the metro transit system (mcts) is made up of the red line and the blue line....
the metro transit system (mcts) is made up of the red line and the blue line. the red line has 4 cars and averages 478 passengers per run. the blue line has 20 cars and averages 468 passengers per run.
determine the relative u fairness if the apportionment if the additional car is given to the red line
Homework Answers
determine the average number of passengers per car
the average number of passengers per car is expressed as:
= 
the average passengers per car of the two lines are as follows:
red line: 478/4 = 119.5
blue line: 468/20 = 23.4
If an additional car is given to red line, its average
passengers become:
red line (new) = 478/5 = 95.6
therefore, red line will have the smaller average passengers per car.
The relative unfairness of apportionment:
Add Answer to:
the metro transit system (mcts) is made up of the red
line and the blue line....
Car Rental Management System The aim of this project is to design and implement a computerized...
Car Rental Management System The aim of this project is to design and implement a computerized Car Rental Management System for a company called COEN244Cars. The company rents two types of cars: standard and luxury cars. A car is identified by a car identification number (int), a type (string), and a flag that indicates whether the car is currently available or not. The company distinguishes between three types of customers: regular customers, corporate customers, and VIPs (Very Important Persons). A...
3- The figure given below shows the one line diagram of a simple power system. Line impedançe is given in per unit...
3- The figure given below shows the one line diagram of a simple power system. Line impedançe is given in per unit on a 100 MVA base. a. Find the unknown bus voltage by using Newton Raphson method with one iteration. IE you need Ssum you can use San-100 MVA. (20 pts) b. If after several iterations the bus voltage converge to V09-j0.1 pu, determine the power loss in the line and the bus 1 real and reactive power. (15...
3. (30) A simple power system, shown below, is made up of a synchronous generatcr connected to a synchronous motor through a couple of transformers and a transmission line. The reactances of the...
3. (30) A simple power system, shown below, is made up of a synchronous generatcr connected to a synchronous motor through a couple of transformers and a transmission line. The reactances of the different elements of the system are all given in pu as: Xsg-0.5 X of each transformer-10 % Xsm-0.5 X transmission line 0.3 The synchronous motor is connected to an infinite bus Hint: The great advantage of an infinite bus is that it always remains constant and our...
I cannot figure out how to do number four. Can someone please show me step by step how to do it? This project is made up of 4 different parts. The dataset for all 4 parts is given in the Students...
I cannot figure out how to do number four. Can someone please
show me step by step how to do it?
This project is made up of 4 different parts. The dataset for all 4 parts is given in the Students are encoruraged to use software (Mimitab, excel tc) to complete the help see your professor. CARS: A sample of 20 cars, including measurements of fuel consumption (eity mi/gal and highway mi/gal), weiglit (poumds), mumber of eylinders, engine disp gases...
BUSI 320 Comprehensive Problem 2 2019 Summer You have been asked to assess the expected financial impact of each of the following proposals to improve the profitability of credit sales made by yo...
BUSI 320 Comprehensive Problem 2 2019 Summer You have been asked to assess the expected financial impact of each of the following proposals to improve the profitability of credit sales made by your company. Each proposal is independent of the other. Answer all questions. Showing your work may earn you partial credit Proposal #1 would extend trade credit to some customers that previously have been denied credit because they were considered poor risks. Sales are projected to increase by $150,000...
20,000 assign to each product line, the two products: car wheals and truck wheels. To determine...
20,000 assign to each product line, the two products: car wheals and truck wheels. To determine theamr controller, Robert Hermann, has developed the follown Estimated wheels produced Direct labor hours per wheel Car 40,000 Truck 10,000 3 Total estimate d overhead costs for the two product lines are $770,000. Instructions (a) Compute the overhead cost assigned to the car wheels and truck wheels, a assuming that direct labor hours he believes that most is used to allocate overhead costs. (b)...
Question 11 EcoFabrics has budgeted overhead costs of $1,096,200. It has allocated overhead on a plantwide...
Question 11 EcoFabrics has budgeted overhead costs of $1,096,200. It has allocated overhead on a plantwide basis to its two products (wool and cotton) using direct labor hours which are estimated to be 522,000 for the current year. The company has decided to experiment with activity-based costing and has created two activity cost pools and related activity cost drivers. These two cost pools are cutting (cost driver is machine hours) and design (cost driver is number of setups). Overhead allocated...
The ACME Manufacturing Company has hired you to help automate their production assembly line. Cameras have...
The ACME Manufacturing Company has hired you to help automate
their production assembly line. Cameras have been placed above a
conveyer belt to enables parts on the belt to be photographed and
analyzed. You are to augment the system that has been put in place
by writing C code to detect the number of parts on the belt, and
the positions of each object. The process by which you will do this
is called Connected Component Labeling (CCL). These positions...
You have been asked to assess the expected financial impact of each of the following proposals to improve the profitability of credit sales made by your company. Each proposal is independent of the other. Answer all questions. Showing your work may ear
You have been asked to assess the expected financial impact of each of the following proposals to improve the profitability of credit sales made by your company. Each proposal is independent of the other. Answer all questions. Showing your work may earn you partial credit. Proposal #1 would extend trade credit to some customers that previously have been denied credit because they were considered poor risks. Sales are projected to increase by $240,000 per year if credit is extended to these...
System Model: Automotive Air Conditioning System Outside Air Temp: 45 oC Car Interior Air Temp: 22...
System Model: Automotive Air Conditioning System Outside Air Temp: 45 oC Car Interior Air Temp: 22 oC Heat Load = 4.2 kJ/sec rate at which heat must go in to the air conditioner to be removed from the car’s interior Refrigerant: R134a HINT: Heat enters an air conditioning system where? Refrigerant 134a … - leaves the evaporator coil and enters the compressor as a saturated vapor at the evaporator pressure of 2.8 bars. - It leaves the compressor at...
Car Rental Management System The aim of this project is to design and implement a computerized Car Rental Management System for a company called COEN244Cars. The company rents two types of cars: standard and luxury cars. A car is identified by a car identification number (int), a type (string), and a flag that indicates whether the car is currently available or not. The company distinguishes between three types of customers: regular customers, corporate customers, and VIPs (Very Important Persons). A...
3- The figure given below shows the one line diagram of a simple power system. Line impedançe is given in per unit on a 100 MVA base. a. Find the unknown bus voltage by using Newton Raphson method with one iteration. IE you need Ssum you can use San-100 MVA. (20 pts) b. If after several iterations the bus voltage converge to V09-j0.1 pu, determine the power loss in the line and the bus 1 real and reactive power. (15...
3. (30) A simple power system, shown below, is made up of a synchronous generatcr connected to a synchronous motor through a couple of transformers and a transmission line. The reactances of the different elements of the system are all given in pu as: Xsg-0.5 X of each transformer-10 % Xsm-0.5 X transmission line 0.3 The synchronous motor is connected to an infinite bus Hint: The great advantage of an infinite bus is that it always remains constant and our...
I cannot figure out how to do number four. Can someone please
show me step by step how to do it?
This project is made up of 4 different parts. The dataset for all 4 parts is given in the Students are encoruraged to use software (Mimitab, excel tc) to complete the help see your professor. CARS: A sample of 20 cars, including measurements of fuel consumption (eity mi/gal and highway mi/gal), weiglit (poumds), mumber of eylinders, engine disp gases...
BUSI 320 Comprehensive Problem 2 2019 Summer You have been asked to assess the expected financial impact of each of the following proposals to improve the profitability of credit sales made by your company. Each proposal is independent of the other. Answer all questions. Showing your work may earn you partial credit Proposal #1 would extend trade credit to some customers that previously have been denied credit because they were considered poor risks. Sales are projected to increase by $150,000...
20,000 assign to each product line, the two products: car wheals and truck wheels. To determine theamr controller, Robert Hermann, has developed the follown Estimated wheels produced Direct labor hours per wheel Car 40,000 Truck 10,000 3 Total estimate d overhead costs for the two product lines are $770,000. Instructions (a) Compute the overhead cost assigned to the car wheels and truck wheels, a assuming that direct labor hours he believes that most is used to allocate overhead costs. (b)...
Question 11 EcoFabrics has budgeted overhead costs of $1,096,200. It has allocated overhead on a plantwide basis to its two products (wool and cotton) using direct labor hours which are estimated to be 522,000 for the current year. The company has decided to experiment with activity-based costing and has created two activity cost pools and related activity cost drivers. These two cost pools are cutting (cost driver is machine hours) and design (cost driver is number of setups). Overhead allocated...
The ACME Manufacturing Company has hired you to help automate
their production assembly line. Cameras have been placed above a
conveyer belt to enables parts on the belt to be photographed and
analyzed. You are to augment the system that has been put in place
by writing C code to detect the number of parts on the belt, and
the positions of each object. The process by which you will do this
is called Connected Component Labeling (CCL). These positions...
Most questions answered within 3 hours.
-
When 60.1 gg of calcium is reacted with nitrogen gas, 31.7 gg of
calcium nitride is...
asked 1 minute ago -
The random variable X is exponentially distributed, where X
represents the time it takes for a...
asked 16 minutes ago -
a) Write a verilog module for 1:4 Demultiplexer using verilog
primitives.
b) Design 1-to-4 DEMUX using...
asked 11 minutes ago -
MATLAB
write a MATLAB function (1) output a third-order polynomial
function with the coefficients as the...
asked 24 minutes ago -
A z-score
communicates a raw score’s "relative standing"
under the normal curve in relation to:
asked 32 minutes ago -
An object is vibrating on a spring with the following equation
of motion:
?=(30 ??)cos((2?)/(160)?)
a)...
asked 32 minutes ago -
Vulcan Flyovers offers scenic overflights of Mount St. Helens,
the volcano in Washington State that explosively...
asked 34 minutes ago -
If organizations do not adapt fast enough and move incrementally
from the twentieth-century model to the...
asked 35 minutes ago -
A helium balloon with 2.5L of gas has a gauge pressure of 10,000
Pa. The balloon...
asked 39 minutes ago -
What is responsible for Jupiter's enormous magnetic field?
asked 55 minutes ago -
At the end of the year, a company offered to buy 5,000 units of
a product...
asked 56 minutes ago -
Implement C++ program for each of the following.
Let D = [-48, -14, -8, 0, 1,...
asked 1 hour ago