I just need a little more clarification on what to include in an assembly drawing. This question is one of the more complicated questions i have come across. I am new to this industry and university has thrown me in the deep end. Any help would be greatly appreciated.
In the assembly drawing you'll have to include all the models, but first figure out exactly which part fits where. Check for a normal belt conveyor assembly.
Make the assembly in this manner, first the base and put fix constraint on it, then attach the bush inside the pulley in whihc the shaft will go inside. match the centres of pulley and frame, and make sure the shaft goes through them. Check for the quantities mentioned in the drawings, and the hardware should be assembled at last.
Check for reference in the image below
I just need a little more clarification on what to include in an assembly drawing. This question is one of the more com...
Figure 3 is above
Draw general assembly views of the belt tensioner, component details of which are given in Figure 3. You will need to determine how the component fits together to make the assembly Take dimension 'W' a s 68 mm (i) a sectional front view on A-A (ii) a side view looking at the side on which the nut is fitted. Draw to 1:1 scale and provide a title block, parts list, and record a revision assuming that...
MAY/JUNE 2017 QUESTION 1 Figure 1 shows the components of an IDLER PULLEY Draw according to scale 1 1, ın first angle orthographic projection, the following views when assembled - A full sectional front view (According to component 1 section) - A left view (24) (14) - And a title block Insert item numbers in the assembly drawing The complete part list is as follows | DESCRIPTION | MATERIAL QUANTITY BODY PULLEY PIN SHAFT BUSH HEXAGONAL NUT I M S...
QUESTION 1 Figure 1 shows the components of a swivel and base assembly Draw according to scale 1 1, in first angle orthographic projection, the following views when assembled -A full sectional front view on plane A-A (25 -A left view and (1 - A title block No hidden lines need be shown Insert the item numbers on your drawing The complete parts list is as foliows Item 1 Base (cast iron)- one required- Item 2 Swivel 9cast iron)- one...