Question

Procedure Using the test board, one 7476 Dual JK Flip-Flop chip and a function generator, connect the circuit shown in Fig-2. The inputs S, R, J and K must be connected to switches, while input C is connected to the function generator to implement the various cases of the inputs. Adjust the function generator to output a 2.5V-peak square wave with a DC offset 2.5V and a 100Hz frequency. Connect the outputs to LEDs. Connect the circuit to the power supply then complete the state table shown in Table-2. What changes must be done to convert this Flip Flop to a T type Flip Flop ? Prove your answer by implementing the new circuit 7476 Chip Schematic 16- K-ト15 12- K-Q-11 7476A Dual JK Flip-Flop Voo Fin 5 Inputs Outputs J1 P1 RD1 02 P2 D2 RD2 Fig-2 Table-2

Answer 1

3K Fup Flop Tyuth Table output (0) ONo change | Reset iosc 1Togle n Table Trpot Outpot 2- cohere o is the previo What changes must be done to convert the Pip Flep to a Ttype -flp flop ? To tonvert JK Flip Flop to T Flip Flop Should give as a inpot T us inpot Cp

T FUp Flop uina J k Flip Flop 丁 t O X for k at ,) -fon J clk