Question: You work in a lab at a chemical fertilizer plant and a month ago you...
Question: You work in a lab at a chemical fertilizer plant and a
month ago you prepared a 10 -2
NaOH solution in distilled water.
a. What pH did you measure after making the solution?
b. What pH would you expect to measure after the month of storage
in the lab which has a
measurable amount of NH3 in the air (155 ppb)? How did the
alkalinity change during this
period?
Homework Answers
Add Answer to:
Question: You work in a lab at a chemical fertilizer plant and a
month ago you...
Properties of Buffers Lab. I need help with problems 7 & 8. They’re pretty similar, but...
Properties of Buffers Lab.
I need help with problems 7 & 8. They’re pretty similar,
but I’m confused on whether I’m doing them right.
I need to calculate the moles of HCl and NaOH and then somehow
insert them into the log fraction in the Henderson Hasselbach
formula, is that right?
Procedure (values are needed in procedure):
Measured values during lab that I’ll be comparing #6/7/8
to:
Questions I need help with:
Part B Procedures: 1. Weigh about 3.5g of...
Please help with the prelab questions! thank you!!!! Especially 2 and 3! Pre-Lab Questions 1. Calculate...
Please help with the prelab questions! thank you!!!!
Especially 2 and 3!
Pre-Lab Questions 1. Calculate the theoretical equivalence point (the volume!) in terms of ml NaOH adde each of the titrations. Assume the concentration of acid is 0.81 M and the concentration of base is 0.51 M. 2. Which equation can be used to find the pH of a buffer? Calculate the pH of a buffer containing 0.20 M CH3COOH and 0.20 M CH3COONa. What is the pH after...
2. If you prepared a 0.15 M CH.COH - 0.15 M CHCO Na buffer, would you expect the resulting buffer capacity t...
2. If you prepared a 0.15 M CH.COH - 0.15 M CHCO Na buffer, would you expect the resulting buffer capacity to be higher, lower, or the same as the buffer you prepared in Part II of this lab? Be specific and use your data. c. Measure the pH of the Beaker #2 solution, via a pH meter, and record in data sheet. Part II: Dilute Buffer Solution In this section, the pH of a 0.25 M CH3CO2H - 0.25...
The table filled is the lab run. Please can you use the three informations provided above...
The table filled is the lab run.
Please can you use the three informations provided above to answer
the empty table
Take Density of vinegar = 1.005g/mol
concentration of NaOH = 0.1205M
Experiment #7. Titration of Vinegar Goals 1. To determine the mass percent of acetic acid in a solution via titration. 2. To master the technique of titration. Introduction Vinegar is a common household item that is found in a number of products from salad dressing to cleaners. Vinegar...
I added everything thing. this is the lab question you need to solve. First assigned buffer...
I added everything thing.
this is the lab question you need to solve.
First assigned buffer pH: 2.031 Second assigned buffer pH: 9.171 Available Buffer Systems (acid/ base) pka of Conjugate Acid 2.847 4.757 malonic acid/ monosodium malonate acetic acid/ sodium acetate ammonium chloride/ ammonia triethylammonium chloride/ triethylamine 9.244 10.715 1) Buffer system details: Given pH Name and volume conjugate acid Name and volume conjugate base 2) Calculations for preparation of high capacity buffer system. Introduction In this experiment, you...
I need help with the problem in the last photo.. I thought I’d post my lab...
I need help with the problem in the last photo.. I thought I’d
post my lab explanation and data if that helps you get a better
understanding, but it’s just the question at the end. I know I need
to use the Henderson Hasselbach equation.. so... 4.70 = pKa + log(
[acetate-ion] / [acetic-ion] ) and solve for pKa, then Ka.. but how
do I find the concentrations to put in the log fraction?
Thanks, in advance!
Learning Objectives: 1....
This is from a Study of Buffer Solutions and pH of Salt Solutions Lab. I calculated...
This is from a Study of Buffer Solutions and pH of Salt
Solutions Lab. I calculated Ka to be 3.2*10^-5. Why is my value
larger than the standard value?
Procedure:
10. How does your calculated value of Ka compare with the standard value of Ka for acetic acid? Discuss why your value may be larger or smaller than the standard value. Caleutats Ka 3.2x 10-5) Cyato-s Learning Objectives: 1. To test the acidic and basic properties of ionic compounds 2....
titration lab report additional images of lab report QUESTIONS 1. A student masse 0878 of an...
titration lab report
additional images of lab report
QUESTIONS 1. A student masse 0878 of an unknown acid follows the titration procedure required to reach the endpoint on a 10.0 ml Calculate the molar mass of the acid. masses out 0.878 of die in 100 ml volume and titration procedure of Partsherds th the average volume of Non to reach the endpoint on 100 ml aliquot of the acid solution is 18.3 m . 2. In the vinegar titrations (Part...
lab report titration help please! additional images on lab report 3. Federal standards require that any...
lab report titration help please!
additional images on lab report
3. Federal standards require that any commercial material called "vinegar" must contain as cast acetic acid. According to your results in question 4, does the vinegar sample you titrated meet the Federal standards? Explain why or why not. PART B: IDENTIFICATION OF AN UNKNOWN ACID DATA Molarity of NaOH used Mass of unknown acid used 0.050M 0.5989 14.43mc Average volume of NaOH used in the titration CALCULATIONS 1. Using the...
please help with my pre lab additional information Pre-Lab Questions: 1. What is the definition of...
please help with my pre lab
additional information
Pre-Lab Questions: 1. What is the definition of an 'equivalence point' in an acid/base titration? (1 point) 2. In part one of the experiment, you will prepare the acid solutions being titrated from a stock solution. Describe how you will accurately prepare 10.00 mL of 0.100 M HCl solution using a 1.00 M HCI stock solution. In your response to this question, be very specific about the quantities of stock solution and...
Properties of Buffers Lab.
I need help with problems 7 & 8. They’re pretty similar,
but I’m confused on whether I’m doing them right.
I need to calculate the moles of HCl and NaOH and then somehow
insert them into the log fraction in the Henderson Hasselbach
formula, is that right?
Procedure (values are needed in procedure):
Measured values during lab that I’ll be comparing #6/7/8
to:
Questions I need help with:
Part B Procedures: 1. Weigh about 3.5g of...
Please help with the prelab questions! thank you!!!!
Especially 2 and 3!
Pre-Lab Questions 1. Calculate the theoretical equivalence point (the volume!) in terms of ml NaOH adde each of the titrations. Assume the concentration of acid is 0.81 M and the concentration of base is 0.51 M. 2. Which equation can be used to find the pH of a buffer? Calculate the pH of a buffer containing 0.20 M CH3COOH and 0.20 M CH3COONa. What is the pH after...
2. If you prepared a 0.15 M CH.COH - 0.15 M CHCO Na buffer, would you expect the resulting buffer capacity to be higher, lower, or the same as the buffer you prepared in Part II of this lab? Be specific and use your data. c. Measure the pH of the Beaker #2 solution, via a pH meter, and record in data sheet. Part II: Dilute Buffer Solution In this section, the pH of a 0.25 M CH3CO2H - 0.25...
The table filled is the lab run.
Please can you use the three informations provided above to answer
the empty table
Take Density of vinegar = 1.005g/mol
concentration of NaOH = 0.1205M
Experiment #7. Titration of Vinegar Goals 1. To determine the mass percent of acetic acid in a solution via titration. 2. To master the technique of titration. Introduction Vinegar is a common household item that is found in a number of products from salad dressing to cleaners. Vinegar...
I added everything thing.
this is the lab question you need to solve.
First assigned buffer pH: 2.031 Second assigned buffer pH: 9.171 Available Buffer Systems (acid/ base) pka of Conjugate Acid 2.847 4.757 malonic acid/ monosodium malonate acetic acid/ sodium acetate ammonium chloride/ ammonia triethylammonium chloride/ triethylamine 9.244 10.715 1) Buffer system details: Given pH Name and volume conjugate acid Name and volume conjugate base 2) Calculations for preparation of high capacity buffer system. Introduction In this experiment, you...
I need help with the problem in the last photo.. I thought I’d
post my lab explanation and data if that helps you get a better
understanding, but it’s just the question at the end. I know I need
to use the Henderson Hasselbach equation.. so... 4.70 = pKa + log(
[acetate-ion] / [acetic-ion] ) and solve for pKa, then Ka.. but how
do I find the concentrations to put in the log fraction?
Thanks, in advance!
Learning Objectives: 1....
This is from a Study of Buffer Solutions and pH of Salt
Solutions Lab. I calculated Ka to be 3.2*10^-5. Why is my value
larger than the standard value?
Procedure:
10. How does your calculated value of Ka compare with the standard value of Ka for acetic acid? Discuss why your value may be larger or smaller than the standard value. Caleutats Ka 3.2x 10-5) Cyato-s Learning Objectives: 1. To test the acidic and basic properties of ionic compounds 2....
titration lab report
additional images of lab report
QUESTIONS 1. A student masse 0878 of an unknown acid follows the titration procedure required to reach the endpoint on a 10.0 ml Calculate the molar mass of the acid. masses out 0.878 of die in 100 ml volume and titration procedure of Partsherds th the average volume of Non to reach the endpoint on 100 ml aliquot of the acid solution is 18.3 m . 2. In the vinegar titrations (Part...
lab report titration help please!
additional images on lab report
3. Federal standards require that any commercial material called "vinegar" must contain as cast acetic acid. According to your results in question 4, does the vinegar sample you titrated meet the Federal standards? Explain why or why not. PART B: IDENTIFICATION OF AN UNKNOWN ACID DATA Molarity of NaOH used Mass of unknown acid used 0.050M 0.5989 14.43mc Average volume of NaOH used in the titration CALCULATIONS 1. Using the...
please help with my pre lab
additional information
Pre-Lab Questions: 1. What is the definition of an 'equivalence point' in an acid/base titration? (1 point) 2. In part one of the experiment, you will prepare the acid solutions being titrated from a stock solution. Describe how you will accurately prepare 10.00 mL of 0.100 M HCl solution using a 1.00 M HCI stock solution. In your response to this question, be very specific about the quantities of stock solution and...
Most questions answered within 3 hours.
-
Assume Kw = 1.01 ✕ 10−14
For pure water, we can calculate [H3O+ ] = [OH...
asked 35 minutes ago -
Suppose that on a temperature scale X, water boils at 203.0°X
and freezes at -105.7°X. What...
asked 1 hour ago -
BaS crystallizes in a cubic unit cell with S2- ions on each
corner and each face....
asked 1 hour ago -
A. 0≤P(Oi)≤10≤P(Oi)≤1 for each i
B. P(Oi)≤0P(Oi)≤0
C. P(Oi)=1+P(OCi)P(Oi)=1+P(OiC)
D. P(Oi)≥1P(Oi)≥1
If an experiment consists of...
asked 3 hours ago -
A battery has an emf of 9.20V and an internal resistance of 1.20
ohm. a)What resistance...
asked 3 hours ago -
The area of an elastic circular loop decreases at a constant
rate, dA/dt = −6.60×10−3 m2/s...
asked 4 hours ago -
The denaturation of proteins can be described by the
equilibrium
F⇌U
where F and U represent...
asked 6 hours ago -
Please answer what the maximum and minimum force is, and the
angle on the ion is...
asked 6 hours ago -
implement a program that reads a number of rows and a symbol.
The program will draw...
asked 6 hours ago -
Assume that when adults with smartphones are randomly selected,
45% use them in meetings or classes....
asked 6 hours ago -
Determine the number of formula units of
Na2SO4 and moles of oxygen contained in 8.11
moles...
asked 6 hours ago -
Explain in steps on the following code
What would be the output when executed
using System;...
asked 6 hours ago