Sampling theorem: Suppose the highest frequency component, in hertz, for a given analog signal is fmax. According to the Nyquist Theorem, the sampling rate must be at least 2fmax, or twice the highest analog frequency component.
C) Aliasing doesn't occur in this case beacause fs>2fm.
E) Aliasing doesn't occur in this case beacause fs>2fm.
3. The signal continuous time signal re(t)-cos(200t)2cos cos(100t) is sampled at twice the Nyquis...
Problem 3: Sampling a Cosine (again) The continuous-time signal ra(t) = cos (150) is sampled with sampling period T, to obtain a discrete-time signal x[n] = XanT). 1. Compute and sketch the magnitude of the continuous-time Fourier transform of ra(t) and the discrete-time Fourier Transform of x[n] for T, = 1 ms and T, = 2 ms. 2. What is the maximum sampling period Ts max such that no aliasing occurs in the sampling process?
10. Find the Fourier transform of a continuous-time signal x(t) = 10e Su(t). Plot the magnitude spectrum and the phase spectrum. If the signal is going to be sampled, what should be the minimum sampling frequency so that the aliasing error is less than 0.1 % of the maximum original magnitude at half the sampling frequency. 11. A signal x(t) = 5cos(2nt + 1/6) is sampled at every 0.2 seconds. Find the sequence obtained over the interval 0 st 3...
(a) The continuous-time signal x(t) with FT as depicted in the figure shown below is sampled. Sketch the FT of the sampled signal for the following sampling intervals: identify whether aliasing occurs, Ts = 1/12 X(jw) -117 107 W -10 0 117 97 97T (b) Determine the z-transform and ROC for the following time signals: x[n] = (4)"u[n] + (1)"u[ -– 1] Sketch the ROC, poles, and zeros in the z-plane.
2.5. Given an analog signal x(t)5cos(2T 2, 5001) + 2cos(2T 4, 5001), for t2 0 sampled at a rate of 8,000 Hz, a. sketch the spectrum of the sampled signal up to 20 kHz; b. sketch the recovered analog signal spectrum if an ideal lowpass filter with a cutoff frequency of 4 kHz is used to filter the sampled signal in order to recover the original signal; c. determine the frequneuencis f aliasing noise.
. A continuous-time signal is given by, x(r) = cos(1600m) +5cos(8000m)+ 3cos(2300m) +2cos(1400π a) Choose sampling frequeney (S,) as twice the Nyquist rate to find x(n) and its period, N. magnitudes, X(k)for one period of x(n. in part-b to design a non-recursive (FIR) digital filter b) For the xen) ound in part-a, sketch the DFT o) usin the hamwline frergueney found in parth to desiegn a non-recursive (FIR) digital fiter using windowing functions such that the three smaller frequencies are...
(1) Consider the following continuous-time signal: (1) 2ua(-t+t)ua(t), where its energy is 20 milli Joules (2 x 103Joules). The signal ra(t) is sampled at a rate of 500 samples/sec to yield its discrete-time counter part (n) (a) Find ti, and hence sketch ra(t). (b) From part (a), plot r(n) and finds its energy (c) Derive an expression for the Fourier transform of a(n), namely X(ew). (d) Plot the magnitude spectrum (1X(e)) and phase spectrum 2(X(e). (e) Consider the signal y(n)...
please can discuss how you solve it For a continuous-time band-limited signal, x(t) = cos (4000nt) compute Nyquist sampling rate, 125. Also compute first 10 samples of the sampled signal, x (nts), for n > 0, that is, n 0 1 2 3 4 5 6 7 8 9 x(nts) Re-compute first 10 samples of the sampled signal, x(nts), for n > 0, that is, 0 2 3 4 8 9 x(nts) n 1 5 6 7 if x(t) is...
Please Justify why or why the nyquist rate does change for each and not just give the rate itself. Consider a continuous time signal s(t) sampled at Js and is bandlimited to a frequency less than ..-N2 . It has a Nyquist rate of ω,-2π.-4n/, . Determine and briefly justify the required Nyquist rate (o) of the following variations of this signal. (a) at)-s(t)+s(t-3004) (b) b(t) duo (c) c)s) (d) d(t)-s (t) (cos(ot)) ds(t) dt Consider a continuous time signal...
(a) Determine the Fourier transform of x(t) 26(t-1)-6(t-3) (b) Compute the convolution sum of the following signals, (6%) [696] (c) The Fourier transform of a continuous-time signal a(t) is given below. Determine the [696] total energy of (t) 4 sin w (d) Determine the DC value and the average power of the following periodic signal. (6%) 0.5 0.5 (e) Determine the Nyquist rate for the following signal. (6%) x(t) = [1-0.78 cos(50nt + π/4)]2. (f) Sketch the frequency spectrum of...
Q2.) Consider the sampling of the continuous-time signal x(t) to obtain a discrete-time signal x[n (1)-10cos(1000m + π/3) + 20cos(2000m + π/6). 110points! ], where x a) What is the maximum sampling interval (minimum sampling frequency) that could be used to ensure an aliasing free sampling of this signal? b) Plot the spectrum of the sampled signal if x() is sampled using a sampling frequency of (i) 2500 Hz (ii) 1800 Hz and state whether there will be an aliasing...