2mm walls carries an ammonia solution of 40 g/m3. The pipe is in contact with groundwater (assume 0 g/m3 ammonia). Determine the diffusion rate...