Question

a.)Suppose you were preparing 1.0 L of a bleaching solution in a volumetric flask, and it...

a.)Suppose you were preparing 1.0 L of a bleaching solution in a volumetric flask, and it calls for 0.26 mol of NaOCl. If all you had available was a jug of bleach that contained 0.74 M NaOCl, what volume of bleach would you need to add to the volumetric flask before you added enough water to reach the 1.0 L line?

Express the volume in milliliters to two significant figures

b.) You need to prepare a 2.40 M solution of sodium hydroxide (molar mass of sodium hydroxide = 40.00 g/mol ), but you only have a 10 mL graduated cylinder and a 25 mL beaker. Complete the following sentences regarding the concentration of the prepared solution.

Match the words below to the appropriate blanks in the sentences. Make certain each sentence is complete before submitting your answer.

exactly 10.0mL

greater than 10.0mL

less than 10.0ml

0.024g

0.960g

Exactly 2.40 M

Greater than 2.40M

Less than 2.40M

1. In order to prepare 10.0 mL (0.0100 L) solution of 2.40 M sodium hydroxide, a mass of ______ would be required

2.When the solute and a total of 10.0 mL of water are both added into the beaker and stirred until the solute dissolves, the solution volume will be_____

3.Based on that, the concentration of the prepared solution will be______

c.) You are asked to prepare a 1.000 L solution of 4.5 M C6H12O6 (glucose; molar mass = 180.16 g/mol) in a lab by dissolving 811.0 g of glucose in water. Consider the following two scenarios in which you commit a user error while preparing this solution.

Prepared in a volumetric flask Prepared in a beaker
Assumed volume 1.000 L 1.000 L
Volumetric error Added water 2.0 cm above the line, which corresponds to 6.3 mL (0.0063 L) additional solution volume 811.0 g takes up 526 mL of space rather than 500 mL of space
Preparation details You add the glucose to a volumetric flask and then add water until it dissolves. The water bottle you are using has a worn tip, and you inadvertently add too much water such that the meniscus is above the line. The diameter of the neck of the volumetric flask is 2.29 cm . You prepare the solution by adding glucose to a large beaker and approximated the volume of the glucose to be 500 mL . Therefore, you add 500. mL of water to the 526 mL in the beaker using a graduated cylinder.

You decide to evaluate and compare the errors you made while preparing the solutions using the different methods. Calculate the actual concentrations of the intended 4.5 M glucose solutions prepared by each method based on their actual final volumes.

Express the concentrations in molarity to two decimal places.

Flask=

Beaker=

0 0
Add a comment Improve this question Transcribed image text
Know the answer?
Add Answer to:
a.)Suppose you were preparing 1.0 L of a bleaching solution in a volumetric flask, and it...
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for? Ask your own homework help question. Our experts will answer your question WITHIN MINUTES for Free.
Similar Homework Help Questions
  • In the laboratory you dissolve 25.0 g of sodium hydroxidein a volumetric flask and add water...

    In the laboratory you dissolve 25.0 g of sodium hydroxidein a volumetric flask and add water to a total volume of 125 mL.   What is the molarity of the solution?   M. What is the concentration of the sodium cation?  M. What is the concentration of the hydroxide anion?  M.

  • You need to prepare a 2.10 M solution of sodium hydroxide (molar mass of sodium hydroxide=...

    You need to prepare a 2.10 M solution of sodium hydroxide (molar mass of sodium hydroxide= 40.00 g/mol), but you only have 10 mL graduated cylinder and a 25 mL beaker. Complete the following sentences regarding the concentration of the prepared solution. 1. In order to prepare 10.0 mL (0.0100 L) solution of 2.10 M sodium hydroxide, a mass of ?? would be required. 2. When the solute and a total of 10.0 mL of water are both added into...

  • Pour 2.5 mL of the 1M glucose (C6H12O6) solution from the flask into the 100 mL...

    Pour 2.5 mL of the 1M glucose (C6H12O6) solution from the flask into the 100 mL volumetric flask. Use the “dilution equation” to determine the volume in mL for the required 0.025M solution, given that the original solution is 1M and you used 2.5 mL Fill the volumetric flask to the 100 mL mark with distilled water. Note: The flask already contains a volume of 2.5 mL. 1. Compute the volume of the diluted 0.025 M solution.   2. What volume...

  • 1.In the laboratory you dissolve 12.8 g of barium acetate in a volumetric flask and add...

    1.In the laboratory you dissolve 12.8 g of barium acetate in a volumetric flask and add water to a total volume of 375 mL. What is the molarity of the solution?  M. What is the concentration of the barium cation?  M. 2.In the laboratory you dissolve 18.2 g of potassium bromide in a volumetric flask and add water to a total volume of 125 mL. What is the molarity of the solution?  M. What is the concentration of the potassium cation?  M. What is...

  • Use a volumetric pipet to deliver 2 mL of 4 M sodium hydroxide solution to each...

    Use a volumetric pipet to deliver 2 mL of 4 M sodium hydroxide solution to each of seven 100-mL volumetric flasks. Add 2,4, 6, 8, and 10 mL, respectively, of the salicylic acid stock solution to 5 of the labeled flasks. Calculate the concentrations of the standard solutions. Use a pipet to place 10 mL of the unknown solution into another volumetric flask and label Unknown 1. Dilute each solution to the mark with DI water. The seventh flask that...

  • A) 300.0g of calcium hydroxide is placed in a 1L volumetric flask and the flask was...

    A) 300.0g of calcium hydroxide is placed in a 1L volumetric flask and the flask was filled to the mark with water at 25°C. There is obviously a lot of solid in the bottom of the flask. Ksp = 1.3 x 10-6 for calcium hydroxide. The contents of the flask are transferred quantitatively to a 2.00 L volumetric. 100. ml of 1.00 M HCL is added and the flask filled to the mark with water. There is still observable solid...

  • O ACIDS AND BASES Preparing a strong base solution with a given pH A chemist must...

    O ACIDS AND BASES Preparing a strong base solution with a given pH A chemist must prepare 800.0 mL of sodium hydroxide solution with a pH of 13.40 at 25°C. She will do this in three steps: • Fill a 800.0 mL volumetric flask about halfway with distilled water. • Weigh out a small amount of solid sodium hydroxide and add it to the flask. • Fill the flask to the mark with distilled water. Calculate the mass of sodium...

  • A student weighs out 14.6 g of AlBrz, transfers it to a 300 mL volumetric flask,...

    A student weighs out 14.6 g of AlBrz, transfers it to a 300 mL volumetric flask, adds enough water to dissolve the solid and then adds water to the 300 mL mark on the neck of the flask. Calculate the concentration (in molarity units) of aluminum bromide in the resulting solution? Calculate the mass, in grams of sodium iodide that must be added to a 250 mL volumetric flask in order to prepare 250 mL of a 0.138 M aqueous...

  • In the laboratory you dissolve 17.8 g of manganese(II) nitrate in a volumetric flask and add...

    In the laboratory you dissolve 17.8 g of manganese(II) nitrate in a volumetric flask and add water to a total volume of 125 mL What is the molarity of the solution? M. What is the concentration of the manganese(II) cation? M. What is the concentration of the nitrate anion? M. Retry Entire Group 9 more group attempts remaining Submit Answer In the laboratory you dissolve 21.3 g of silver fluoride in a volumetric flask and add water to a total...

  • In the laboratory you dissolve 23.1 g of zinc nitrate in a volumetric flask and add...

    In the laboratory you dissolve 23.1 g of zinc nitrate in a volumetric flask and add water to a total volume of 250 . mL. What is the molarity of the solution? ______ M

ADVERTISEMENT
Free Homework Help App
Download From Google Play
Scan Your Homework
to Get Instant Free Answers
Need Online Homework Help?
Ask a Question
Get Answers For Free
Most questions answered within 3 hours.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT