BOILING POINT
1. Why is it necessary to position the sample tube right next to the thermometer bulb in the Thiele tube?
2. The normal boiling point of benzene is 80 degrees C. What is the vapor pressure of benzene at 80 degrees C?
3. Define boiling point. How does this definition describe what is occurring in micro-boiling point determination method i.e. that the boiling point is the temperature at which the liquid levels inside and outside of the capillary tube are the same?
ANSWER:
Boiling point determination is carried out using Thiele s tube since the design Thiele s tube helps in the passage of uniform temperature throughout the oil.
The convention currents set up in the tube as heating starts.The side arm helps in the generation of the convention currents.The entire oil in the tube gets uniformly heated
The sample is placed in a small tube ,right next to the thermometer,so that the temperature at which the first bubble appears is clearly noted in the thermometer. This helps in the accurate boiling point determination.
AS PER HOMEWORKLIB RULES I AM ABLE TO ANSWER FIRST ONE ONLY PLEASE REPOST
REMAINING
BOILING POINT 1. Why is it necessary to position the sample tube right next to the thermometer bulb in the Thiele tube? 2. The normal boiling point of benzene is 80 degrees C. What is the vapor pressu...
1. The normal boiling point of benzene (i.e., at 1 atm) is 80.09 °C. The molar enthalpy of vaporization is 30.72 kJ mol . Assuming that AvapHm and AvapSm stay constant at their values at 80.09°C, calculate the values of AvapGm at 75.0 °C, 80.09 °C and 85.0 °C. Given your calculated values, do you still expect benzene to spontaneously condense at 75.0 °C and to spontaneously evaporate at 85.0°C? -1 2. The vapor pressure of a liquid was measured...
summatize the following info and break them into differeng key points. write them in yojr own words apartus 6.1 Introduction—The design of a successful hot box appa- ratus is influenced by many factors. Before beginning the design of an apparatus meeting this standard, the designer shall review the discussion on the limitations and accuracy, Section 13, discussions of the energy flows in a hot box, Annex A2, the metering box wall loss flow, Annex A3, and flanking loss, Annex...