Consider the model of a cylinderical hydraulic reservoir with a bottom flow valve with input qin ...
answer 3 and 4 please Consider the model of a spring-mass-damper system, where the following parameter values are assumed: m 1,b 2,k 2. 3. a. Write down the transfer function of the system b. Choose a sample time for the system c. Find the pulse transfer function (use MATLAB 'c2d' command) d. Find the range of K for stability for the closed-loop sampled-data system 4. Consider a series RLC circuit driven by a voltage source with capacitor voltage as output....
Consider the model of a small DC motor, where the following parameter values are assumed: R-10 L-10mH,J-0.01kgm0.0.05 2. ra a. Write down the transfer function of the system b. Choose a sample time for the system c. Find the pulse transfer function (use MATLAB 'c2d' command) d. Find the range of K for stability for the closed-loop sampled-data system Consider the model of a small DC motor, where the following parameter values are assumed: R-10 L-10mH,J-0.01kgm0.0.05 2. ra a. Write...
4. Consider a series RLC circuit driven by a voltage source with capacitor voltage as output. Assume the following parameter values: R 20n, L ;: 1 mH, C : 5μF a. b. c. d. Write down the transfer function of the system Choose a sample time for the system Find the pulse transfer function (use MATLAB 'c2d' command) Find the range of K for stability for the closed-loop sampled-data system 4. Consider a series RLC circuit driven by a voltage...
Consider the plant sDs2) 1) What is the plant's type? 2) Let C(s) - K (a proportional controller). Find the closed-loop transfer function from reference to output using unity feedback. ) Choose different gains for K within the range 1 to 100. Plot the unit step response for the different gains. What happens with the transient response of the closed-loop as K increases? 4) For K 20 find the maximum value attained by the output y(t) and the settling time...
please show work thank you! Use Matlab to and the SISOTool construct the system for analysis (You may want to preview the tf and sisotool commands from matlab by typing help tf or doc tf etc...) Each Block B1, B2, B3 and B4 will be constructed individually and then concatenated together As shown in the block diagram let K=0.1 Set B1 = 0.1 by typing in matlab >>B1=0.1 To assign the Blockl values use the TF command to construct a...
solve quastion 3,4 and 5 B. Tasks and Guide 1. System description and Mathematical modeling The antenna positioning system is shown in Fig. 1. In this problem we consider the yaw angle control system, where 0(t) is the yaw angle. Suppose that the gain of the power amplifier is 5 , and that the gear ratio and the angle sensor (the shaft encoder and the data hold) are such that (t)= 0.40(t) where the units of v,(t) are volts and...