Please rate the answer
please give me a detailed explanation for part C. please only answer if you can help.will rate good answer. 1. A long, mild steel cylindrical pressure vessel with diameter 2 m has an operating pr...
A strain gauge affixed to the outside of a cylindrical pressure vessel at an angle of θ = 35° reads ε = 400 μm/m. The outside diameter of the vessel is 500mm and the wall thickness is 5 mm. If the veseel is constructed of A36 steel, determine the following: a) The hoop and longitudinal stresses in the tank. Hints: To solve you will need to consider the equations for strain transform and generalized Hooke’s Law. The hoop and longitudinal...
Q3 (30) A cylindrical pressure vessel is constructed from a long, narrow steel plate by wrapping the plate around a mandrel and then welding along the edges of the plate to make a helical joint α 55° with the longitudinal axis. The vessel has inner radius r-1.8 m and wall thickness t 20 mm. The material is steel with modulus E: 200 GPa and Poisson's ratio0.30. The internal pressure p is 800 kPa Helical weld . The helical weld makes...
A cylindrical pressure vessel of 250 mm mean diameter and 6 mm wall thickness is fabricated from a 1.2 m length of spirally welded pipe AB as shown. Tank gauge pressure is 4 MPa and centric axial forces P and P1 of 240 kN act through rigid end plates. Determine: (a) Net longitudinal and hoop stresses. (b) Normal stress acting perpendicular to weld and shear stress parallel to weld (show sketch of Mohr’s circle). (c) Determine the Factor of Safety...
Question 1 The cylindrical pressure vessel shown has an inside diameter of 625 mm and a wall thickness of 5 mm. The cylinder is made of an aluminum alloy that has an elastic modulus of E = 70 GPa and a shear modulus of G-26.3 GPa. Two strain gages are mounted on the exterior surface of the cylinder at right angles to each other; however, the angle θ is not known. If the strains measured by the two gages are...