Explain the significance of the peak to peak voltage in terms of Vac production and why...

Question

Question

Explain the significance of the peak to peak voltage in terms of Vac production and why you divide by two to obtain voltage amplitude.

Answer 1

Answer #1

Answer 2

Similar Homework Help Questions

An AC waveform has an RMS voltage of 60 VAC. What's the waveform's peak voltage?

An AC waveform has an RMS voltage of 60 VAC. What's the waveform's peak voltage?
The LCR circuit in the figure below is driven by a voltage source with VAC =...

The LCR circuit in the figure below is driven by a voltage source with VAC = Vmax sin(2(pi)ft), where Vmax = 12 V, R = 280 ohms, and C = 31 nF. (a) If the resonant frequency is fres = 99 MHz, what is L? (b) What is the amplitude (the peak value) of the current when f = fres? The LCR circuit in the figure below is driven by a voltage source with VAC = Vmax sin(2(pi)ft), where Vmax...
Practice Problem 5 Consider a triangle wave voltage with peak-to-peak amplitude of 16 V and a...

Practice Problem 5 Consider a triangle wave voltage with peak-to-peak amplitude of 16 V and a dc offset of 4 V; the rising and falling slopes have equal magnitudes - Find the average power absorbed by a 50 ohm resistor supporting this voltage in terms of its Fourier components. Use up to the 15th harmonic in your answer. Answer: 0.747 W PT: 6min

please explain Name(s): the ripple voltage for the cir i) Approximate formulas for the peak rectifier...

please explain Name(s): the ripple voltage for the cir i) Approximate formulas for the peak rectifier (e.g., see the textbook). Assume the 0.7V diode; (ii) Transient simulation using Multisim with the IN5393GP diode. Show the output voltage plot. The circuit consists of a 5uF capacitor, IkOhm resistor, diode, and source. The source voltage is a periodic triangular waveform with the 10V amplitude, zero DC offset, the 1 ms period and the 0.5 ms rise/fall time
For an ideal transformer, what is the ratio in terms of winding, current, and voltage? Explain...

For an ideal transformer, what is the ratio in terms of winding, current, and voltage? Explain how you derive it and what is Zp = a^2 * Z_L ? Why is it a^2 and not just a?
Explain how kilovoltage peak (kVp) affects radiation production and IR exposure.

Explain how kilovoltage peak (kVp) affects radiation production and IR exposure.

could you please help me to explain the problem with answers and explain why peak c...

could you please help me to explain the problem with answers and explain why peak c is 3h triplets ? points) A compound, C&H-N, has the following IR and 'H NMR spectra. 100 momw Transmittance %) 0 TTT 500 1000 4000 3500 3000 2500 2000 1500 Wavenumber (cm) peak a: 2H, triplet peak b: 2H, multiplet peak c: 3H, triplet Intensity - TMS (a) (8 points) Calculate the degree of unsaturation for this compound. Degree of unsaturation = 2 (b)...
In terms of the earth-sun relation explain the significance of the: TRPOIC OF CANCER, THE TROPIC...

In terms of the earth-sun relation explain the significance of the: TRPOIC OF CANCER, THE TROPIC OF CAPRICORN, THE ARCTIC CIRCLE, THE ANTARCTIC CIRCLE
When you drop a magnet (North Pole first) through a large coil and measure the induced voltage...

When you drop a magnet (North Pole first) through a large coil and measure the induced voltage over time, you will notice that the induced voltage has one peak upward and one peak downward. Explain why this happens. You will also notice that these voltage peaks are not the same magnitude, but the area under the peaks are nearly the same. Which peak is larger, the earlier or the later one? Explain why. What do the areas represent and why are...

Explain why the signal in SWV is peak-shaped while in NPV it is sigmoidal.

Explain why the signal in SWV is peak-shaped while in NPV it is sigmoidal.