2. A double-heterojunction InGaAsP LED emitting at a peak wavelength of 1310 nm has radiative recombination times of 25 and 90 ns, respectively. The drive current is 35 mA
(a) Find the internal quantum efficiency and the internal power level.
(b) If the refractive index of the light source material is n =3.5, find the power emitted from the device
i just refer from textbook for transmission factor ,
If you have transmission factor and refractive index of medium ,you can substitute at that variables at power emitted from the device
If you have doubt at any step please comment below
2. A double-heterojunction InGaAsP LED emitting at a peak wavelength of 1310 nm has radiative recombination...
Question 3: (8 points) (a) A photodetector has an effective area of 6x102 cm. It is illuminated with 700nm laser light that has an intensity of 2.5mW/cm². Assuming each three photons generate one electron-hole pair on average, calculate the generated photocurrent. (b) A 40 nW optical power at 1555 nm is incident on APD. The APD has refractive index of 3.5, and its multiplication factor is 12. It is efficiency without avalanche breakdown is 80%. Find: a) The responsivity of...
Problem 2: A Helium-Neon laser gives a wavelength of 633 nm and has a power of 20 milliWatt. Find (a) The frequency of laser light and (b) The total number of photons emitted per second.
Problem 3 (25 points) A silicon photodetector has an internal photo responsivity of 0.5 A/Wt wavelength of 850 nm. When photons of wavelength 850 nm are incident normally on this photodetector, some photons are reflected back and some photons penetrate to the detection region and are absorbed by the photodetector. (a) The index of refraction of silicon is 3.45. If the electric current measured by this photodetector is 20 mA, what is the incident optical power? (b) Silicon has a...
Question 11 (1 point) An LED has reached the end of rated life when: Question 11 options: the filament opens. the fill gas is allowed to escape. emissive material on the cathode is insufficient to start or maintain the electrical discharge. lumen output drops 30 percent from initial rated value. the mercury beads have been vaporized. Question 12 (1 point) Based upon the operating conditions, it is determined that it is necessary to change a LED lamp 0.05 times over...