Question

Please drawing the front view, top view and side view of this drafing tools.

+ on the top view, draw a cutting plane AA’ to draw a section view please.

+ Please drawing the isometric Pictorial drawing also.

Thank you!

t 1305-FINAL PROJECT B" You are showed a machined part, and you are to messure that part using e caliper Then you wil ransfer the neasurement into hand drawings with drafting tooks that you will be creating # for the prototype The acual part is available at the lab during class sessions and lab open hours only. Do not remove a from the lub Tite: 2340 GOLDEN BASE A. INSTRUCTIONS: (Please read thoroughly belore starting) 1. Title name: Please see above. types of technical drawings as shown below. Use reqular white paper (orovided) pertormed by necessary drafting tools 4. Create a Title Block (4.50 wide x1.875 high recommended) on the lower right corner, onsheets. You must come up with the appropriate information for the part in the Title Block eg.: Company Name (here is the HCC), itle name (above), drafter's full name, course name (DFTG-1405), semesteriyear, date, assignment number, and scale. 5. Ensure that proper ine types and line weights are employed. 6. Use caliper to measure with Engineer Scale applied. Tolerance to be 3-digit (x.xxo) 1 .001. See the Chart attached or on the lab's wall. All characters to be upper cases with the heights to be 125 (e.g. for dimension units) or .188" (e.g. for View names) 7. All dimensions are in inches. Scale: 1-1 B. DRAWINGS TO SUBMIT Sheet 1 Use Size B-17"x11" landscape paper (provided). Multiview Projection with full dimensions -Create FRONT VIEW, TOP VIEW and LEFT SIDE VIEW, and RIGHT SIDE VIEW At the Top View, draw a cutting plane AA' that runs through all siots at the center marks a. b. Sectional View -Create SECTIONAL VIEW based on the above cutting plane with appropriate material's pattern. It is recommended to place the section view on the toplright corner of the paper Add FOOTNOTES on the lower left corner of the drawing with the following info: c. UNLESS OTHERWISE SPECIFIED, ALL DIMENSIONS ARE IN INCHES. FINISH: REMOVE ALL BURRS AND SMOOTHEN ALL EDGES Sheet 2-Use Size A (11'x8.5) isometric landscape paper (provided). a. Create isometric Pictorial Drawing b. Add isometric dimensions on it c. Name it as ISOMETRIC VIEW NOTES: Don't forget to put appropriate view names at the botom and under all dimension lines on gach drawing view part, comer to corner to make a N shape so that you see only a partial box of the Title Block in order: Isometric sheet 2 on the top, 11x17 sheet on the bottom after folding. Stapled a How t fold back the top to fold 17x11 paper into 8.5X117. Line up corner to corner of the 17x11 paper and fold into half. Then D. SUBMISSION -Put drawings i 4.493 0.9% 4,131 0 294 2.672 ISY

Answer 1

R0.49 Ψ0.85 2.67 0.61 0,15 φ0.20 THRU CN 0.25 Top view sometric view with hidden lines SECTIONA-A 1.14 0.36 0.25 Front view Side view 1.17 isometric view without hidden lines

Top view isometric view with hidden lines SECTION A-A LJl Front view Side view 3S isometric view without hidden lines

Top view isometric view with hidden lines SECTION A-A Front view Side view isometric view without hidden lines

Top view isometric view with hidden lines SECTION A-A LJl Front view Side view 3S isometric view without hidden lines

Top view isometric view with hidden lines SECTION A-A LJl Front view Side view 3S isometric view without hidden lines