Water is being pumped from reservoir A to reservoir F through a 30-m long PVC pipe...
Q3 (40 pts): Water is pumped through a 60-m-long, 0.3-m-diameter pipe from a lower reservoir to a higher reservoir, which has a water surface 10 m above the lower one. When the pump adds 40 kW to the water the flowrate is 0.20 m/s. Assume the following coefficients of minor losses: • Entrance: Kentrance = 0.5 Exit: Kexit = 1 Each elbow: Kelbow = 1.5 • Valve: K= 6 Part A (20 pts) Determine the pipe roughness ε. Part B...
NO QUESTIONS DURING T Water is to be pumped from a reservoir (ZA30 /s- to another reservoir at a higher elevati rate of elevation (Zn THE EXAM! n) through a long pipe, as shown in the figure at a volume ow olume flow rate has been calculated and is 11 m he head loss in the pipe at this usefuf pump ) Demostrate that wh en a pump moves a fluid from one reservoir to ano e elevation difference between...
1. Water is pumped from a low reservoir to a high reservoir that is 20 m higher in elevation. The water is flowing at 1.5 m/s through a 305 mm internal diameter piping system. The water is at 18 degrees C. There are 1,000 m of piping, six standard 45 degree bends, two standard 90 degree bends, a branch flow tee, three gate valves, a swing check valve, a square inlet and a square outlet. The piping and valves are...
Task 1: You were asked to check up the status of the water system. Water at 24 °C is to be pumped from a Lower reservoir with 100 m elevation to another reservoir at a higher elevation 112 m through 150-m-long pipe as shown in Figure (1). The pipe is made of steel, and the diameter of the pipe is equal to 30 cm. Water is to be pumped by a 72% efficient motor-pump combination that draws 33 A of...
Water is being pumped from a lower reservoir to an elevated tank as shown below. The pump is 80% efficient and rated at 200 kW. Determine the flow rate if the total head loss from point 1 to point 2 is 15 m. elev. 100 m 150-mm diameter pipe pump 180-mm diameter pipe elev. 50 m water
Water Flows from reservoir A to a straight pipe through a protrunding pipe entrance, and then enters reservoir B. The velocity head of the pipe flow is 1.6ft. Calculate Minor loss from A to B
[14] 5. As shown below, water is to be discharged from a large reservoir through a horizontal section of cast iron pipe containing a pump and an open globe valve. The outflow from the pipe will be to the atmosphere. Not to scale K 10 reservoir30.0m Pump a 0.018 m2/s L 20 m L-35 m D 0.06 m e 0.26 mm Ke 0.5 D 0.06 m e = 0.26 mm [10 a) Considering all minor losses, determine the head the...
Water (density 998 kg/m', absolute viscosity 1.12x10 Ns/m2) is pumped from a lake into a reservoir at a rate of 0.7 m/s. The water flows through a re-entrant opening, a valve, and a sharp-edged exit, which have loss coefficients of 0.8, 10, and 1, respectively. The pipe has an absolute roughness of 1x104m and di of 0.30 m. The pump efficiency is 65%. A) Is the flow in the pipe laminar or turbulent? (2 points) B) What is the power...
4. Water is pumped from a supply reservoir to a water transmission line (ks0.07 mm) as shown below. The highest point of the transmission line is at point A, located 0.5 km (pipe length) downstream of the supply reservoir, and the lowest point of the transmission line is at point B, located 0.25 km (piple length) downstream of point A If the flow rate through the pipeline is 1.1 m3/s, the diameter of the pipe is 700 mm, and the...
you can skip task 1 (3) because its a code in
matlab.
Task 1: You were asked to check up the status of the water system. Water at 24 °C is to be pumped from a Lower reservoir with 100 m elevation to another reservoir at a higher elevation 112 m through 150-m-long pipe as shown in Figure (1). The pipe is made of steel, and the diameter ofthe pipe is equal to 30 cm water is to be pumped...