y
6. Consider a power screw used in an application to lift a load. In the following, select a standard power screw, a...
SOLVE ALL , Show details clear and orgnaized
In an application, an Acme-threaded power screws is to be designed to raise a maximum load of 50 kN. (a) Select a satisfactory screw from the Table on the basis of tensile strength, limiting the tensile stress to 70 MPa (2 marks). (b) Then determine the required thickness of the nut that to limit the shear stress in the threads to 35 MPa (2 marks). (c) For the screw thus designed, check...
15-3 A 1 3/8-4 Acme thread screw is used to lift a 1-ton load. The mean collar diameter is 2 in. Find the torque to lift and to lower the load using a ball-bearing thrust washer. What are the efficiencies? Is it self-locking?
A single-square threaded 35-mm power screw is 35 mm in diameter with a pitch of 5 mm. A vertical load on the screw reaches a maximum of 5 kN. The coefficients of friction are 0.06 for the collar and 0.09 for the threads. The frictional diameter of the collar is 45 mm. Find the overall efficiency and the torque to "raise" and "lower" the load Repeat this problem if ACME screw is used in this design.
A single-square threaded 35-mm...
A square power screw has a mean diameter of 30 mm and a pitch of 4 mm with single thread. The collar diameter can be assumed to be 35 mm. The screw is to be used to lift and lower a load of 7 kN. A coefficient of friction of 0.05 is to be used for friction at the thread and at the collar. Determine the following: (i) Torque required to raise the load. TR. (Equation 8.1) (ii) Torque required...
triple-threaded power screw is to taise/lower à 100kN load. This s square threads. Thread kinematic friction is 0.05. The loading collar has a Problem#2020pts). A 5andiameter diameter of 25cm and is a) Continuous torque required to raise the load? b) Efficiency of the system during raising the load screw has a pitch of 0.5cm and has threads using bal bearing design with a static/kinematic friction of 0.01. Determine e Considering ductile behavior with a Yield strength of 100MPa, what is...
(50) 7. Analyze the following operation. A 385C Excavator will be used to load material into a CAT 740 (no ejector) articulated truck. The excavator is equipped with a 6 cy heaped bucket and is capable of cycling every 30 seconds. The material being loaded weighs 3,300 lbs cy. The job efficiency is 90%. The trucks will be hauling the nmaterial 4000 feet over a road with a total rolling resistance of 9% to the dumpsite and 10% total rolling...
find v belt drive
design power
select belt type
determine shive size (belt speed 4000 ft/min)
find shive size from power rating figure
find rated power
find estimated centre distance
find belt length (by selecting standard belt length)
calculate actual centre distance
find contact angle for small shieve
determine correct factors
calculate correct power per belt
no. of belt needed
V-Belt Designing Sample Problem . Given: A 4 cylinder diesel engine runs at 80 hp, 1800 rpm, to drive a...