Can you Solve this question? III) (10/50) Given the following circuit 1) What is the nature of this circuit 2) Explain...
Can you Solve this question?
III) (10/50) Given the following circuit 1) What is the nature of this circuit 2) Explain the principle of operation of this 555 multivibrator circuit 3) Draw the waveform of the output voltage Vo and V at pin 2 4) Find the expression of the pulse width W of the output voltage in terms of RA and C. 5) Given RA-1 00kΩand C 10μF. Calculate w 6) What are the differences between this circuit and...
1. Consider the astable multivibrator circuit given in Fig. 4.6 with C 100 nF and Vcc-5 V Reset Discharge 555 Output Threshold Trigger Ground Fig. 4.6. Astable Multivibrator 555 IC Determine the values of the resistors RA and RB to set f-1 kHz and duty cycle-60 % 2. Now consider the monostable circuit of Fig. 4.7. Assume RA 100 k2. Reset Discharge Threshold 555 Output Trigger Ground 0 in Fig. 4.7. Monostable Multivibrator 555 IC Determine C to get a...
A basic change to the astable circuit allows the 555 timer to be
used as a triangle waveform generator. What is the
function of the “RC circuit” part? Briefly explain
why we can obtain triangle waveform in the circuit. Hint:
“integrator”.
+VCC X1 VCC Rint gk R1 9k 2 TRIGGER RESET OUTPUT CONTROL THRESHOLD C5 DISCHARGE 0.1u D1 R2 10k GND D1N4002 1555D C3 C2 0.01u 0.01u integrator part
+VCC X1 VCC Rint gk R1 9k 2 TRIGGER RESET OUTPUT...
Question 8 (6 marks) You have been given a 555 Timer, an LED with Von-2V, a 9V battery that can comfortably supply 5mA of current without loss of voltage, a 1uF capacitor and access to any resistor values you want. Design a circuit that causes the LED to flash periodically once per second with a duty cycle of 75% Ensure that it does not draw more than 5mA of current from the battery (i.e 3mA of charging current and 2mA...
ans,
RA = 721.5 kohms, RB = 360.8 kohms, R3 = 3.5kohms as an example
solution.
Question 7 (6 marks) You have been given a 555 Timer, an LED with Von 2V, a 9V battery that can comfortably supply 5mA of current without loss of voltage, a 1 μF capacitor and access to any resistor values you want. You are to design a circuit that causes the LED to flash periodically once per second with a duty cycle of 75%....
(a) Design a inverting Schmitt trigger circuit
to be used as a zero crossing detector with transition voltages
about ±25 mV. Assume the saturation voltages for the op–amp are ±13
V. Draw the voltage transfer characteristic (VTC), i.e., vout vs.
vin.
(b) Design an astable multivibrator to produce
a square signal with a frequency of 1 kHz using C=0.01 µF, R1 = 30
kΩ, and R2 = 20 kΩ. Sketch the circuit waveforms (vo, v +, and v −)
assuming...