Q7. The flow field is defined by the complex potential function, f(z)- Uz+mlnz) a) Define the stream and potential functions, b) Define the types of the potential flows superpositioned c) Using t...
Q7. The flow field is defined by the complex potential function, f(z)- Uz+mlnz) a) Define the stream and potential functions, b) Define the types of the potential flows superpositioned c) Using the values, U-8 m/s and m-3 m'/s determine the pressure distribution and obtain the location op the stagnation point or points in the flow field.
Q7. The flow field is defined by the complex potential function, f(z)- Uz+mlnz) a) Define the stream and potential functions, b) Define the types...
2. Water flows over a flat surface at 8 m/s, as shown in figure. A pump draws off water through a narrow slit at a volume rate of 0.2 m2/s per meter length of the slit. Assume that the fluid is incompressible and inviscid and can be represented by the combination of a uniform flow and a sink. a) Based on method of superposition, propose a general expression for stream function ψ velocity potential ф, and velocity components of v,...
# 4: For smooth complex valued functions f(x), g(z) defined for 0 < x inner product<f(x),g(x) > by 2π define the Hermitian Introduce the operator D(f() a)Show that <D(f(x),9()), D(g(x)) > if f b) For n and integer show that einz for 0-x-2n satisfi c) Show that for mメn both integers then < einz, enny-0, 0,警) (0)- ic boundary conditions. Also onormal and < einz, einz >-2T. θ, Call these last periodic boundary conditions for f(x), g(s), show that D(einz)...
summatize the following info and break them into differeng key points. write them in yojr own words
apartus
6.1 Introduction—The design of a successful hot box appa- ratus is influenced by many factors. Before beginning the design of an apparatus meeting this standard, the designer shall review the discussion on the limitations and accuracy, Section 13, discussions of the energy flows in a hot box, Annex A2, the metering box wall loss flow, Annex A3, and flanking loss, Annex...
summarizr the followung info and write them in your own words and break them into different key points. 6.5 Metering Chamber: 6.5.1 The minimum size of the metering box is governed by the metering area required to obtain a representative test area for the specimen (see 7.2) and for maintenance of reasonable test accuracy. For example, for specimens incorporating air spaces or stud spaces, the metering area shall span an integral number of spaces (see 5.5). The depth of...