Question

GD&T questions. Angularity, perpendicularity and parallelism.

7. IT IS POSSIBLE THAT PERPENDICULARITY TO TWO DATUMS COULD HAVE BEEN SPECIFIED OWN ON THE PREVIOUS EXAMPLE. SHOW AN EXAMPLE ON THE PART BELOW. SELECT YOUR O DATUMS 1.000 ±.003 2.886±.003 ! _ .61 7±.003 1 . 1 00±.003 400 ± .003 8. WHAT EFFECT WOULD TWO DATUMS HAVE ON PERPENDICULARITY? 9. ON THE PRODUCE PART BELOW, SHOW BY HAND SKETCH THE SPECIFIED PERPINDICULARITY TOLERANCE ZONE AND AN EXAMPLE OF HOW IT MAY BE CHECKED. 1.000±.003 2.886±.003- - .617±.003 1, 100 ±.003 400土003 . ON THE PART ABOVE, SPECIFY A REQUIREMENT TO MAKE THE LEFT HAND SURFACE IN THE FRONT VIEW, PERPENDICULAR TO THE BOTTOM SURFACE WITHIN .005 TOTAL 2. CAN THE MMC SYMBOL BE APPLIED TO THIS CONTROL? UD 3. WHY OR WHY NOT? Bcas 4. WHAT IS THE FLATNESS TOLERANCE ON THE LEFT SURFACE OF THE PART ABOVE? ON THE PART ABOVE, THERE IS NO PERPENDICULARTY REQUIREMENT BETWEEN THE RIGHT HAND SURFACE AND THE BOTTOM SURFACE, WHAT PERPENDİCULARITY IS IMPUED? 6. ON THE PRODUCED PART BELOW, SHOW BY HAND SKETCH THE SPECIFIED PERPENDICULARITY TOLERANCE ZONE AND AN EXAMPLE OF HOW IT MAY BE CHECKED. 13 HAND SKETCH A SIMPLE FUNCTIONAL GAGE TO VERIFY THE REQUIREMENT OF THE PART ON PAGE . SHOW PIN SIZE ec 36 ON THE PART ABOVE, SHOw AN ANGULARITY SPECIFICATION TO MAKE THE ANGLE SURACE IN RELATION TO THE TOP SURFACE WITHIN .033 TOTAL 14 15. PLUS/MINUS TOLERANCE APPLIED, OR SHOULD IT SHOULD BE A BASIC DIMENSION? COMPLETE THIS REQUIREMENT ON THE DRAWING ABOVE THE 36 ANGLE ABOVE HAVE A 16. WHAT IS THE FLATNESS TOLERANCE ON THE ANGLE SURFACE OF THE PART ABOVE? 17. CAN THE MMC SYMBOL BE APPLIED TO THIS CONTROL? 18. WHY OR WHY NOT? 19. DRAW A SIMPLE HAND SKETCH BELOW ON HOW THE PRODUCED PART MAY BE CHECKED AND THE SHAPE OF THE RESULTANT ANGULARITY TOLERANCE ZONE. 1.000±.020 2.886±.020- .617±.010 1.100土020 27 t0 400±.007 20. ON THE PART ABOVE WHAT IS THE MAXIMUM VARIATION İN PARALLELISM BETWEEN THE TOP AND BOTTOM SURFACES BEFORE ANY SYMBOLS ARE APPLIED 21. SPECIFY A PARALLELISM TOLERANCE TO MAKE THE BOTTOM SURFACE PARALLEL TO THE TOP SURFACE WITHIN A TOTAL OF .006. BE SURE TO PROPERLY IDENTIFY THE DATUM 22. CAN THE MMC SYMBOL BE APPLIED TO THIS cONTROL? WHY OR WHY NOT? 23. WHAT CAN WE EXPECT THE FLATNESS TOLERANCE ON THE BOTTOM SURFACE TO BE? 24. ON THE PRODUCED PART BELOW SHOW A SIMPLE SKETCH ON HOW THE PART WOULD BE CHECKED AND HOW THE RESULTANT TOLERANCE ZONE WOULD BE DEFINED.

Answer 1

o 00o6 00006 A SLuy 0-15 ter 383

cloce in 1.gune. ble..ce ±oooj is guita ble o 006 0.006 2

Q-7 MMC symbol not applied because this parameter not true parameter