A radar has a linear FM modulated pulse from 34GHZ to 35GHz.
a. What is the range resolution?
The radar has a 1ms transmit pulse width and uses stretch processing in the receive mixer. The receiver local oscillator ramp starts at a frequency of 33GHz at same time the transmit pulse is sent.
b. What is the IF frequency of a target at 4 km?
A radar has a linear FM modulated pulse from 34GHZ to 35GHz. a. What is the...
What is the range resolution of a 12us pulse radar with and without an FM modulated chirp pulse that has a 100MHz bandwidth?
Question 5 superheterodyne receiver that The commercial FM broadcasting radio uses a has the following specifications: IF Filter Frequency: 10.7 MHz FM Radio transmitter carrier frequency range: 87.5 MHz to 108 MHz (a) Determine the local oscillator frequency range if low-side tuning is used. (b) Determine the local oscillator frequency range if high-side tuning is used (c) Determine the range of the image frequencies associated with a high-side tunning local oscillator Question 5 superheterodyne receiver that The commercial FM broadcasting...
A radar receiver has a “wide open” front end with no RF filtering before the mixer. It is intended to operate in C-Band at 9.825 GHz with a heterodyne receiver with an I.F. of 30 MHz and the local oscillator set to 9.855 GHz. What other “image” frequency will the receiver detect?
7) If f1= 5MHz and f2=7 MHz, find: a. 2nd order harmonics. b. 3rd order harmonics. c. 3rd order inter-modulation products (IMD) 8) In a superheterodyne receiver, the input RF frequency is 1 GHz. Find the IF frequency if the local oscillator frequency is 950 MHz? 9) Rank from 1 to 3 for linearity and efficiency with 1 as the most linear and most efficient. Class of amplifier Linearity Efficiency Class A Class B Class C 10) Which of the...
71. A superheterodyne receiver tunes at the frequency range from 25 to 50 MHz. What is the IF frequency of the receiver if the range of the local oscillator is 10 MHz to 35MHz 75. An AM transmitter uses high-level modulation. The RF power amplifier draws 12 A from 22 V supply putting out a carrier power of 140 Watts. What impedance would be seen at the modulation transformer secondary? 72. A receiver has a sensitivity of 0Suv and blocking...
When the message signal m (t) =cos (2π fmt) and the carrier signal is c(t)=cos (2π fct) , fm<< fc, The modulated DSB-SC signal SDSB-SC=m(t)cos(2πfct) is generated, and only the upper sideband To generate and transmit the SSB signal. As shown in the figure below, the receiver is a local oscillator cosine signal to the received signal and passes it through a low-pass filter. Answer the following questions. (a) Draw the waveform of DSB-SC modulated signal SDSB-SC(t) (b)Find the result...